高溫處理 的英文怎麼說

中文拼音 [gāowēnchǔlǐ]
高溫處理 英文
high heat treatment
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  1. The physical methods include mechanical scarification, low and high temperature, hydration - dehydration, irradiation, high pressure and other physical treatments, and the chemical ones include acid scarification, alkali solution soaking and other organic chemical treatments

    物理方法有機械損傷、低溫和高溫處理、干濕交錯處理、輻射和高壓處理等；化學方法有酸蝕、堿液浸泡和有機溶劑等處理。
  2. It is studied that the activity against eumycetes of the fermentation filtrate ( 16h ) of strain jw - 725 is the strongest. the optimum nutritional sources are wheat bran and soya bean meal. the fermentation filtrate reserved under 4 still has bioactivity after 20 days or so, but its bioactivity decreases much while being treated under high temperature. the ph of fermentation filtrate has much influence upon the bioactive substance, and it remains activity at the range of 5

    發酵液在4下保存20天左右仍有抗菌活性；但經高溫處理后，其抗菌活性降低很多； ph對抑菌物質的生物活性影響比較大，抑菌物質保持活性的ph范圍是5 . 0 7 . 0 。分離到的多粘芽孢桿菌（ b polymyxajw - 725 ）對柑橘青黴菌（ p
  3. In order to study the influence factors of aoa of rose flowers, the effects of drying and extraction methods on the aoa of rose flowers were investigated. the results indicated that drying after high - temperature short - time pretreatment was rather effective to maintain their aoa ; the aoa of water extracts was stronger when the temperature was raised from 25 to 100 ; by using orthogonal test, the optimum extraction conditions of rose flowers were : solvent - 75 % ethanol ; ratio of material and solven - 1 : 10 ; extraction times - three times with 24 h at one time, at the room temperature. the extracts obtained by 75 % ethanol were fractionatedly extracted with petroleum, diethyl ether, ethyl acetate and n - butanol in turn, and the various fractions " aoa were analyzed

    為了探討玫瑰花抗氧化活性的影響因子，比較了不同乾燥方法、提取方法對其抗氧化活性的影響，發現：經短時高溫處理后再進行乾燥有利於較好地保持玫瑰花的抗氧化活性；以水作溶劑提取時， 25 100范圍內水提液的抗氧化活性隨著溫度的升高而增強；通過正交實驗篩選得到常溫下玫瑰花抗氧化活性物質的最佳提取方法為： 75乙醇為溶劑，液料比1 ： 10 ，提取3次，每次24h ； 75乙醇提取物依次用石油醚、乙醚、乙酸乙酯、正丁醇等有機溶劑進行兩相分部萃取，發現玫瑰花的抗氧化活性物質主要存在於乙酸乙酯部，說明玫瑰花抗氧化活性主要成分可能是單寧類、黃酮苷類和原花色素類化合物； 4
  4. Thermal expansion and its evolution of c / sic composites have been studied by such analytical methods as thermal dilatometer and sem, based on thermal stress and micro structure evolution in c / sic composites. the influence of perform structures, heat treatment and interphase thickness on thermal expansion of c / sic composites has been analyzed

    本文採用熱膨脹儀和掃描電鏡（ sem ）等分析手段，從材料界面熱應力的變化和微結構改變的角度，研究了c sic復合材料的熱膨脹系數及其隨溫度的演變規律，分析了其演變機理，以及編織結構、高溫處理工藝和界面層厚度等對復合材料熱膨脹行為的影響。
  5. The influence of heat treatment temperature on the properties of 3k pan - based carbon fibers was investigated

    摘要在不同溫度下對3k聚丙烯腈基炭纖維進行了高溫處理，研究了熱處理溫度對炭纖維結構和性能的影響。
  6. Capacity high wet strength and is not liable to tear. the products are clean and sanitary through 450

    高，不易撕爛，原紙經過450攝氏度超高溫處理，產品浩凈衛生，
  7. Creep testing, high temperature treatment and metallographic examination of the tungsten wires

    鎢絲蠕變試驗高溫處理及金相檢查方法
  8. Rhi refractories is the technology leader for all kinds of high temperature industrial processes

