高薄 的英文怎麼說

中文拼音 [gāo]
高薄 英文
takasusuki
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 名詞[方言] (浮萍) duckweed
  1. A detailed analysis of the electrical properties of ato thin films was carried out in order to investigate the sb / sn atomic ratio and substrate temperature ' s influence on the ato thin film. a convictive explanation brought forward to illustrate the changing of the electrical ; properties of the ato thin film in different conditions

    在溫度較低時( < 500 ) ,膜的方塊電阻隨成膜溫度的升而降低;當基板溫度繼續升膜的方塊電阻隨基板溫度的升而增大,這主要是因為玻璃基板中k ~ + 、 na ~ +離子向膜中的擴散。
  2. The way to achieve better economic results of thin kerf diamond bits

    高薄壁金剛石鉆頭經濟效益的途徑
  3. Controlled demolition blasting technology for thin reinforced concrete wall of a flood discharging tunnel

    泄洪洞鋼筋砼高薄邊墻切割拆除控制爆破技術
  4. While the thin films are annealed at higher temperature, the c axis of the permanent phase tends to lie in the thin films plane, which results in the higher coercivity of the thin films

    隨著退火溫度的升膜永磁相c軸趨向于平行膜面,從而膜面內矯頑力較
  5. Based on experiments and theory analysis in the past, here we present the most important technology conditions that affecting photosensitivity : 1 、 cycle times, experiments showed that with the increase of cycle times, photosensitivity got worse ; 2 、 h dilution ratio, with the continuously increase of h dilution ratio, h ’ s bombardments on the growing surface enhanced continuously too. these bombardments can eliminate high - energy default configurations priorly and leave stable configurations behind. therefore, growing layer ’ s configurations are impacted ; default state density is decreased and photosensitivity is improved

    Layer - by - layer方法的制備工藝條件很多,我們在以往實驗和理論分析的基礎上,介紹了對光敏性影響最為重要的工藝條件: 1 、循環次數的影響,實驗表明隨著循環次數地增加,光敏性變差; 2 、 h稀釋比的影響,隨著h稀釋比的不斷增加, h對生長表面的轟擊不斷增強,這些轟擊能優先消除能缺陷結構而留下穩定的結構,從而使生長層結構緻密,減少缺陷態密度,提高薄膜的光敏性。
  6. The properties of cn thin films such as their morphology, component, crystal structure and the bonding structure and the relation between those properties and the gas - phase reaction parameters were discussed, showing that the deposition of p - c3n4 thin film is the compete result of various reaction processes in the dynamics balance conditions ; the process of cn films depo sition is diagnosed in situ through the optical emission spectra technique, the effects of experimental parameters on the concentration of the precursors and the gas - phase reactions in the plasma have been obtained ; the main reaction precursors for film deposition identified ; the relation between the characteristics of cn thin films and the reaction process in the plasma is analyzed. the cn thin films deposition under different substrate temperatures in high pressure pe - pld shows that the si atom of the substrate has participated the cn films growth process, based on this the growth mode of cn thin films on the si substrate is proposed. the further experiment of cn thin films deposition on si substrate scratched by diamond as well as covered with fe catalyzer has been attempted, which indicates that changing the dynamics conditions of the surface reaction can alter the growth characteristic of the cn thin films and can enhance obviously the films growth rate

    採用pld技術進行了碳氮化合物膜沉積,得到了含氮量為21at的cn膜;研究了襯底溫度和反應氣體壓強對膜結構特性的影響,給出了cn膜中n含量較小、 sp ~ 3鍵合結構成分較少和膜中僅含有局域cn晶體的原因;引入脈沖輝光放電等離子體增強pld的氣相反應,給出了提高薄膜晶態sp ~ 3鍵合結構成分和膜的含n量可行性途徑;應用pe - cvd技術以ch _ 4 + n _ 2為反應氣體並引入輔助氣體h _ 2 ,得到了含n量為56at的晶態cn膜;探討了cn膜形貌、成分、晶體結構、價鍵狀態等特性及其與氣體壓強和放電電流的關系,證明了- c _ 3n _ 4膜沉積為滿足動力學平衡條件的各種反應過程的競爭結果;採用光學發射譜技術對cn膜生長過程進行了實時診斷,得到了實驗參量對等離子體中活性粒子相對濃度和氣相反應過程的影響規律,給出了cn膜沉積的主要反應前驅物,揭示了cn膜特性和等離子體內反應過程之間的聯系;採用氣壓pe - pld技術研究了不同襯底溫度條件下cn化合物膜的結構特性,揭示了si原子對膜生長過程的影響,給出了si基表面碳氮膜的生長模式;在金剛石研磨和催化劑fe處理的si襯底上進行cn膜沉積,證明了通過控制材料表面動力學條件可以改變碳氮膜結構特性,並可顯著提晶態碳氮材料的生長速率。
  7. The main topic of this thesis is to deposit the lacamno3 films using the pulsed laser deposition ( pld ) technique, and to improve the properties of the films through a serials of processes including the post annealing treatments. at last, the relation between the physical properties and the film making processes of the materials are discussed and some possible applications explored

    本論文的任務就是利用脈沖激光沉積lacamno _ 3膜,並通過退火等一系列工藝處理提高薄膜性質,最終製作測輻射熱儀的敏感元件,同時也對材料的物性展開討論,以探尋更多的應用。
  8. The films prepared under 425 ? is composed with amorphous snoi and its sheet resistance is very high. with the substrate temperature ' s increasing, the degree of crystallization, film thickness increase and electrical resistivity, sheet resistance decrease obviously. when the substrate temperature is higher than 525 ?, the temperature ' s increasing is not of benefit to the films thickness and sheet resistance

