高頻陶瓷 的英文怎麼說

中文拼音 [gāobīntáocí]
高頻陶瓷 英文
high frequency ceramics
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 陶 : 陶名詞1. （窯） kiln2. （人名用字） a word used in person's name
  • 瓷 : 名詞（用高嶺土、長石、石英等燒製成的材料） porcelain; china
  • 高頻 : high frequency
  • 陶瓷 : pottery and porcelain; ceramics陶瓷地磚 floor tile; 陶瓷電子管 ceramic tube; 陶瓷電阻器 ceramic r...
  1. Using the advanced technology by its head office ( newkey co., ltd. ), it produces various kinds of alumina black and white ceramic products. the component alumina ceramics, which are widely used in electron components, devices, electrical products, enjoy low loss of high frequency, high insulating strength, good specific volume resistance, small dielectric constant, high mechanical intensity and excellent airtightness and thermal and chemical stability

    本公司根據目前市場需求，生產出各種型號的黑、白陶瓷產品，廣泛應用於電子、電工、化學工業、紡織工業、水暖、宇航、環保等諸多方面，系列產品有高頻損耗少，比體積電阻大，介電常數小，強度高，氣密性、熱穩定性、化學穩定性好等特點。
  2. Using pro / e ansys fem software, based on results of analyzing fem model, the article discuss the influence to the eigenfrequency of the stator in different dimension parameters of the stator loop, different pzt thickness, the influence of tooth height along circumferential direction on eigenfrequency is analyzed. it offers a foundation for optimum design the structure of the stator. fem equivalent circuit model of the ultrasonic motor has been built

    利用pro / e 、 ansys等軟體建立了圓盤定子的有限元模型，通過有限元分析的方法，討論了定子圓盤各個徑向尺寸參數對特徵頻率的影響，不同壓電陶瓷厚度對定子特徵頻率的影響，以及定子齒的齒高的變化對特徵頻率的影響，為馬達結構參數的優化設計提供了依據。
  3. Smart materials and structure have definite requirements of sensor components and driving components, for example, they can adhere well to the matrix and have higher strength, fatigue strength, more broad scope of frequency response and faster response speed, etc. piezodielectric ceramics have characteristic of easily preparing, heat - resistance, wet - resistance, high strength and broad scope of frequency response, etc. furthermore, it has piezoelectric effect and inverse piezoelectric effect, namely it can produce electric potential energy when it is transformed by mechanical strength and its mechanical dimension can be transformed when voltage is put on it

    壓電陶瓷能與基體材料很好結合，具有制備容易、耐熱、耐濕、強度高、頻響寬等特點，另外它具有正壓電效應和逆壓電效應，即當它受到機械力變形時，能產生電勢，對它施加電壓時，能改變其機械尺寸，因此它在智能材料結構中既能用作傳感元件又能用作驅動元件。
  4. Low - frequency fatigue investigation of 0. 94pbmg1 3nb2 3o3 - 0. 06pbtio3 and ba0. 7sr0. 3tio3 ceramics under high - electric - field cycling and the de - fatigue effects by heat treatment

    鐵電陶瓷的低頻高場疲勞特性及去除疲勞方法的研究
  5. It was found that the dropping rate in remnant polarization, pr ( n ), of the samples would be accelerated when a high intensity or low frequency or square - wave of electric field was applied or at a lower temperature

    實驗結果表明，在高電場強度、低電場頻率和在方波電場的作用下以及較低的溫度下，鐵電陶瓷材料剩餘極化強度p _ r （ n ）下降的速度變快。
  6. The factory specially produces electronic high frequency ceramic parts, electric ceramic, electro thermal ceramic, optical ceramic, and various fine ceramic parts, main have porcelain lamp holder, porcelain lampstand, chem lamp holder, optical lamp holder, optical resistance, accessories and art ceramic, fine flower plateetc

    我廠專業生產電子高頻陶瓷件，主要有電器陶瓷，電熱陶瓷，光源陶瓷，以及各種精陶瓷配件；還生產各種低壓電器陶瓷件，主要有瓷燈頭，瓷燈座，碘鎢燈頭，光源燈頭，瓷電阻，煤氣燃具瓷打火針，感應針和異形陶瓷等多品種配件以及工藝陶瓷精品花盆等。
  7. Various 9 5 porcelains of specialty production, 7 5 porcelain and high frequency porcelain, general porcelain, refractory and various pottery and porcelain metals assemble the part, and manage at the same time the various potteries and porcelains previously assisting the material, and the product extensive use is in electronics, electrical equipment, automobile and spins machine, welding, metallurgy, illumination and chemical industry etc trades

    專業生產各種九五瓷、七五瓷、高頻瓷、普瓷、耐火材料及各種陶瓷金屬裝配件，同時經營各種陶瓷原輔材料，產品廣泛應用於電子、電器、汽車、紡機、焊接、冶金、照明、化工等行業。
  8. Dr is made of microwave ceramic with high dielectric constant and very low loss. using dr, the phase noise of an oscillator could be made to be extremely low

    介質諧振器（ dr ）由高介電常數、低損耗的微波陶瓷材料製作而成，它能極其容易地實現微波頻率源的低相位噪聲。
  9. Secondly, we have studied the properties of the conbzr high frequency soft - magnetic thin film, and use the dc magnetron sputtering system by conquering the key technology to fabricate double - sides thin - film inductors on 10mm * 10mm printed circuit board and 20mm * 20mm ceramic board

    再次，研究了薄膜電感所使用的conbzr高頻軟磁薄膜材料的性能，並利用真空磁控濺射設備，克服各種關鍵技術及工藝難度，在10mm 10mm的pcb板、 20mm 20mm陶瓷基片上製作了薄膜電感。
  10. Advanced monolithic structure is formed using multilayering and sintering process with ceramic and conductive materials for high - frequency

