高速跡形 的英文怎麼說

中文拼音 [gāosùjīxíng]
高速跡形 英文
very high rates of deformation
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 跡 : 名詞1 （留下的印子; 痕跡） mark; trace 2 （前人遺留的建築或器物等） remains; ruins; vestige 3 （...
  • 高速 : （高速度） high speed; high velocity （hv）; high rate; swift; fast; express; high-speed
  1. The procedure functions in the compare between partial image of dynamic collection and corresponding image of the airscape. in chapter 5, basing on the analysis of correlative theory of digital image, we introduce the improved fasted - down algorithm and simulative anneal algorithm, which applies to nn calculation, an d bring forward the unique and effective means, correlative original value evaluation. basing on the combination of correlative arithmetic, a stable, high - speed and exact correlative arithmetic is formed, which makes it possible to apply computer vision detection of single - needle quilting in industrial production

    本文展開研究並取得一定成效：構建了基於pci總線的微機實時圖像採集系統；在採集的布料總圖（鳥瞰圖）的基礎上，通過數字圖像的數字濾波、圖像增強、邊緣檢測等處理，提取布料圖像的邊緣，對輪廓的矢量化的象素點進行搜索，得到相應的圖案矢量圖，從而確定絎縫的加工軌跡，生成加工指令；在進給加工過程中，主計算機對動態局部圖像與總圖（鳥瞰圖）的對應部分進行圖像相關的匹配計算，應用數字圖像理論，結合神經網路計算的改進最速下降法和模擬退火演算法，提出獨特而有效的相關迭代初始值賦值方法，形成穩定、高速和準確的相關運算，實現單針絎縫視覺測量和自動控制。
  2. When a meteoroid with a speed of tens of kilometers per second hits the earth s atmosphere, the friction with air will heat up the meteoroid. the high temperature will cause the surrounding atmosphere to glow, creating a bright streak of light called a

    當流星體以每秒數十公里的速度進入地球大氣層，由於與空氣摩擦而產生高熱，高溫令流星體四周空氣發光，形成一條劃破天際的光跡，我們稱之為
  3. Based on the theory creation of space voltage vector ' s polygonal flux linkage locus, freewill partition of the ideal flux circle is realized by the software method. furthermore, different polygonal flux linkage locus ' s fluent switching point is also found, which overcomes the motor " switching failure and improves the speed adjusting dynamic performance

    在充分研究磁通軌跡法原理的基礎上，採用軟體方法實現了任意多邊形磁鏈軌跡的生成；並找出了不同磁鏈軌跡間的平滑切換點，解決了切換時的電動機失步問題，提高了系統轉速調節的動態性能。
  4. In the paper, based on the method of low pair replacing with high pair, the problem of cam design was transferred to that of linkage design. by means of rotary unit vectors, the equations of displacement, velocity and acceleration of the replacement mechanisms were developed. and then, the virtual linkage ' s length and direction were deduced

    論文基於高副低代原理，將平面凸輪機構設計與再現函數的平面連桿機構設計統一為同一種方法，運用圓向量函數建立代換機構的位移、速度、加速度矢量方程式，求取虛擬連桿桿長和方向，由此展開凸輪理論廓線、實際廓線、曲率半徑和壓力角的求解，並得出用圓形刀具加工凸輪時刀具中心的軌跡方程。
  5. The supernatant fraction and the precipitation fractions were analyzed by western blotfor strain dh5 a / pkkfpga, 5 - 10 % pga precursors formed as inclusion bodies in the cytoplasm while no inclusion bodies formed in the periplasm, this suggested most pga precursors were transported to the periplasm and matured to active pga and indicated that the maturation of pga in strain dh5 / pkkfpga was limited by the translocation step

