高縮率纖維 的英文怎麼說
中文拼音 [gāosuōlǜxiānwéi]
高縮率纖維
英文
high shrinkage fiber-
Through the experimental research, we think : the technological capacity of fiberglass asphalt macadam if weaker than asphalt macadam, however, if use elasticized capacity to solve blending technological problem. adjust the breed of fiber silk, extend its diameter, its paving capacity is still worth exploring, asphalt - rubber macadam structure lager have good deformed - become capacity and crazed - resistance capacity, small gap rate. good water - resistance capacity, good hot - stability and simple construction technology. therefore. pitch rubber spall is a good cover material which is suitable for the second class or lower whose asphalt pavement has split open because of fatigue. and is the good structural measure of preventing half - rigidity grass - roots unit shrink - rift reflecting. pave a thin layer of pitch rubber spall between asphalt - type pavement layer and half - rigidity basic level, although the cost of building is higher than paving togongbu in the middle, the construction technology, crazing - resistance and water - resistance are better than togongbu, not only could reduce greatly the reflex of half - rigidity grass - roots unit material, long then the use lifespan of pavement, but also it is possible to reduce suitably the thickness of asphalt mixture layer, though the cast of building in the early days becomes more, in the long - term opinion, it have fully important technological and economical significance
通過試驗研究認為：玻璃纖維瀝青碎石的技術性能不如瀝青碎石好，但路用彈性性能較好，如能解決拌和工藝問題，調整纖維絲的品種，增大其直徑，其路用性能仍值得探討，瀝青橡膠碎石結構層具有變形性能和抗裂性能良好，空隙率小，防水性能好，熱穩定性較好，施工工藝簡單的特點，因此，瀝青橡膠碎石是二級及二級以下公路因疲勞而開裂的瀝青路面的良好罩面材料，也是防止半剛性基層收縮裂縫反射的良好結構措施，在瀝青類路面面層和半剛性基層之間夾鋪瀝青橡膠碎石薄層，雖然造價比夾鋪土工布高，但其施工工藝，抗裂性能和防水性能均優于土工布，不僅可以大大減少半剛性基層材料的反射裂縫，延長路面使用壽命，而且可能適當減薄瀝青混合料面層的厚度，雖然初期造價有所增加，從長遠來看，具有十分重要的技術和經濟意義。Experimental result shows that cavitation can destroy metal cyanogen preparation and chemical property of bearing cyanide wastewater is changed ; it intensify the fiber ' s adsorption progress and reduce the time of adsorption equilibrium, the general cyanide adsorption rate is increased 5 % or so, but it strength the different effect on different metal - cyanide negative ions ; strengthen effect of copper cyanide complex is stronger than zinc and iron cyanide complex, so ultrasonic wave may strength the fiber ' s adsorption processes
實驗結果表明，功率超聲的空化作用能破壞金屬氰配合物鍵，從而改變含氰廢水的化學性質，另外也可縮短吸附平衡時間，強化纖維的吸附過程，使總氰的吸附率可提高5 %左右；功率超聲對不同金屬氰配合物離子的強化效果是不同的，對銅氰絡離子的強化效果要強于鐵氰、鋅氰絡離子，所以功率超聲可以強化纖維的吸附過程。The effects of mineral additive such as fly ash, slag, and dura fiber on concrete expansive property are studied, the results show that these mineral admixture reduce shrinkage in common concrete and also reduce expansive value in shrinkage - compensating concrete
本文討論了粉煤灰、礦渣、杜拉纖維對混凝土膨脹性能的影響，在補償收縮混凝土中，摻合料使其膨脹率減低，杜拉纖維可以提高混凝土的體積穩定性，顯著提高劈拉強度。The compress tests on multiaxial multi - layer warp knit glass - fiber composite ( mmwk ) have also been carried out at high strain rates. the out - of - plane compressive property of multiaxial multi - layer warp knit glass - fiber composite are also rate sensitive. the maximum stress strain and elastic modulus of mmwk composite increase with the rising of strain rate
