點火分 的英文怎麼說

中文拼音 [diǎnhuǒfēn]
點火分 英文
ignition cam
  • : Ⅰ名詞1 (液體的小滴) drop (of liquid) 2 (細小的痕跡) spot; dot; speck 3 (漢字的筆畫「、」)...
  • : fire
  • : 分Ⅰ名詞1. (成分) component 2. (職責和權利的限度) what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] (料想) judge
  • 點火 : 1 (挑起是非) stir up trouble 2 (點燃; 打火) ignite; light the fire; fire up; strike a light; ...
  1. When measuring the magneto performance parameter , we find that the instrument which use to measure voltage and current is still the simple voltmeter and amperemeter in the national standard , and the form of wave that we observed is anomaly. based on the measure principles, it obviously ca n ' t be used to do quantitative analysis ; because the discharge process of ignition system is quite complex, accompanies with very strong electromagnetism interference, and the ignition current and voltage are variable , it make the measure of ignition energy become a difficult thing of ignition system performance detection

    在磁電機常規測量時,發現在國家標準中用於測量電壓、電流的儀器仍然是普通的電壓、電流表,而觀測到的波形多為不規則的形狀,根據測量原理,顯然不能用其來做定量的析;由於系統的放電過程比較復雜,伴隨著很強的電磁干擾,電流、電壓都是變量,使得能量的測量成為系統性能測試的一個難
  2. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子,並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測;並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還析了傳感器和執行器典型故障波形。
  3. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比;通過提高壓縮比來彌補動力性的損失;以動力性為主控目標,對最大功率、最大扭矩、中等轉速、最低轉速所對應的發動機轉速做了特性的調節;通過空燃比的合理控制,直接改善發動機的動力性、經濟和排放指標;作為對缸內燃燒過程的理論析,進行了燃燒特性的實驗測試;對原汽油機和新開發的液化石油氣發動機,進行了外特性和部負荷特性以及怠速的排放及噪聲對比性測試。
  4. In this thesis, based on pershing ii surface to surface missile, a new kind of ballistic missile was designed with an additional rocket engine, which can be ignited twice. firstly, aerodynamic computational models of missile body and warhead which reentry with supersonic are built according to the task requirements ; secondly, the propulsion system model of missile is built whose first two stages are solid rocket engines and the third stage is liquid - solid combined rocket engine. the nozzle and the shape of the engine are designed to meet the needs of the populsion project ; thirdly, the trajectory model of the mass point is built and a wavy trajectory is designed & optimized ; finally, the ability of a missile ' s breaking through defence is analyzed

    以美國潘興導彈為原型,增加可兩次的末級發動機,改裝成具有跳躍能力的地地彈道導彈;首先,根據任務需求,建立了導彈的氣動模型,並建立了彈頭再入時高超聲速氣動模型;其次,建立了導彈推進系統模型,前兩級採用了固體箭發動機,第三級採用了固?液組合箭發動機,並在總體方案要求下,對發動機噴管和外形進行了設計;第三部,建立了導彈質彈道模型,設計了一條跳躍式彈道,並對跳躍式彈道進行了優化設計;最後,對導彈進行了突防能力析,從析的結果可以看出,跳躍式彈道的突防能力比常規的拋物線彈道要強。
  5. According to the " solid - particle " theoretical model, a theory model of the dynamic burning - velocity of a rocket - portfire in its igniting delay - time cannulation is established, a theory model of the dynamic delay - time is educed. the factors are analyzed, setting position and shape of a igniting delay - time cannulation that affect its igniting delay - time, the theoretical basis is offered to develop the high - level precision rocket - portfire in the air

    本文根據「固體粒子」效應理論,建立了延期管動態燃速數學模型,導出了延期管動態延時控制的理論計算模型,析了箭空中延期管的安裝位置及其形態對其延期時間的影響,為高精度箭空中具的工程研製提供了理論依據。
  6. In order to examine the south motorcycle engine preignition phenomenon, using the rich burning information of the massive ions which are produced when the air cylinder is burnt, through analyzing the wave form difference between lighting a fire normally and firing early, it can be determined whether preignition occurs or not