    常壓熱分解cvd法制備的sno _ 2在較低基板溫度下制備出的膜基本上是非晶態的,方塊電阻很;隨著基板溫度的升膜厚度增加,膜結晶程度提膜電阻率和方塊電阻均顯著降低;當基板溫度於525以後,隨著基板溫度的升膜厚度基本不再明顯增加,膜結晶程度繼續提膜電阻率繼續降低,方塊電阻不再明顯降低。
  9. With increasing calcination temperature, the photocatalytic activity of the tio2 thin films gradually increased due to the improvement of crystallization of the anatase tio2 thin films

    隨熱處理溫度的升膜的光催化活性逐漸增加,這是由於膜中銳鈦礦相tio _ 2的形成和tio _ 2晶化程度的提
  10. Excessive or less n2o flux would lead the falling down of photocatalysed efficiency under the uv light irradiation. with the doping of n, the photocatalysed efficiency under visible light irradiation was improved obviously

    N _ 2o流量過大和過小都會導致膜在紫外光照射下光催化性能下降, n的摻雜可以提高薄膜可見光照射下的光催化性能。
  11. Lower water vapor partial pressure during processing for higher quality, better adhesion and more reproducible deposition

    改善鍍膜的質量,提高薄膜的附著力和多層鍍膜能力。
  12. X - ray diffraction ( xrd ), uv - vis absorption spectroscopy and photoluminescence spectroscopy ( pl ) were employed to study the structural and optical properties of mgxzn1 - xo alloy thin films. the experimental results show that the films were hexagonal wurtzite structure and the band - gap of mgxzn1 - xo alloy thin films gradually increased with increasing mg content. the quality of mgxzn1 - xo alloy thin films can be greatly improved by means of annealing in oxygen ambient

    實驗結果表明,利用溶膠-凝膠法制備的mg _ xzn _ ( 1 - x ) o納米膜為六角纖鋅礦結構,粒徑為3 5nm ,隨著mg含量的增加帶隙變寬;通過在氧氣氣氛下退火處理后, mg _ xzn _ ( 1 - x ) o納米膜表現出了較好的結構和發光特性,表明熱處理可提高薄膜質量。
  13. It was found from the experiment that, with the increasing of substrate temperature, there were more oxygen vacancies in the films, which lead the conductance of the sample become larger, and the absorb edge of zno thin films shifted toward higher wavelength ; with increasing of ar : o2 ratio, there were lesser oxygen vacancies in the films, which lead the absorb edge of zno thin films shifted toward lower wavelength

    實驗還發現,隨著襯底溫度的升膜中產生的氧空位將會增多,使得zno膜的電導逐漸增大,而且其紫外透射吸收截止邊帶向波長方向漂移;隨著氬氧比例的增加,膜中的氧缺陷相對減少,膜的透射吸收截止邊向低波長方向漂移。
  14. It was found from the experiment that, with the increasing of substrate temperature, there were more oxygen vacancies in the films, which lead the conductance of the sample become larger, and the absorb edge of ito thin films shifted toward lower wavelength ; with increasing of ar : o2 ratio, there were lesser oxygen vacancies in the films, which lead the absorb edge of ito thin films shifted toward lower wavelength

    實驗還發現,在一定的溫度范圍內隨著襯底溫度的升膜中產生的氧空位將會增多,使得ito膜的電導逐漸增大,而且其紫外透射吸收截止邊帶向短波長方向漂移;隨著氬氧比例的增加,膜中的氧缺陷相對減少,膜的透射吸收截止邊向低波長方向漂移。
  15. It also shows that hardness increases with the increase of film thickness, substrate temperature and substrate bias. and among these processing parameters, the substrate temperature and bias have the more prominent influences

    同時,隨著膜厚的增加,基片溫度的提以及對基片施加的偏壓的增膜的硬度都有不同程度的提
  16. To those films with various zro2 contents, the linear relationship with refract index and zro2 contents would become more significant with the increase of heat treatment temperature

    對于不同組成的膜,隨著熱處理溫度的提膜的折射率與組成的線性關系越來越顯著。
  17. The writer also elaborates the working principles of solar cell and various factors that may lead to bad conversion efficiency of solar cell, emphasizes on three thin film solar cells ( amorphous silicon thin film solar cell, poly silicon thin film solar cell, cuinsea thin film solar cell ), analyzes their structure, photovoltaic effect, producing techniques, and conversion efficiency etc., and discusses how to reduce the effects of sw in solar cell and how to improve the conversion efficiency

    闡述了太陽電池的工作原理,論述了影響太陽電池轉換效率的因素,並重點介紹了當前研究比較深入的三種熱點膜太陽電池:非晶硅膜太陽電池( a - si ) ;多晶硅( poly - si )膜太陽電池:銅銦錫( cis )膜太陽電池。分析了它們的結構、光伏效應、制備工藝、轉換效率等,探討了如何減小太陽電池的光致衰退效應和提高薄膜太陽電池的轉換效率的方法。
  18. It has been found that a preferable orientation can be obtained while both the smco5 phase and the sm2co17 phase have deposited plenty in the two - steps heat treatment

    而合適的兩級退火熱處理能使smco5和sm2co17永磁相充分析出,並形成一定的擇優取向,從而可以顯著提高薄膜的矯頑力。
  19. Modify tool structure of tungsten carbide to improve turning quality of thin - walled hole

    改進硬質合金刀具結構提高薄壁內孔表面車削質量
  20. Elementary analysis of how to improve the comfort nature of thin woolen sweater

    淺析如何提高薄型羊毛衫的舒適性
分享友人