黏度比 的英文怎麼說

中文拼音 [niándùbǐ]
黏度比 英文
viscosity ratio
  • 黏 : 形容詞（像糨糊等那樣能使一個物體附著在另一物體上的性質, 同「粘」 ） sticky; glutinous
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  1. Through experiment on the influence factor of calcic - mortar ' s performance, we find out the best cement contrast minute stone for compounding, strength of cement, configuation craft, maintenance system and minute stone cement intensity grading

    摘要通過對鈣性黏結砂漿性能影響因素的試驗研究，找出了配製鈣性黏結砂漿的最佳灰砂比、水泥強度等級、配製工藝、養護制度為和沙子級配。
  2. The density of mucopolysaccharide increased upon complete sonication more for the treated rats than for the controls, and this was closely related with the improvement in histopatho - logical findings, but inversely with the changes in arthritic severity

    在治療組中黏多醣類的密度在超音波治療前後及和控制組比較均有明顯的上升，而且於超音波治療結束時之黏多醣類密度與組織病理學上的修護有密切相關；同時黏多醣類密度的變化與嚴重度指標的改變成負相關。
  3. In the " wallace " film, which topped both the u. s. and uk box office charts and in march won an oscar for best animated feature film, the plasticine heroes battle a mutant rabbit bent on destroying their home town ' s annual giant vegetable contest

    在英美兩地都曾拿下票房冠軍、更在今年3月贏得奧斯卡最佳動畫獎的酷狗寶貝一片中，兩位黏土製的英雄與一隻執意要破壞其家鄉年度巨大蔬菜比賽的變種兔英勇奮戰。
  4. The quality of furan sand castings is usually better than clay sand castings, however, some defects are also very easy take place with furan sand castings such as blow hole, metal penetration, veining, cracking, slag inclusion, hardness too low, surface recarburation, surface sulphuration, nodularity degeneration etc, which were usually caused by improper raw materials selection, improper method design, incorrect moulding or / and core - making

    摘要呋喃樹脂砂鑄件質量一般比黏土砂鑄件好，但如果原材料選擇、工藝設計、造型和制芯操作不當，也會產生氣孔、粘砂、脈紋、裂紋，夾渣、硬度不足、滲碳、滲硫和球化不良等鑄造缺陷。
  5. Complete air piston pump contains pneumatic motor and piston pump, the ratio of piston area of pneumatic motor and plunger ' s sectional area of piston pump is transforming times of pump pressure ; the higher times, the more pressure can deliver higher viscosity fluid, and achieve the delivery aim

    完整的氣動柱塞泵包含有氣動馬達與柱塞泵兩部分，氣動馬達中的活塞面積與柱塞泵活塞的截面積比值，就是泵壓力轉換的倍數；愈高的倍數就能以愈大的壓力輸送愈高黏度的流體，達到輸送的目標。
  6. The paper points out that the reasons for displacement efficiency improving of pressure coring well are as follows : firstly, extra - high injection multiples ; secondly, extra - low critical drive ratio ; thirdly, high velocity fluid ' s big differential pressure drive during the process of coring

    得出導致礦場密閉取心井驅油效率高的原囚：一是特高的注水倍數，二是特低的臨界驅動比，三是取心過程中高黏度流體的大壓差驅動。
  7. The high sulfitated larch bark tannin extracts are more available to decrease the solution viscosity than the alkali treated extracts

    高度亞硫酸化的改性落葉松栲膠相比堿處理的改性落葉松栲膠更有效地降低其黏度和相對分子質量。
  8. On the other hand, through inhibted performances of concrete and mortar, the permeability refutations with different w / c, ages, admixture, and physics chemistry absorb regulation of different viscosity permeable liquid, the liquid - gas method is proved science and accuracy. because adopting with liquid - gas method it case clearer concrete permeability regulation. different concretes relativity is more exact and more efficiency and fixed quantity

    另一方面，我們利用混凝土所固有的性質：不同水灰比混凝土、砂漿、抗滲性能規律；不同齡期混凝土的抗滲規律；不同外加劑、摻合料抗滲性能之間相互對比規律；不同黏度滲透液物理化學吸附對測試結果影響的規律；用規律來映證溶液氣壓法的科學性，準確性。
  9. The effects of the mole ratio of anhydride to amino group of chitosan in the feed solution on the solubility, intrinsic viscosity and molecule weight of the product were studied

