高濃度膠乳 的英文怎麼說

中文拼音 [gāonóngdùjiāorǔ]
高濃度膠乳 英文
high dry rubber content latex
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 濃 : 形容詞1. （液體或氣體中所含的某種成分多; 稠密） dense; thick; concentrated 2. （程度深） （of degree or extent） great; strong
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 乳 : Ⅰ動詞（生殖） give birth to Ⅱ名詞1 （乳房） breast2 （奶汁） milk 3 （像奶汁的東西） any milk lik...
  • 高濃度 : heavy concentration
  1. The latex concentration is raised by evaporation or centrifugation.

    通過揮發或離心作用提高膠乳的濃度。
  2. The remaining 5 percent of the ingredients are non - organic or synthetic, and include baking powder, pectin to make yogurt thicker, or carbon dioxide to keep products, like cottage cheese, fresher longer

    其餘5 %的成分為無機物質或人工合成物，包括用來製作高濃度酸乳酪的發酵粉，膠質，或可使像松軟乾酪一類產品保持持久新鮮的二氧化碳。
  3. Their properties have been investigated by using scanning electronic microscopy ( sem ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), thermogravimetry - differential thermal analysis ( tg - dta ), infrared spectroscopic analysis ( ir ), and gas chromatography ( gc ), etc. the effects of the mulser ' s stirring rate and the emulsifier concentration on the properties of encapsulated pcms have been systematically studied, and nanopcms have been obtained by increasing the stirring rate or the emulsifier concentration. the influences of different nucleating agents on micropcm performances have also been investigated in detail to search for a suitable nucleating agent to prevent micropcms from super - cooling

    首先，系統研究了乳化機轉速和乳化劑濃度對膠囊性能的影響，並通過提高轉速或乳化劑濃度獲得相變材料納膠囊；其次，系統研究了不同成核劑對微膠囊性能的影響，找到合適的成核劑抑制了相變材料微膠囊的過冷現象；再次，詳細研究了環己烷對膠囊性能的影響，並通過添加適量環己烷提高了相變材料微膠囊及納膠囊的耐熱溫度。
  4. With the reference of many relevant materials, the author prepared a fined molybdenum disulfide powder with a average size of 800nm by ball milling, and a nano - copper with average size of 30nm in micromulsion solution method, and synthesized surface - modified titanium dioxide nanoparticles with average size of 40nm in organic media via sol - gel method. the tribological performances of three particles were studied by universal test as well, with the result of fined molybdenum disulfide powder with good reducing wear and antiwear performance at low load, nano - copper with good reducing wear and antiwear performance at high load, surface - modified titanium dioxide nanoparticles maintaining stable reducing wear and antiwear performance from low load to high load due to its characteristics of organic and inorganic nanocomposite. the results indicate that the nanocomposite is the most perspective oil additive. the reducing wear and antiwear mechanism of nano oil additive was studied with in - situ tribochemical principle. nano additives possess broadly developing prospect with its above - mentioned performance

    在參閱了大量文獻的基礎上，分別採用了球磨法、微乳液法、溶膠?凝膠法制備了超細二硫化鉬、納米銅粒子、表面修飾納米二氧化鈦，經原子力顯微鏡測試，獲得的超細二硫化鉬的粒度平均在800nm以內，納米銅粒子平均粒度約為30nm ，表面修飾納米二氧化鈦平均粒度約為40nm ，在萬能摩擦磨損試驗機上測試了三種粒子的摩擦學特性，結果表明：在合理的添加濃度范圍內，超細二硫化鉬在低載時具有優良的減摩抗磨性能，納米銅在高載時具有比較好的減摩抗磨性能，表面修飾二氧化鈦粒子因具有有機與無機復合物的特性，從低載到高載都保持穩定的減摩抗磨性能。
  5. As far as the new technology of selective diffusion, the method of printing is used and the phosphoric paste ( high concentration ) is printed at the electrode - site in silicon. afterwards, a thin layer of phosphoric source ( low concentration ) is sprayed on the surface of the non - electrode - site in silicon

    在選擇性擴散新工藝中，我們採用絲網印刷電極的方法在矽片的電極位置印刷濃度較高的磷漿（摻磷sio _ 2乳膠） ，在非電極區噴塗一層濃度較低的磷源，擴散后形成重摻雜和輕摻雜。
  6. Results indicated that the concentration of salvolatile and the conserved effect was in proportion because of the capability to counteract the acids produced by microbe

    實驗結果表明，濃度越高的碳酸銨鹽溶液的保存體系，其緩沖能力越大，越能很好地中和細菌代謝產生的脂肪酸，以防止天然膠乳的迅速凝固，保存效果越好。
  7. Accurate measurement in highly concentrated solutions has always been a desire of latex manufacturers because of concerns about particulate changes arising during dilution

    為了避免稀釋造成的微粒變化，膠乳製造者總是希望在高濃度溶液中進行精確測量。
分享友人
分享到 Line

分享到臉書