點腐蝕試驗 的英文怎麼說

中文拼音 [diǎnfǔshíshìyàn]
點腐蝕試驗 英文
pitting corrosion test
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  • 試驗 : trial; experiment; test
  1. It has low power and can defrost or heat in the refrigerator and expositing cabinet. both the ends of the heater adopt the imported resin glue and vulcanizate for seal ment and high ni - cr stainless steel as the case. it has good corrosive resisting performance and the insulation resistance is still more than 1000 after immersing in the water and being electrified for a long time

    本加熱器的特點為表面功率較小，在冰箱，展示櫃中起加熱化霜作用。電熱管兩端採用進口樹脂膠及硫化橡膠封口，外殼採用高鎳鉻不銹鋼，具有很好的耐腐蝕性能產品經長時間浸入水中通電試驗，其絕緣電阻仍1000m 。
  2. Because of its resistance to electrochemical erosion, low manpower demand for application and minimal changes in geometrical dimensions of the member, the method has been found to be economical and efficient for application, based on the previous work, we designed and conducted experiments of 10 reinforced concrete ( rc ) slabs strengthened with the common carbon fiber reinforced plastic ( cfrp ) ; and investigated the effect, failure mechanism and theory

    由於具有耐腐蝕、施工簡便快捷、幾乎不改變構件原有尺寸等特點，得到廣泛的應用，具有良好的經濟效益。在前人的工作基礎上，我們設計、試驗了10採用碳纖維布加固的鋼筋混凝土單向板，探討了加固單向板的加固效果和理論分析方法。
  3. Standard test methods for pitting and crevice corrosion resistance of stainless steels and related alloys by use of ferric chloride solution

    用氯化鐵溶液測定不銹鋼及有關合金耐點腐蝕和縫隙腐蝕的標準試驗方法
  4. X - ray diffraction spectrum, empa methods and several tests including mechanical properties, electrochemistry, corrosion wear, on - site plate hanging, the microstructure of steel has been observed and analyzed, performance has been studied, and corrosion - abrasion, fragility mechanism, and microalloy application in ferritic stainless steel have been explored comprehensively. the test results of electrochemistry, corrosion wear and on - site plate hanging have been analyzed. the analytical result shows that crsomo has enough corrosion resistance in phosphoric acid slurry because it has high chromium and low carbon

    通過實驗室的電化學試驗、腐蝕磨損試驗和磷肥廠的現場掛片試驗結果分析，表明： cr30mo鐵素體不銹鋼高鉻低碳的配合，保證其在磷酸料漿中具有足夠的耐蝕性： cr30mo中（ fe ， cr ） _ 23c _ 6 、 （ fe ， cr ） _ 7c _ 3 、 mo _ 2c 、等碳化物硬質點從基體的彌散沉澱析出可提高鋼的硬度和耐磨性，使得鋼在磷酸料漿中具有良好的耐磨蝕效果。
  5. Several key problems and their technical settlements were expounded emphatically, such as the accelerated corrosion test technique for aircraft structure under laboratory conditions, the evaluation technique for corrosion damage of anticorrosive coats, the distribution characteristics and their variation regularities of the corrosion damage and fatigue life, the corrosion equivalent relationship between the accelerated environment and the service environment, and the methods for theoretical analysis of the calendar life

    重點對腐蝕環境下飛機結構加速腐蝕試驗技術、防腐塗層腐蝕損傷評定技術、腐蝕損傷和疲勞壽命的分佈特性及其變化規律、腐蝕當量關系和日歷壽命理論分析方法等幾個關鍵問題及其技術途徑進行了闡述和探討。
  6. Insulating and sheathing materials of electric and optical cables - common test methods - part 5 - 1 : methods specific to filling compounds - drop - point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive compo

    電纜和光纜用絕緣和護套材料.通用試驗方法.第5 - 1部分:填充復合物的專用方法.滴點.油分離.較低溫脆性.總酸值.無腐蝕性成分. 23 ?時的電容率. 23 ?和100 ?時的直流電阻率
  7. Common test methods for insulating and sheathing materials of electric cables. part 5 : methods specific to filling compounds. section one : drop - point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 - d. c. resistivity at 23 and 100

    電纜絕緣和護套材料通用試驗方法第5部分:填充膏專用試驗方法第1節:滴點-油分離-低溫脆性-總酸值-腐蝕性- 23時的介電常數- 23和100時的直流電阻率
  8. Insulating and sheathing materials of electric and optical fibre cables - common test methods - methods specific to filling compounds - drop point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 c - d. c. resistivity at 23 c and 100 c

