高純鋅 的英文怎麼說

中文拼音 [gāochúnxīn]
高純鋅 英文
high purity zinc
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 純 : 形容詞1 （純凈; 不含雜質） pure; unmixed 2 （純粹; 單純） simple; pure and simple 3 （純熟） skil...
  • 鋅 : 名詞[化學] （金屬元素） zinc （zn）
  1. The cdte films doped te are deposited onto glass substrate by close spaced sublimation. the x - ray diffraction data indicate the pure cdte films are polycrystalline zinc - blende structure with grain orientation predominantly along ( 111 ) direction. the electrical properties of cdte films are investigated by hall effect measurement using the van der pauw method

    X射線衍射分析表明，純cdte薄膜是立方閃鋅礦結構， （ 111 ）晶面取向生長； hall效應實驗測量發現薄膜電阻很高，呈p型電導，面電阻率數量級達1010
  2. Study on the synthesis of corundum - mullite - gahnite multiphase materials by one - step sintering process using high purity raw materials showed that the more the content of gahnite in multiphase materials, the high the volume expansion would be introduced in the system, which resulted in the sintering difficulty of the multiphase materials. while the content of gahnite was controlled about 30wt % and the content of mullite was about 70wt %, the densified multiphase materials can be obtained after fired at 1600 or 1700

    採用高純原料一步合成剛玉?莫來石?鋅鋁尖晶石復相材料研究表明：復相材料中鋅鋁尖晶石含量越高，則合成鋅鋁尖晶石時產生的體積膨脹越大，燒結性也就越差；當鋅鋁尖晶石含量為30wt ，莫來石含量較高為70wt左右時，在1600或1700燒后都能得到顯微結構較為緻密的復相材料。
  3. The zinc refining furnace ( new jersey furnace ) is today the most important pyrometallurgical method for the production of zinc very high purity, where the impurities is of different boiling point from the zinc

    鋅精餾爐（ newjersey爐）是利用粗鋅中其它雜質成分與鋅具有不同沸點，而生產高純鋅最主要的火法精煉方法。
  4. Products : rectifers, high silicon cast iron anodes, mmo anodes ( rod, tubularribbon ), titanium conductor bar, sacrificial anodes ( aluminum, magnesiumzinc ）, magnesiumzinc ribbon anodes, zinc grounding cell, reference electrodes, test postjunction boxes, thermite ( corrtech exothermic weld metal ) mold, cathodic protection system utilizing solar energy, cp data remote monitoring system, and other accessories

    我們的產品：恆電位儀、高硅鑄鐵陽極、鈦基混合金屬氧化物陽極（帶狀、棒狀、管狀） 、鈦導電片、鋅合金陽極、鎂合金陽極、鋁合金陽極、鋅帶鎂帶、長效硫酸銅參比電極、高純鋅參比電極、鋅接地電池、陰極保護測試樁、鋁熱焊模具和焊劑、太陽能陰極保護系統、陰極保護參數遠程監測控制系統等全系列陰極保護系統配套產品。
  5. Methods for analysis of high purity copper cathode cu - cath - 1 - method for determination of chromium, cobalt, iron, nickel and zinc by discrete volume nebulization atomic absorption spectrophotometry

    高純度銅陰極cu - cath - 1分析方法.第2部分:採用不連續體積噴霧原子吸收分光光度法對鉻鈷鐵鎳和鋅的測定方法
  6. In this dissertation, nanometer zno thin films on si ( 100 ) substrates were prepared by using thermal evaporation technique following by two - step annealing process : high quality zno thin films and mgxzn1 - xo alloy films have been grown on si ( 100 ) substrates with mgo buffer layers by using thermal evaporation technique following by two - step annealing process

    本文介紹了採用電子束蒸發方法在si補底上制備出了高純度的金屬鋅膜，然後通過二次退火得到了具有六角結構的高質量氧化鋅多晶薄膜材料，另外，還採用電子束蒸發mgo薄膜作為緩沖層二次退火金屬鋅膜的方法制備出了高質量氧化鋅多晶薄膜材料和mgzno合金薄膜材料。
  7. Spectrophotometric determination of tin in high - pure zinc with salicylfluorone cetyltrimethylammonium bromide

    分光光度法測定高純鋅中的錫
  8. Moreover, we observed the concentration profiles of the ion - implanted samples and the diffused samples by c - v method, and discovered that the carrier concentration decreased with increasing of the diffusion depth. whereas, the peak concentration of the ion - implanted samples located at 0. 248151 u m beneath the surface and the peak concentration of the diffused samples located at the surface. furthermore, the carrier concentration of mnas source diffused sample as high as 102 % m3can be obtained, and the surface was much smoother compared with that of the pure mn source diffused sample

    發現兩種摻雜方法的載流子濃度大體上都是隨著擴散深度的增加而下降，不同的是離子注入樣品的載流子最高濃度處于離表面深度0 . 248151 m處，而擴散樣品的載流子最高濃度處于表面，並摻錳（ mn ）砷化鋅（ gaas ）材料性質的研究且還發現相對于純mn源擴散樣品來說， mnas源擴散樣品的表面較為光滑，且表面載流子濃度高達1020 cm 』數量級。
分享友人
分享到 Line

分享到臉書