高膨脹合金 的英文怎麼說

中文拼音 [gāopéngzhànggějīn]
高膨脹合金 英文
high expansion alloy
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 膨 : 動詞（物體的長度或體積增加） expand; swell
  • 脹 : 動詞1. （膨脹） expand; dilate; inflate 2. （脹大） swell; distend; bloat
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 膨脹 : expand; swell; dilate; inflate; puff; bulge; inflation; expansion; dilatation; buckling; swelling...
  1. And due to the heat expansile coefficient of the stainless steel rather high, the connecting force between the stainless steel pipe and the pipe coupling in the room temperature is much less than that between the titanium alloy pipe and the pipe coupling. the results accord with the tensile experiments well. finally, the dependence of dimensions of the coupling on the strength of the connector system is analyzed

    模型計算還表明，被接管材料和管接頭材料之間的熱膨脹系數的差異會造成管接頭系統的室溫強度低於高溫強度；由於不銹鋼的熱膨脹系數較大，使得室溫下1不銹鋼管與n立tinb形狀記憶合金管接頭間的抱緊力遠小於鈦合金管與nitinb形狀記憶合金管接頭間的抱緊力，成功地解釋了拉脫實驗中的結果。
  2. Hypereutectic al - si alloys are known to be suitable for wear - resistance material because of its low density, high tensile properties and low coefficient of thermal expansion

    高硅鋁合金的耐磨性好，強度高，密度低，熱膨脹系數小。
  3. The expansion and dehiscence behavior during the vacuum reactive sintering below 660 of compact ti / al composite powders was experimentally investigated, and the reasons of expansion and dehiscence were theoretically analyzed. the method of low temperature reactive sintering was generalized, and the experiment testified the method effective. the rule of the expansion of the billets was generalized from the result of density of the billets

    低溫反應燒結工藝:研究了高能球磨ti / al復合粉體在溫度低於660下真空無壓反應燒結過程中的膨脹和開裂行為，分析了產生膨脹和開裂的主要原因;並提出了能夠有效預防坯料開裂的方法;通過測定坯料在低溫燒結后的密度，總結了其體積膨脹的規律;通過x射線衍射技術分析了隨球磨時間不同，金屬間化合物的生成情況。
  4. In metal matrix composites, thermal residual stresses will arise due to get ( coefficient of thermal expansion ) mismatch between matrix and fiber during cooling

    在擠壓鑄造的金屬基復合材料中，由於基體和纖維的熱膨脹系數相差很大，所以在制備過程中由高溫（工藝溫度）冷卻至室溫時復合材料中會有熱殘余應力產生。
  5. As the content of vermiculite minerals was about 3 %, the impact strength ( nick ), the flexural strength and the heat distortion temperature ( hdt ) of the nanocomposites all were the lowest and decreased 21 %, 28 %, 3c, respectively. compared with those of the polybenzoxazine ( bisphenol a type ), its thermal expanded coefficient ( tec ) was 3. 4 % bigger than that of the polybenzoxazine ( bisphenol a type )

    雙酚a型ben蛭石納米復合材料的力學性能和熱性能表現出明顯的結構特徵，普遍地低於純樹脂的性能數值，而優于雙酚a型ben金雲母復合約zi和zs 「熱變形溫度dt ）低約3 ，線膨脹系數高約3
  6. We think increase of the internal resistance of battery is the main problem to the recycle life deteriorating at high rate, besides the influence of the materials. decomposition occurred on positive and negative electrode at high rate current and the interspaces increased. the restrains of swelling and the increase of an oxygen overvoltage can improve the performance of recycle life

    對于電池性能衰減的原因，認為除了所使用的材料是影響電池性能的重要因素之外，在溫度和大電流作用下，電池的正負極材料發生裂解，極片內空隙增大，電池內阻性能惡化是引起電池高倍率循環性能惡化的關鍵;通過抑制正極析氧和膨脹，並降低負極合金材料的粉化過程，將有望緩解電池內阻特性的惡化，從而提高電池高倍率充放電循環性能。
  7. The titanium alloy valve is more superior than ordinary steel valve in lighter, smaller thermal expansion coefficient, lower in thermal expansion, fatigue durable, good elasticity, and reduces oil consumption so as to prevent instability while revolving at high speed and obtain perfect performance

