adiabatic temperature 中文意思是什麼

adiabatic temperature 解釋
絕熱溫度
  • adiabatic : adj. 【物理學】絕熱的；不傳熱的。 an adiabatic curve 絕熱曲線。
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. In an adiabatic system, this heat release serves to increase the chamber temperature.

    在一絕熱系統中，放出的熱量增加了房間的溫度。
  2. The temperature rise at the center of a massive concrete wall is calculated by using the adiabatic rise of temperature and heat conduction equations of concrete based on the equivalent time, and considering effects of temperature on the hydration heat reaction ratio and creep characteristics of early - age concrete

    摘要基於等效時間的混凝土絕熱溫升、熱傳導方程，考慮溫度對早期混凝土水化熱化學反應速率和徐變特性的影響，計算了大體積混凝土墻中心的溫升。
  3. Two temperature on the kelvin scale are to each other as the heats trasnferred between the same two reversible adiabatic surfaces at these two temperatures

    上式說明凱式溫度的定義是與在等溫面上一等溫過程由一可逆絕熱面轉換至令一個可逆絕熱面所吸收之熱量有關。由此定義的凱式溫標與物質的特性無關。
  4. Perlite is lava of acid volcanic glass ; there is certain combo water in it. can be swselled in high temperature, it is a main ore source to make adiabatic materials with high quality and super light

    珍珠巖是酸性火山玻璃質熔巖，其中含有一定量的結合水，在高溫下迅速膨脹，是製作優質超輕絕熱材料的主要礦石資源。
  5. Adiabatic compression temperature

    絕熱壓縮溫度
  6. Adiabatic condensation temperature

    絕熱冷凝溫度
  7. The change of adiabatic temperature rise along with age and the effect on temperature field of dam body made by pouring lift by lift, work suspension in summer and water storage are considered in the analysis

    分析中考慮了混凝土的絕熱溫升隨齡期的變化和分層澆築、夏季停工及蓄水對壩體溫度場的影響。
  8. Adiabatic recovery temperature

    絕熱恢復溫度
  9. Aft adiabatic flame temperature

    絕熱火焰溫度
  10. Adiabatic flame temperature

    絕熱火焰溫度
  11. Adiabatic temperature rise

    絕熱溫升
  12. Plastics - phenolic resins - determination of the pseudo - adiabatic temperature rise of liquid resols when cured under acid conditions

    塑料.酚醛樹脂.測定可溶酚醛樹脂在酸性條件下凝固時假絕熱溫升
  13. Also the correcting rules of three kinds of common adiabatic temperature rise of concrete were researched. 2

    並對三種常用混凝土絕熱溫升計算公式的修正規律及時間步長與精度的關系等問題進行了研究。
  14. In this paper, referring to qingju water power station, temperature control analysis and study has been done : study on the match ratio of the concrete and question of modifying of the special fine sand concrete to improve resisting ability of splitting of concrete ; study on the technology of the highly mixed fly ash to reduce the adiabatic temperature rise of concrete ; in case of the condition of resisting splitting to allow, study on the temperature control measure to strengthen and water the size of building, simplify the operational procedure, accelerate the construction speed, economize the expenses of the project

    溫控問題成為青居水電站設計和施工的關鍵技術問題。 、本文對水工大體積混凝土溫控問題進行了分析和總結，結合青居水電站閘壩工程，開展溫度應力及溫度控制研究:研究混凝土的配合比及特細砂混凝土『改性問題，提高混凝土的抗裂能力;研究高摻粉煤灰技術，降低混凝土的絕熱溫升:在抗裂條件允許的情況下，研究施工過程中溫控措施的簡化，以加大澆築尺寸，簡化施工程序，加快施工進度，節約工程費用。
  15. En iso 9771 plastics. phenolic resins. determination of the pseudo - adiabatic temperature rise of liquid resols when cured under acid conditions

    塑料.酚醛樹脂.測定可溶酚醛樹脂在酸性條件下的反應性
  16. Adiabatic temperature probe

    絕熱溫度傳感器
  17. Adiabatic temperature change

    絕熱溫度變化
  18. According to the thermodynamics theories, reaction free energy and adiabatic temperature in zro2 - b _ 2o _ 3 - mg system have been theoretically calculated and analyzed. results of adiabatic temperature calculation showed that the adiabatic temperature of zro2 - b _ 2o _ 3 - mg system without diluent was 3093k, and it reduced with improvement of diluent content. when the diluent mgo content was 0 ~ 45 %, or the diluent zrbb2 content was 0 ~ 62 % the shs process would occer

    絕熱溫度計算表明:稀釋劑含量為零時， zro _ 2 - b _ 2o _ 3 - mg體系的絕熱溫度tad為3093k ，隨著稀釋劑含量的增加絕熱溫度呈現逐漸降低的趨勢，得出了稀釋劑mgo含量在0 45 % ，稀釋劑zrb2含量在0 62 %之間的所有組分的體系均有足夠的熱量來完成燃燒合成反應的結論。
  19. The experimental results show that in situ reaction between several oxides and al balances adiabatic temperature and controls the drastic reaction between cuo and al. at the same time, this kind of in situ reaction also accelerates the other replacement reactions and makes them react till to the end

    實驗結果表明採用多種氧化物原位反應法合理調配了不同反應的絕熱溫度，控制了cuo與al劇烈的鋁熱反應，同時促進了其它單質氧化物與al反應，使其能自我維持進行下去。
  20. When the difference method is used to solve temperature problem, the error of adiabatic temperature rise of concrete is often caused by a difference step that is too big, at the same time computation workload increases greatly because of a difference step that is too small. based on the basic characteristics of the difference method, this paper introduced one kind of correcting method, which can assure solution precision but does n ' t increase the calculating workload

    針對差分法進行不穩定溫度場求解時，差分步長過大會造成絕熱溫升計算誤差加大，差分步長過小又會引起計算量成倍增長的問題，根據差分法求解的基本特點，提出了一種誤差修正方法，在計算量得到成倍提高的同時，保證了求解精度，較好的解決了這一問題。
分享友人
分享到 Line

分享到臉書