    Rhi奧鎂是各種高溫處理工業技術的領導者。
  9. Adhesives - methods of preparing bulk specimens - elevated - temperature - curing one - part systems

    粘合劑.散裝樣品的制備方法.高溫處理單成份系統
  10. However, the matrix - cracks - sealing temperature has not been changed by heat treatment

    但高溫處理未改變c sic復合材料的基體裂紋愈合溫度（ 900 ） 。
  11. ( 3 ) the effect of heat treatment on thermal expansion of c / sic composites has been investigated

    （ 3 ）研究了高溫處理對c sic復合材料熱膨脹行為的影響。
  12. The ht procedure is also critical and requires strict controls to ensure the proper microstructure

    高溫處理也是關鍵的，並需要進行嚴格的控制，才能夠保證適當的微觀結構。
  13. These are fitted into the annular space between the cylinder and the cylinder liner, and are connected to the steam supply

    這是在鍋爐裏面使用高溫處理蒸汽和給氣缸增設蒸汽套共同作用的結果。
  14. Silicone fiberglass sleeving, woven as sleeving by non - alkali fiberglass and coated with silicone resin in high temperature

    硅樹脂玻璃纖維套管，是由無堿玻璃纖維紗編織成管后，塗以硅樹脂高溫處理而成。
  15. However, the refractive index will increase with the increase of the flow ratio of sifu / nhs, slightly increase with the increase of substrate temperate, and decrease with the increase of rf power. by measuring the passivation results of hydrogen plasma and sinx thin film, we found an evident improvement of minor carrier lifetime in polycrystalline silicon after hydrogen plasma treatment, although it has little to do with the annealing temperature and time. the hydrogen contained in sinx thin film can enhance the carrier mobility of monocrystalline silicon, but after annealing at high temperature the mobility turns down

    通過測試氫等離子體鈍化和氮化硅薄膜鈍化的效果，實驗還發現氫等離子體處理對多晶硅材料的少子壽命提高作用比較明顯，但是這種提高作用與處理溫度以浙江大學碩士學位論文王曉泉2003年5月及時間的關系不大；氨化硅薄膜中的氫對單晶硅的載流子遷移率提高有一定作用，但經過高溫處理后這種作用消失；氮化硅薄膜能提高單晶硅和多晶硅的少子壽命，具有表面鈍化和體鈍化的雙重作用；氫等離子體和氮化硅薄膜都能有效地提高單晶和多晶電池的短路電流密度，進而使電池效率有不同程度（絕對轉換效率0
  16. Since it is not a high temperature treatment process, it can be used to sterilize a range of heat - sensitive items such as plastics

    由於不需經過高溫處理，很多會被高溫破壞的物料，例如塑膠等，都可以使用放射程序消毒。
  17. Since it is not a high temperature treatment process, it can be used to sterilize a range of heat - sensitive items such as plastics. in addition, as

    由於不需經過高溫處理，很多會被高溫破壞的物料，例如塑膠等，都可以使用放射程序消毒。
  18. The surviving time upon heat exposure and the swimming time were examined and the physiologic and biochemical changes such as body weight, potassium concentration, blood sugar, hemoglobin were compared before and after heat exposure

    並比較了高溫適應前後以及高溫處理前後小鼠的一些生理生化指標如體重、血清中鉀離子濃度、血糖含量和血紅蛋白含量。
  19. Silicone rubber fiberglass ( fiber inside and rubber outside ) sleeving, woven as sleeving by non - alkali fiberglass and coated with silicone rubber in high temperature

    硅橡膠玻璃纖維（內纖外膠）套管，是由無堿玻璃纖維紗編織成管后，塗以硅橡膠高溫處理而成。
  20. Then, the fluid was coated on the surface of c / c composite dental implants, a stronger modified composites layer was formed on the surface of c / c composites by means of heat treatment at 1 100

    研究結果表明：在熱固性酚醛樹脂中添加10 % 25 %的羥磷灰石細粉製成漿體，用預氧絲作增強劑包覆于炭炭復合材料牙種植體表面，再經1100高溫處理，可以在炭炭復合材料的表面形成強度良好的復合改性膜。
分享友人
分享到 Line

分享到臉書