    電纜的絕緣和護套材料.通用試驗方法.填充復合物的專用方法.滴點.油分離.低溫脆性.總酸值.無腐蝕性成分. 23時的電容率. 23和100時的直流電阻率
  9. Common test methods for insulating and sheathing materials of electric cables ; part 5 : methods specific to filling compounds ; section one : drop point ; separation of oil ; lower temperature brittleness ; total acid number ; absence of corrosive components ; permittivity at 23 ; d. c. resistivity at 23 and 100

    電纜絕緣和護套材料的通用試驗方法.第5部分:填充復合物的專用方法.第1節:滴點油分離較低溫脆性總酸值無腐蝕性成分.在23時的電容率在23和100時的直流電阻率
  10. Common test methods for insulating and sheathing materials of electric cables - part 5 : methods specific to filling compounds - section 1 : drop point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 centigrade degrees - d. c. resistivity at 23 centigrade degrees and 100 centigrade degrees

    電纜絕緣和鎧裝材料的通用試驗方法.第5部分:填充復合物的專用方法.第1節:滴點.油分離.較低溫脆性.總酸數值.不腐蝕組分. 23下的電容率. 23和100下的直流電阻率
  11. Insulating and sheathing materials of electric and optical fibre cables - common test methods - part 5 : methods specific to filling compounds - section 1 : drop point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 oc d. c. resistivity at 23 oc and 100 oc

    電纜和光纜的絕緣和護套材料.通用試驗方法.第5部分:填充化合物的專用方法.第1節:滴點.油分離.較低溫脆性.總酸度數值.無腐蝕性成分. 23時的電容率和23與100時的直流電阻率
  12. Amendment 1 - insulating and sheathing materials of electric and optical cables - common test methods - part 5 - 1 : methods specific to filling compounds - drop point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 c - dc resistivity at 23 c and 100 c

    電纜和光纜用絕緣和護套材料.通用試驗方法.第5 - 1部分:填充復合物的專用方法.滴點.油分離.較低溫脆性.總酸值.無腐蝕性成分. 23時的介電常數. 23和100時的直流電阻率.修改件1
  13. Test of pitting corrosion resistance of stainless steels in the ferric chloride solution

    不銹鋼三氯化鐵點腐蝕試驗方法
  14. The working principle of pulsed eddy current ( pec ) nondestructive testing technology is analyzed, the pec testing system was been established to examined the specimen of multi - layered aircraft structure, peak and zero - crossing time of the time domain transient response signal of pec are extracted as the features to detect the corrosion in the second layer of aircraft structure quantificationally, the experiment results are consistent with that of the theory analysis, as the pec have the advantages of fast speed and quantification, this makes the method have the broad using foreground in the testing of aircraft structure corrosion

    摘要對脈沖渦流無損檢測技術的工作原理進行了分析，建立了脈沖渦流的檢測系統對加工的模擬飛機多層結構的試件進行了測試，提取其時域瞬態感應信號的峰值和過零時間作為特徵量，對出現在飛機多層結構第二層中的腐蝕缺陷進行了定量檢測，試驗結果和理論分析相一致，證明了脈沖渦流檢測方法的有效性，由於其具有快速和定量化的優點因而在飛機結構的腐蝕檢測中具有廣闊的應用前景。
  15. Which has high strength, good ductility, impact bearing, erode - bearing, besides, its linear expanding coefficient is almost equivalent to concrete, and it has excellent performance - price ratio etc. this paper is related to 8 rc - poles wrapped by gfrp ( sgfw430 ) and rc - poles are compressed axially, in order to analyze the influence of different stick layer over the pole ' s work performance and the influence between three type axial compress ratio ( 0, 0. 8, 1. 1 ) with one layer gfrp with the contrast poles about limit load - bearing capability, failure state, ductility, section stiffness, restrict losing owing to stress - difference

    其具有強度高，延性好；抗沖擊、耐腐蝕；線膨脹系數與混凝土接近；性能價格比高等多個特點。本文通過8根外包單向gfrp （ sgfw430 ）的rc組合柱，以及混凝土對比柱在軸心荷載作用下的試驗為基礎，具體詳細地分析柱子在粘貼不同層數的高性能玻璃纖維和在不同的軸壓比（ 0 、 0 . 8 、 1 . 1 ）下粘貼一層的高性能玻璃纖維后混凝土組合柱相對對比柱在極限承載能力、破壞形態、延性、截面剛度、應力差帶來的約束損失等方面的變化情況。
  16. Insulating and sheathing materials of electric and optical cables - common test methods - part 5 - 1 : methods specific to filling compounds - drop point - separation of oil - lower temperature brittleness - total acid number - absence of corrosive components - permittivity at 23 oc - d. c. resistivity at 23 oc and 100 oc

    電纜和光纜的絕緣和護套材料.通用試驗方法.第5 - 1部分:填充復合物的專用方法.滴點.油的分離.較低溫脆性.總酸值.無腐蝕性成分. 23時的介電常數. 23和100的直流電阻率
分享友人
分享到 Line

分享到臉書