    先進的單體結構是使用積層的堆層方式，陶瓷的燒結過程及傳導性的材質適用於高頻
  11. The high switching frequency allows the use of small surface - mount capacitors, saving board space and reducing cost

    高的開關頻率允許選用小的表面陶瓷電容，可節省板級面積、降低成本和減小輸出電壓紋波。
  12. Ceramic capacitors at high frequencies, method of test for effective series resistance and capacitance for multilayer

    高頻多層陶瓷電容器有效串聯電阻和電容的試驗方法
  13. Monolithic ceramic capacitors have very low series inductance ( they are formed of a multilayer sandwich of metal films and ceramic dielectric and all the films are joined to a bus - bar rather than being connected in series )

    對于高頻去耦更合適的選擇應該是片式陶瓷電容器，因為它們具有很低的等效串聯電感。
  14. The thesis mainly investigated the bati _ 4o _ 9 ( bt _ 4 ), which has the lowest dielectric loss in ba - ti system, and ( ba, sr ) tio _ 3, the a position substitute compound of batio _ 3. the dielectric properties of bt _ 4 / bst with different preparation way and different elements doping were investigated. a archimedes method, xrd, sem, impedance analyzer, network analyzer and hakki - coleman method were used to investigate the density, phase formation, microstructure, dielectric properties and doping mechanisms

    本論文以在ba - ti系中具有最低介電損耗的bati _ 4o _ 9 （ bt _ 4 ）高頻介質陶瓷和batio _ 3a位sr取代而得的（ ba ， sr ） tio _ 3 （ bst ）高頻介質陶瓷作為研究對象，對不同粉體制備方法制備的bt _ 4 / bst高頻電介質材料進行不同元素的摻雜，運用阿基米德方法， x射線衍射分析儀，掃描電子顯微鏡和阻抗分析儀，網路分析儀， hakki - coleman法等方法手段和測試儀器測試燒成樣品的密度，相組成情況，微觀結構和介電性能，探討造成介電性能起伏的形成機理。
  15. Our company absorbs nationtal and international advanced technics and managing approaches. it professionally produces special porcelain for electrothermal tubes, insulative radioceramics for electric machine, ceramhome appliances appropriation porcelain and ics, high - low - pressure porcelain, porcelain lamp holders, and kinds of porcelain etc. its annual output reaches over one hundred millionpieces and its products mainly are sold to all cities, municipalities of china, and the occident. and consumers favor them very much

    本廠全面吸收國內外先進技術和管理方法，專業生產電熱管專用陶瓷、家用電器專用陶瓷、電器絕緣高頻瓷件、高低壓陶瓷、燈飾瓷座、各種粗細瓷件等，月產量可達一億件以上，產品銷往全國各省、市、自治區，並遠銷歐美等國，深受用戶青睞。
  16. But its sintering temperature is so high that it cannot be sintered under 1000 with low melting point electrode materials like ag, cu etc. presently investigations about this material are mainly via glass - ceramic technique to decrease the sintering temperature and the dielectric loss is high. for the first time, this investigation manufacture a casio 3 system low dielectric and high frequency microwave dielectric ceramic via tape casting with basic material altered and additives doped

    本文以casio _ 3體系為研究對象，首先對casio _ 3體系進行改性，並首次採用li _ 2o和bi _ 2o _ 3作為燒結助劑，降低體系燒結溫度，在此基礎上，採用catio _ 3調節陶瓷的頻率溫度系數，制備出微波介電性能優良的具有工業應用價值的casio _ 3系ltcc低介高頻微波介質陶瓷。
  17. 2 ) temperature analysis of spindle bearings : using the basic theory of heat transfer, the paper founds the heat transfer model and derives the heat transfer resistance and heat transfer equations in spindle units. 3 ) running performance analysis of spindle bearings : the paper analyses the running performances with the influences of the friction heat, structure and application parameters through an example. 4 ) stiffness analysis and testing of spindle bearings : using hertz contact theory, the paper derives the stiffness formula, computes, analyzes and tests the stiffness through an example

    4xio 『 ，定壓預緊下，陶瓷球軸承的剛度大於全鋼軸承，而定位預緊下則相反； 5 ）一般，軸承中球的溫度最高，內圈次之，外圈溫度最低，但定壓預緊廠轉速達到一定值時，外圈溫度可能高於內圈； 6 ）主軸平動固有頻率和軸承徑向剛度的測量值與計算值基本一致，忽略w1 ） d的影響使測量值小於計算值，表明理論分析是正確的。
  18. The dielectric loss of the plct ceramics after polarization increases firstly, and then decreases with increasing frequency

    極化后的plct （ x ）陶瓷的介質損耗，隨頻率的增加先升高，然後降低。
  19. Shenzhen luguang electronic technology co., ltd is a high - new electronic technical enterprise, which is specializing in r & d, manufacturing, and selling of various piezoelectric materials, such as piezoelectric frequency components, diodes, transistors, digital television receiver, wireless controller, etc

    深圳市魯光電子科技有限公司，是一家專業研發、生產、銷售各種壓電陶瓷材料，壓電陶瓷晶體頻率元件?二極體?三極體?提供各種電路設計，模組化設計，無線控制器等各種電子產品的供應和技術應用的高新企業。
  20. The improvement of piezoelectric properties was obtained, and the frequency constant of the ceramics was changed obviously

    並且該pmzn壓電陶瓷的壓電性有所提高，明顯改變了頻率常數。
分享友人
分享到 Line

分享到臉書