點列 的英文怎麼說

中文拼音 [diǎnliè]
點列 英文
point range; range of points點列對合 point involution
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 列 : Ⅰ動1 （排列） arrange; form a line; line up 2 （安排到某類事物之中） list; enter in a list Ⅱ名詞1...
  1. A camera calibration method with co - line points is proposed, in which distortion center is located according to cross ratio invariability, and then distortion coefficients are calculated based on a line ' s central projection is a line

    摘要提出一種用共線點列標定攝像機鏡頭畸變參數的方法，先根據交叉比不變性確定畸變中心，再利用直線的中心投影仍為直線這一性質確定畸變系數。
  2. Four kinds of situations between the smallest outer - contained hexahedron of the same point series and axis of cylinder are presented, and the reliability of the above stated model and analysis is verified by living example

    給出了同一點列的最小外包容六面體與圓柱軸線間的4種情況，並用實例驗證了所述模型和分析的可靠性。
  3. The outer - contained parallel hexahedron smaller then that in the now existing document is presented according to the given point series, and the definition and solution model of smallest outer - contained cylinder are introduced

    摘要根據已給點列，給出了比現有文獻更小的外包容平行六面體，並引進了最小外包容圓柱的定義、求解模型。
  4. Presents a new method for fairing of curves which has a small flexibility based on fitting the derivative of second order of curves. we fit the derivative of second order of curves by a polynomial fitting, then find an indefinite integral of this polynomial to get a approach of curves. otherwise, we discuss the analyze of the error and the optimize of fairing to this arithmetic

    提出了一種針對小撓度曲線的逆向曲線光順演算法，該演算法直接擬合曲線型值點列的二階導數曲線，然後通過兩次積分來反求出光順后的曲線，並對該演算法的誤差分析、效果分析、光順優化等問題進行了深入探討。
  5. An expression that is evaluated with the specified node as the current node, and with the complete list of nodes being processed in unsorted order as the current node - list

    將指定節點作為當前節點並將未排序進行處理的完整節點列表作為當前節點列表計算的表達式。
  6. The appendchild ( ) method is used to add a node after the last child of a specific node

    方法的作用：在指定節點的子節點列表末尾添加一個新節點。
  7. The appendchild ( ) method appends a new child node to the end of the list of children of a node

    方法的作用是：在指定節點的最後一個子節點列表之後添加一個新的子節點。
  8. Camera lens distortion calibration with co - line points

    用共線點列標定攝像機鏡頭畸變
  9. The values that appear in the list of connection points are obtained from the

    顯示在該連接點列表中的值是從
  10. One possible solution is to provide the peer with a list of peers to check

    一個可能的解決方案是向這個對等點提供一個對等點列表，讓其檢查。
  11. In many practical problems, xi usually are some nonrandom design points, that is, fixed design points

    在許多實際問題中，我們遇到的多為x _ i是非隨機設計點列，即固定設計點列的情況。
  12. 5 hong x l, jing t, xu j y, bao h y, gu j. cnb : a critical - network - based timing optimization method for standard cell global routing

    即：每隻螞蟻各自維護一個訪問結點列表，記錄已經訪問過的結點，以此避免重復訪問同一個結點。
  13. Use effective and concise presentation methods to overcome length constraints, e. g. tables, charts, pictures, highlights, bullet points, lists, etc

    透過精簡有效的表達方式，克服報告的頁數規限，例如採用圖表照片彩色顯示點列一覽表等
  14. By preconfiguring every peer in a network with the list of peers it knows about and is willing to talk to, the network is hardened against outside attack

    通過對網路中的每個對等點預先設置它所知道並且將要與之交互的對等點列表，使得網路在外部攻擊面前表現得很穩固。
  15. This chapter sets out, in point form for easy reading, the task forces views on the consultants five - country study and highlights relevant points that might merit further consideration

    本章以方便閱讀的點列形或，載述專責小組對顧問研究結果的意見，並提出值得進一步研究的要點
  16. The parameter control methods are in the contrast, which is to find a sequence of parameters that converge to optimal value and its corresponding points in converge to optimal solution

    參數控制演算法的基本思想正好相反，它是構造參數序列來逼近最優值，相應的迭代點列逼近最優點。
  17. A dump usually of a selected area of storage taken at specified times during the execution of a routine, thereby providing a time history of this section of storage for debugging purposes

    通常指在程序執行過程中某一選定存儲區內容在指定時間的一種內象（也就是抽點列印內容） ，從而為調試程序提供該存儲區的定時記載。
  18. The following tables list by server explorer node the categories of data sources that administrators and typical users on local and remote computers can explore and create

    下表按服務器資源管理器節點列出了本地和遠程計算機上的管理員和典型用戶可以瀏覽和創建的數據源類別。
  19. This process is as follows : firstly, the data of different section contour and of section line have been obtained by reverse - engineering ; secondly, non - uniform b - spline approximation algorithm is used to fit the discrete data ; then the data have been optimized and reduced by adopting adaptive sampling of key points of the fitted curve based on vertical distance, sequently the adaptive sampling data is transformed into the format of the. ibl file of the famous 3 - d design software pro / e. therefore we reconstruct the surface and a model is generated ; lastly, the effectiveness of the adopted algorithm and modeling approach are demonstrated by the experiments

    建模型的過程中，首先運用逆向工程測量方法，獲得曲面物體上不同截面輪廓線的測量數據點列，接著對測量數據點進行平滑處理，用最小二乘法求解基於數據點列的控制多邊形，以非均勻三次b樣條曲線擬合截面輪廓曲線；然後利用基於垂距的數據采樣演算法，對擬合曲線上的數據點進行重新采樣，達到優化數據點的分佈及減少描述曲線數據量的目的。
  20. In addition to government press releases, it also provides breaking news stories conveniently highlighted in a front - page news ticker

    除政府新聞稿外，網站主頁的新聞速遞重點列出主要新聞，方便瀏覽人士閱覽。
分享友人
分享到 Line

分享到臉書