高溫粘度計 的英文怎麼說

中文拼音 [gāowēnniándùjì]
高溫粘度計 英文
high temperature visco meter
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  1. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  2. In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer

    本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程，從鋪裝層環境溫度變化范圍、交通量等使用條件出發，在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上，提出了（即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma ）的高性能鋼橋面sma鋪裝體系，並對這種sma的組成材料，包括改性瀝青、集料、礦粉、纖維進行了比較研究，設計了這種sma的配合比，對sma混合料的性能進行了對比試驗，對這種sma方案進行了疲勞性能研究，驗證了所選擇sma方案的可行性。
  3. The sort, material composite, structure properties and conduction mechanisms of eca ( electrical conductive adhesive ) were discussed in this paper. then three types of ega specimens were designed and made, on which temperature cycles test from - 55 ? to + 125 ? and thermal aging at + 125 ? were carried out. changes of the adhesive strength, eca ' s bulk resistance and contact resistance under the environment stress were summarized and a detailed evaluation on these specimens was given

    本文在全面闡述導電膠的分類組成、物理結構、導電機理的基礎上，設計並製作了三批導電膠樣品，通過對樣品進行長時間的- 55 ? ? + 125溫度循環和125高溫存儲試驗，總結了導電膠粘接強度、體電阻和接觸電阻在環境應力下的變化規律，對三類樣品的長期可靠性做出了全面的評價，並結合導電膠電阻率和「穿流閾值」的計算機模擬，給出了提高導電膠可靠性和電導率的建議，介紹了國內外在高電導率高可靠性導電膠研製方面的一些最新進展。
  4. The grade composite, road performance and its mechanism are systemically studied. 1 ) the aggregate grade of ogfc is studied through the volume method base on the analysis of the aggregate grades. then the grade is verified and the relation between the grade and pore rate is studied statistically, the typical grades of ogfc are developed ; 2 ) the reasonable pore rate of ogfc is studied on the basis of the balance of mechanics and function performance ; 3 ) the mineral fiber is added to the ogfc mixes to increase asphalt content, thus the anti - water performance of ogfc mixes are improved ; 4 ) high viscous asphalt fit for the preparation of ogfc is prepared through composite modification by sbs and rubber powder ; 5 ) the mechanics mechanism of ogfc is studied in the paper, it shows : asphalt paste, as well as the coarse aggregate skeleton, is essential to the mechanics of ogfc

    在分析各國ogfc級配的基礎上，運用礦料體積法進行ogfc級配設計，用正交實驗對礦料級配進行了優化設計，運用數理統計方法分析礦料級配和孔隙率之間的關系，並回歸出礦料關鍵篩孔通過率與ogfc骨架空隙結構關系的數學方程，進而提出了ogfc的合理級配；通過對不同孔隙率典型級配混合料的性能研究，綜合力學和功能性能，得出了ogfc的合理孔隙率范圍：針對高速公路面層對ogfc力學性能方面的要求，本文從瀝青膠結材料、纖維穩定劑兩方面對ogfc的性能進行改善：通過sbs和橡膠粉復合改性的方法開發出了適合ogfc的高粘度改性瀝青，摻加聚合物纖維，提高ogfc的最佳瀝青用量，進而改善了混合料的高溫性能和抗水損害性能，優化設計出能滿足高速公路路用性能，車轍動穩定度達5000次/ mm以上，動融劈裂強度比90 ，透水系數31ml / s ，並具有防滑降噪功能的開級配瀝青磨耗層（ ogfc ）混合料。
  5. 3. the author designs ortho - experimentations of palygorskite acidification and organising modification by adopting propyl alcohol as thinner of wd - 51, and acquires the best craft parameters and craft conditions for gaojiawang palygorskite acidification and acidified palygorskite organising modification, namely : the best craft parameters and craft conditions for gaojiawang palygorskite acidification is : parlygorskite : h2o = 1 : 3, activation time 50 min, activation temperature 96, hydrochloric acid concentration 1. 0 n, parlygorskite granularity - 100mesh ; the best craft parameters and craft conditions for gaojiawang acidified palygorskite organising modification is : wd - 51 concentration 2. 0 % ( wt % ), modification temperature 120, and modification time 60 mins, adopting iso - propyl alcohol as thinner of wd - 51. 4