    Western印跡分析表明對于菌株dh5 pkkfpga ， 5 - 10的原前體青黴g素酰化酶在胞內形成了包涵體，說明其成熟的限速步驟在胞內的運輸階段，而菌株dh5 psmlfpga則無明顯包涵體形成，說明菌株dh5 psmlfpga改善了青霉素g酰化酶的合成流，因而其表達能力高於菌株dh5 pkkfpga 。
  6. It is constructed that radial impact and rubbing dynamics differential equations of the rotor system having the nonlinear rigidity on the unsteady and non - linear oil film. the bifurcation and chaos behavior of impact and rubbing fault rotor system caused by the parameters of nonlinear rigidity, rotor rotating speed, eccentric mass is analyzed, in the numerical value analysis method. the bifurcation diagrams, maximum lyapunov exponent diagrams, poincar maps, phase plane portraits, trajectories of journal center, time - history curve, amplitude spectra diagrams of the rotor motion are used

    （ 2 ）建立了具有非線性剛度的轉子系統在非穩態非線性油膜力作用下的徑向碰摩動力學微分方程，並應用含高階余項的非線性動力方程的線性化數值法研究了此類系統響應的復雜動力學行為，利用轉子響應的分岔圖、最大lyapunov指數曲線、 poincar截面映射、時域波形、相軌線、軸心軌跡、幅值譜等圖形分析了系統響應的周期運動、擬周期運動、倍周期分岔、混沌等運動形式的轉化與演變過程，重點研究了非線性剛度、轉子轉速、偏心質量等系統參數對碰摩故障轉子系統的分岔和混沌行為的影響。
  7. By means of the software of pro / e we studied the movement of the bit and obtained some data reports about different parameter bit. in the environment of visual basic the trace program can compute the well - bottom outline. it also can draw the trace and the velocity curve that the teeth scrape the well bottom

    分析方法是在pro / e中對試驗鉆頭進行運動模擬，得到不同結構參數和傳動比的鉆頭運動的數據文件，然後進入用visualbasic高級語言編制的異形牙輪單牙輪鉆頭分析軟體中，計算出鉆頭的井底輪廓曲線，並繪制鉆頭井底軌跡和牙齒刮切井底的速度曲線。
  8. Generally speaking, the algorithm of terrain contour matching is adapted to be used in cruise missiles which made fight path prior for that this algorithm is not a real - time system for it makes use of historical terrain data. while kalman filter algorithm is a real - time, rapid calculation system. which is appropriate for pilot or pilotless aircraft

    得出，地形輪廓匹配演算法使用歷史地形數據，實時性差，比較適合事先規劃好航跡的導彈使用：卡爾曼濾波的方法有較好的實時性，計算速度快，很適合有人無人駕駛飛機的機動飛行要求；小波分層只是對地形信息做了高低頻分解，其本質還是相似性度量演算法，但它有效的降低了匹配演算法的計算量。
  9. Aperture synthesis sonar, as its name implies, synthesizes an aperture by storing successive echoes obtained from a moving platform and by processing the results as if they had been obtained from a multi - element array enables a high azimuth resolution to be obtained from a physically small array

    合成孔徑聲納，顧名思義就是通過小孔徑物理聲陣的勻速直線運動，將沿航跡方向的回波數據相干累加，形成較大的虛擬孔徑，從而提高方位解析度。合成孔徑技術相對于常規聲納技術的突出優勢在於，它只利用小孔徑的物理聲陣，就可以得到與徑向距離和頻率都無關的高方位解析度。
  10. Based on adaptive control theory, respectively study the system consisting of non - redundant robots and the system made up of redduant robots, proposing classes of adaptive control strategies for trajectory tracking and internal force tracking of robot manipulators with uncertainties. though the controller for the system consisting of nonredduant robots dot not satisfy the condition persistent - exciting, it guarantees the system be stable ; for the system consisting of redduant robots, firstly we derive a new dynamic equation based on the manifold embedding theory in geometry, then design a controller without solving the represser of the system

    對于非冗餘的具有參數不確定性的多個機器人系統，給出了一種自適應控制器的設計法，此控制器保證即使系統不滿足pe條件，系統的內力軌跡仍漸進穩定；對于冗餘的機器人系統，利用微分幾何中的流形嵌入理論推導出一種新的機器人動力學方程，利用此方程設計出一種無須求系統回歸矩陣的控制器，從而提高了系統的運算速度。
分享友人
分享到 Line

分享到臉書