    為了檢測南方摩托車發動機早燃現象,利用其氣缸內燃燒時產生大量的離子電流信號所包含的豐富燃燒信息,對其花塞正常和熾熱離子電流顯示的波形進行研究析,從而確定是否發生早燃。
  7. Theoretical analysis and testing results demonstrated that viton, a new substitute of the former plasticizer, could noticeably improve its performances, which has been proved as the important improvements of the mixture. due to the favorable thermochemistry performance, dicyandiamide can act as a good combustion - rate regulator. the addition of antistatic agent can desirably increase the antistatic capability of the mixture, and the testing results showed that the performance of the improved mixture was excellent

    理論析和測試結果均表明了以氟橡膠取代耐水藥中原粘合劑將使藥劑的各項性能有明顯的改善,是耐水藥改進的重要方面;雙氰胺具有良好的熱化學特性,作為耐水藥改進中的燃燒速度調節劑具有很好的調速效果;抗靜電劑的加入,進一步提高了藥劑的抗靜電能力,測試析表明改進后藥劑的性能更加優異。
  8. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗析和研究表明,汽車空氣燃油加熱器在整個工作過程中,其排放存在以下三個問題:一、開機和關機兩個階段的排放問題嚴重,廢氣中hc和co的濃度值及煙度測量值都很高;二、因系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落;三、在過程中,會出現因操作不當而失效的現象。
  9. Appliances, solid fuels and firelighters for barbecueing - part 2 : barbecue charcoal and barbecue charcoal briquettes - requirements and test methods

    燒烤用器具固體燃料和器.第2部:燒烤木炭和燒烤木炭成型煤.要求和試驗方法
  10. Appliances, solid fuels and firelighters for barbecueing - part 2 : barbecue charcoal and barbecue charcoal briquettes - requirements and test methods ; german version en 1860 - 2 : 2005

    露天燒烤用器件固體燃料和器.第2部:烤肉用木
  11. Abstract : in the countersunk caseless cartridge, the burning at ignition allied to the matching of charge configuration

    文摘:埋頭無殼彈的、燃燒與裝藥結構的相互匹配有著十密切關系。
  12. With analyzing of the case study and based on simulating and analyzing quantitatively, this article, considering the goal of the performance - based fire - protection design is protecting occupants from being injured and keeping buildings from being damaged, thought that fire compartmentation of a large building of saling books can be divided according to their saling malls and fire compartmentation in the saling mall can be separated by the fire - proof screen. on the evacuation design, the quantity of safety exits around these buildings and the evacuation width should be increased if possible and the safety exit number, exit width and evacuation distance can be determined according to the simulating results on smoke layer temperature and height, concentration of co2 and co, occupants evacuation time and visibility. on the means of preventing and discharging smoke, the most proper measure should be determined according to their geometrical characteristics and the natural means of discharging smoke is feasible to the large building of saling books. based on analyzing of smoke

    通過對案例析研究,本文認為大型書城建築性能化防設計研究的最終目的是保證人員生命安全和保證建築結構安全,在模擬計算和量化析的基礎上,大型書城的防區可以將中庭連通的書城區域劃為一個區,在書城場地內可以採用防卷簾進行防區劃;在人員疏散設計中,應盡可能利用書城賣場的空間設計較多的安全出口和增大疏散寬度,其安全出口數量、寬度和疏散距離可以根據人員安全疏散時間和煙氣溫度、沉降高度、 co2濃度、 co濃度、能見度模擬計算結果驗證確定;在防排煙方式的選擇上,應當根據建築物的幾何特選取最適宜的措施,就大型書城建築而言,採用自然排煙的方式是可行的。
  13. Blackbird produces a pistol in reaction to my movement and fires several shots. the sounds the bullets make as they rip the air next to my ear give away the identity of his ammunition. cop - killers

    山鳥類生產對我的運動反應的一把手槍而且一些注射。聲音當他們撕開緊鄰我的耳朵空氣的時候,子彈發出送他的軍身份。警官-凶手。
  14. Das distributor advance solenoid

    電盤提前電磁閥
  15. Ess electronic spark selection

    離式電子
  16. Exactly speaking, the train will arrive at 9 : 15 a. m

    準確地說,車將於915到達。
  17. High tension connection for ignition coils and distributors

    線圈和點火分電器用高壓接頭
  18. Road vehicles. ignition coils and disributors. high - voltage connections

    道路車輛.線圈和點火分配器.高壓接頭
  19. Road materials. test method for the analysis of bituminous mixtures by ignition

    道路材料.點火分析瀝青混合物的試驗方法
  20. Ignition transformers with 6000v secondary. rotary ignition distributors with ignition stations from 8 to 40

    6000v輸出變壓器。旋轉點火分配器具有8到14個
分享友人