    鈦合金汽門彈簧比一般鋼閥材質更輕巧、熱膨脹系數小、熱量傳導擴散更低、耐疲勞、彈性佳、減少油耗，以阻止在高速運轉下的不穩定以獲致最完美的性能表現。
  8. The ha coating is easily broken off from the substrate because of the interface corrosion, caused by the body fluid, and the cycle load. the preparation of the bg / ha bioactive graded coating on the surface of ti6a14v is an effective way to alleviate the heat stress

    在鈦合金表面制備生物玻璃（ bg ） ha梯度塗層，來緩和因熱膨脹系數不匹配而造成的塗層內部過高的熱應力是解決以上問題的有效途徑之一。
  9. Jiangsu days steel limited - production, scientific research, integration of the business, is the industry standard varieties of the most complete one of the special steel enterprises, will be able to produce acid stainless steel, heat - resistant stainless steel, welding of stainless steel, high temperature alloy electrical resistivity, magnetic alloys, expanding alloy material from the rods, bars, wires, tubes, strip

    江蘇興天合金鋼有限公司集生產、科研、商貿為一體，是同行業中品種規格最齊全的特鋼企業之一，能生產耐酸不銹鋼、耐熱不銹鋼、焊接用不銹鋼、高溫電阻電熱合金、軟磁合金、膨脹合金等材質的線材、棒材、絲材、管材、帶材。
  10. The present situation of investigation on the alloy with high strength and low linear coefficient of thermal expansion and the achieved level are summarized, and some opinions on the further alloy researches are given roughly

    總結了高強度低熱膨脹合金研究的國內外現狀和達到的水平，對高強度低熱膨脹合金將來的研究方向提出了看法。
  11. When analyzing the conditions of monetary cooperation, the dissertation compares east asia with ecu region and south america on financial and exchange rate policies first, and then discusses 6 basic cooperating conditions completely. these conditions are : ( 1 ) the industry and trade related rate and economic open rate among east asia countries ; ( 2 ) diversity degree of products in the region ; when countries in the region can meet the condition of " diversity of low degree products ", operating monetary cooperation may have significant in reality ; ( 3 ) consistence of member states " economy period and symmetry of financial relation among member states ; ( 4 ) inflation rate ' s similarity among member states ; ( 5 ) coordination on policy among member states ; ( 6 ) support of a hard currency in the region. without a hard currency ' s support, monetary cooperation will be destroyed easily by outer speculating capital because of limitation of economy and store capital in the region

    在對東亞貨幣合作可行性條件進行分析時，本文首先對東亞和其它貨幣合作區域的金融及匯率制度進行分析，以確定東亞地區在貨幣合作階段上所處的位置；然後對實施東亞貨幣合作的六大基礎條件進行了詳細的論述和分析，分別是門）區域內成員間的產業與貿易關聯度，其值越高，貨幣合作的收益越大：區域內各成員的經濟開放度，外貿依存度較高則合作收益明顯： （ 2 ）區域內產品的多樣化程度，當區域內成員符合「低程度產品多樣化」的條件時，實行貨幣一體化以抵禦外部沖擊才具有現實意義； （ ）區域內各成員之間經濟周期波動的一致性，區域內成員的金融關系及受外界沖擊的對稱性； （ 4 ）區域內各成員間通貨膨脹率的相似性； （ 5 ）區域內各成員在政治上的協調性； （ 6 ）區域內強勢貨幣的支持，缺乏強勢貨幣的支持而建立起來的貨幣同盟會因整體經濟實力和儲備資產的限制而難以擺脫外部投機資本的沖擊。
  12. A titanium alloys possess characteristics such as high specific strength, low thermal conductivity, good compatibility to medium and good resistant to hydrogen embrittlement, which makes a titanium alloy suitable for the use in liquid fuel tank and tube at cryogenic temperature

    鈦合金在低溫下具有比強度高、導熱率低、熱膨脹系數小、介質相容性好、抗氫脆等特點。這些性能特點使得鈦合金能很好的滿足液體燃料儲箱和低溫管道的使用要求。
  13. Metal matrix composite had begun to develop early in 1960s, and became one new branch in the field of composite. among them, the aluminum based matrix developed especial quickly, because it has many merits compared with other metal, such as light weight, specific strength and shear strength, low coefficient of thermal expansion, high young ' s modulus, better thermal stability and temperature conductivity

    金屬基復合材料在六十年代開始有了較快的發展，成為了復合材料領域的新支，其中，鋁基復合材料的發展尤為迅速，因為它具有重量輕、比強度高、剪切強度高、熱膨脹系數低、高的彈性模量，良好的熱穩定性、導熱性能等一系列優點。
分享友人
分享到 Line

分享到臉書