    設計坡縷石粘土酸化正交實驗和有機化改性正交實驗，取得了高家窪坡縷石粘土酸活化處理和酸化坡縷石用wd - 51進行有機化改性處理的最佳工藝參數和工藝條件，即：高家窪坡縷石酸活化處理的最佳工藝參數和工藝條件為：固液比為1 ： 3 （固體為高家窪坡縷石粘土，液體為去離子水） 、活化時間50min 、活化溫度為96 、鹽酸濃度為1 . 0n 、粒度為- 100目。
  6. In the aspect of improving the cracking feature, compatibility and flexibility, the author has done experiments, including strength, modulus of elasticity experiments, and design some experiments similar to the practical structure and circumstance including adhesion strength between fresh mortars and old ones, between mortar and polystyrene board, mortar shrinkage in concrete circle, mortar shrinkage at different strength and different polymer - cement ratio, and temperature deformability at different strength and different polymer - cement ratio on mortars, on different type of formwork and on mortars with different type of formwork

    在改善砂漿抗裂性、提高柔韌性和協調變形能力方面，進行了不同聚合物摻量的強度試驗、彈性模量試驗；設計了與模網混凝土實際結構和情況相接近的新老砂漿粘結強度試驗、砂漿與苯板的粘結試驗以及混凝土環中的砂漿收縮試驗；進行了不同強度、不同聚合物摻量下的砂漿干縮變形試驗、溫度變形試驗，以及不同結構形式的鋼網自身溫度變形試驗和配有鋼網的砂漿溫度變形試驗。
  7. Then, the program based on complex eigenvalue method was employed to investigate the influence of three parameters on vibration - controlled of cables. final, in term of character of vsd which is strongly dependent on temperature, the method based on lowermost damper of first order vibration - controlled aim at design tiptop temperature and checked at minimum temperature is presented, in which available shear area of damper is calculated

    最後，在學習國內外研究成果的基礎上，根據粘性剪切型阻尼器的溫度依賴性強的特點，提出在設計最高溫度下，以滿足一階制振目標的阻尼值下限為標準設計阻尼器插板的有效剪切面積，最後在設計最低溫度下復核拉索各階制振目標是否滿足的設計方法。
  8. Standard test method for measuring apparent viscosity at high - temperature and high - shear rate by multicell capillary viscometer

    用多孔毛細管粘度計在高溫高剪切率下測量表觀粘度的標準試驗方法
  9. Test method for measuring apparent viscosity at high - temperature and high - shear rate by multicell capillary viscometer

    用多孔毛細管粘度計在高溫和高剪切率下測量表面粘性的試驗方法
  10. The temperature pressure measuring instruments of the standard programme can be used anywhere where liquid or gaseous materials to be measured do not attack copper alloys, do not crystallise and are not highly viscous

    溫度壓力計標準程序的溫度-壓力測量儀可以用於任何液體氣體介質測量，但介質不能腐蝕銅合金結晶或高粘稠。
  11. Standard test method for viscosity determination of asphalt at elevated temperatures using a rotational viscometer

    利用旋轉粘度計測定高溫瀝青粘度的標準試驗方法
  12. It ' s unique chemistry combines the low temperature performance characteristics heretofore found only in silicones with the excellent encapsulating properties of epoxies, formulated to withstand severe thermal shock, low moisture absorption and excellent dielectric insulation

    獨特的低粘度硅酮化合物，能與大多數金屬及膠料進行良好的粘接並具有獨特的低溫性能，是專業為高溫、低吸水性、高絕緣性設計製造的。
分享友人
分享到 Line

分享到臉書