首次對多軸向經編玻璃纖維復合材料進行了高應變率下的面外壓縮試驗，實驗結果表明，多軸向經編結構玻璃纖維復合材料在面外力學性能上是應變率相關的，隨著應變率的增加，沖擊壓縮瞬時應力增加，最大應力和最大應變增加，同時初始模量也有增大的趨勢。The result of macro - quality experiments show : mineral admixtures markedly slow the hydrating velocity of cement slurry, decrease and delay the hydrating max - temperature, in which steel slag is more effective ; expansive agents compensate concrete shrinkage, enhance the concrete dense degree, strengthen the interfacial layer between fiber and cement matrix and improve the physical mechanics qualities of acic ; minimal admixtures markedly improve the concrete workability property, increase the concrete later intensity & density and the capability of anti - chemical attack and anti - permeability ; hybrid fiber reinforces the toughness of obviously acic by the means of anti - cracking effect of fiber with different sizes and different properties in the corresponding construction levels
實驗結果顯示：鋼渣摻合料能顯著減緩水泥漿體水化速率，降低砂漿的水化溫升並延遲最高溫升時間；補償混凝土收縮，提高混凝土密實度，加強纖維與水泥石的界面粘結，增強混凝土力學性能，但不能明顯改善混凝土韌性。混雜纖維通過纖維的不同尺度與不同性質在相應的結構層次上產生阻裂效應，增韌鋼渣防滲抗裂混凝土；增加混凝土的破壞極限能，極大提高混凝土抗彎曲能力和韌性指數，改善混凝土脆性。By molecular design, high shrinkage polyamide for fiber was synthesized. the chip after spinning and drawing has a shrinkage of 20 ? 40 % in boiling water. the spinning speed is above 4500 m / min
藉由分子設計，篩選共單體，合成高收縮尼龍粒，紡速可達4500米以上，纖維經延伸后，沸水收縮率20 ? 40 % 。將此纖維透過織物設計製成紡織品，具超蓬鬆感或緻密感，並有特殊光澤。By molecular design, high shrinkage polyamide for fiber was synthesized. the chip after spinning and drawing has a shrinkage of 20 40 % in boiling water. the spinning speed is above 4500 m / min
藉由分子設計，篩選共單體，合成高收縮尼龍粒，紡速可達4500米以上，纖維經延伸后，沸水收縮率20 40 % 。將此纖維透過織物設計製成紡織品，具超蓬鬆感或緻密感，並有特殊光澤。Based on the characteristics of silicon whisker, the research on the modification of pa6 by silicon whisker sio2 - jx was made, and the result showed that the tensile strength, impact strength, brinell hardness, and heat resistance increased with the increase of the content of the whisker ; sio2 - jx could replace short glass fiber in the modification of pa6, improving the heat distortion temperature, removing the appearance of glass fiber, reducing shrinkage and the cost
摘要利用晶須矽纖維狀的特性，對其填充于龍玻纖改性進行研究，結果表明，隨晶須用量的增加，材料的拉伸強度、沖擊強度，布氏硬度、耐熱溫度均得到提高；晶須矽可取代短玻纖使用，提高熱變形溫度、消除玻纖外露，降低收縮率及生產成本等。The compress tests on 3d woven glass - fiber composite have been carried out at high strain rates
首次對三維機織玻璃纖維復合材料進行了在高應變率下的面外壓縮試驗。Regarding the lcm filling process as the newton fluid through fibrous reinforcements, the permeability of preform determines the saturating of resin in fiber, and has effects on the curing process and the quality of products. based on the darcy ' s law, the theoretical model of permeability measurement was established. and the influence of different testing methods and major process parameters such as fabric structure, fiber volume fraction, injection pressure, flow rate and resin viscosity on preform permeability were investigated in details
文中首先根據達西定律建立了滲透率測量的理論模型，深入研究了不同的測試方法及主要工藝參數（纖維織物織構、纖維體積含量、充模壓力、流動速度、樹脂粘度）對滲透特性的影響規律，發現多孔介質增強材料的滲透率主要取決于纖維織物的結構形式，預成型體孔隙分佈及其體積分數、壓實性對滲透率有較大的影響，提高充模壓力和流動速度可以縮短充模時間，在一定程度上可以提高滲透率。分享友人