    研究了投料物質的量比對產物的溶解性、特性黏度和相對分子質量的影響。
  10. Two percent of hpmc appeared to be a satisfying suspending agent by evaluating the sedimentation rate and the redispersion of nabumetone

    通過對其沉降體積比、再分散性指標的考察，篩選了2 % hpmc助懸劑，並從流變學、混懸劑黏度及顯微形態等方面對其穩定性進行了研究。
  11. So the fires to make containers from volcanic clay must be hotter than those used for non - volcanic clay

    所以在燒制這種火山黏土做容器的時候就必須用比非火山黏土高很多的溫度來燒制。
  12. Composition, viscosity and interfacial tension are the most important effects that affect blends ' thermodynamic properties and crystal properties consequently change morphology of pp / ps blends

    聚丙烯/聚苯乙烯共混物的相形態受多種因素的影響，其中混合比例、黏度和界面張力為最關鍵的因素，影響著共混物的熱性能和結晶性能，從而導致相態的各種變化。
  13. Inherent viscosity, logarithmic viscosity number

    比濃對數黏度
  14. In this article are analysized the difficult points and the sizing technology in warp sizing of low and mid tex high density and high tight fabric, and it is proved, by practical example, that the warp sizing of low and mid tex high density and high tight fabric is more suitably to take the use of mid - concentration, mid - viscosity, high - pressure and fast sizing technology

    摘要分析了粗中特高密高緊度織物的經紗上漿難點，分析了其上漿工藝，並用實例進一步證實：粗中特高密高緊度織物的經紗上漿採用中濃、中黏、重壓和快速上漿工藝比較適宜。
  15. They found that black holes have an extremely low shear viscosity ? smaller than any known fluid

    宋等人發現黑洞有極低的切變黏度，比任何已知的流體還低。
  16. The simulation results show that the shaped degree is decreasing when the spinning temperature and intrinsic viscosity are increasing ; the spinning speed has little effect on the shaped degree when the pump mass throughput is constant ; the shaped degree is increasing with the increasing of pump mass throughput when the spinning speed is constant ; the cross air - blow conditions have much effect on the shaped degree ; the scope of shaped cegree is increasing when the aspect ratio of spinneret hole is increasing ; the shaped degree has obvious decreasing tendency in the small zone of spinning path and this decreasing became gently when the pump mass throughput is increasing

    模擬的結果表明：扁平纖維的異形度隨著紡絲溫度及特性黏度的升高而降低；泵供量一定時，紡速對異形度的影響不大；紡絲速度一定，異形度隨著泵供量的增大而增大；吹風條件對異形度的影響較大；隨著噴絲孔的長寬比的增大，異形度增加的幅度也較大；異形度在紡程上較小的區間內有明顯的下降趨勢，並隨著泵供量的增加其下降的趨勢變緩。
  17. By adding a narrow - sized coarse coal fraction to the finer coal slurry, the flow characteristics optimum coarse - to - fine particle ratio of 40 : 60 exist at which the slurry is newtonian

    但繼續增大粗顆粒在煤粉中的比例，體系的黏度又會增大，而且煤漿的流變性能也發生改變。
  18. The significant improvement in the rheological behavior with changing the particle size distribution may be explained in terms of spatial rearrangement of the particles, and apparent dilution effect

    在試驗條件下，粗細顆粒質量百分比為40 : 60時體系具有最低的黏度，煤漿性質由同濃度的細顆粒體系的非牛頓流體轉變為牛頓流體。
  19. A comparative study on relations for viscosity coefficient of a liquid determined by eddy - canister viscometer is presented and some errors therein are pointed out

    摘要對文獻中轉筒法測液體黏度的幾個關系式進行了比較研究，指出了其中的問題。
  20. The results indicate that less dosage of water, clay, bentonite and larger dosage of cement, and mixing coal ash and admixture can increase compressive strength of plastic concrete

    結果表明，減小水膠比及黏土和膨潤土的用量，增加水泥用量，摻加粉煤灰和外加劑，均可提高塑性混凝土的抗壓強度。
分享友人
分享到 Line

分享到臉書