air exhaust pipe 中文意思是什麼

air exhaust pipe 解釋
排氣管
  • air : n 1 空氣，大氣。2 天空，空中。3 微風，和風。4 態度，樣子，風度，氣派；〈pl 〉高傲的架子。5 傳播，...
  • exhaust : vt 1 用盡，耗盡（資源等）。2 排出（空氣），抽空，空出（容器等）；汲干。3 提盡（可溶解的物質）。4 ...
  • pipe : n 1 管，導管，筒。2 煙斗，煙袋；一袋煙。3 〈古語〉笛，管樂器；【航海】（水手長的）哨子（聲）；〈p...
  1. Takes several energy saving measures for air conditioning system, nick a large capacity centrifugal chillers working with variable frequency nil capacity chillers, variable frequency and variable flow control on secondary pump water systems, cooling tower for four - pipe water system in winter, fan - coil unit for commercial peripheral zones aid all - air systems for interior zones, variable frequency control on supply and exhaust air fain, enthalpy control on fresh air cooling in winter and intermediate season

    採用了多項空調節能措施：大冷量離心冷水機組搭配變頻小冷量機組，二次泵變頻變流量空調水系統，四管制風機盤管冬季用冷卻塔換冷供冷設計，商業外區風機盤管、內區全空氣空調系統，送風機、排風機變頻控制，過渡季、冬季利用室外新風通風降溫的焓值控制設計。
  2. For intake system, adopting the resonant intake manifold construction, make use of the intake motive effect to increase volumetric efficiency ; adopt measure to prevent the heat transmit between intake pipe and exhaust pipe, lower the intake air temperature to increase volumetric efficiency

    對于進氣系統，採取諧振進氣的結構措施，利用進氣動力效應來提高進氣充量；採取進、排氣管隔熱措施，降低進氣溫度來提高進氣充量。
  3. At hot end of beat pipe, several measures were taken to eliminate heat, namely ( 1 ) traditional sensible heat elimination ; ( 2 ) exhaust air is processed by air washer, then passes through hot end ; ( 3 ) exhaust air is handled by wet film, then passes through hot end ; ( 4 ) sprays water at the top of hot end, respectively

    第一級採用熱管式間接蒸發冷卻器，熱端布置4種散熱方式： （ 1 ）傳統類型的顯熱散熱； （ 2 ）排風經過噴水室降溫后進入熱端； （ 3 ）排風經過填料式直接蒸發冷卻器降溫后進入熱端； （ 4 ）直接在熱端頂部淋水。
  4. Air filtration portfolio, air filters, valve, oil mist machine, filter valve, oil mist separator, micro - mist separator, stability activated solenoid valve, pressure gauge, micro - valve and vacuum valves, links the release of the closure - pressure valves, and pipe connection, a one - way valve, t - shelves, shelves, brackets, diaphragm - type flow switches, blades type flow switches, further growth actuator, the valve lock, precision valve, pressure switches, mechanical pressure switches, pneumatic control ratio positioning devices, and electric - gas ratio positioning devices, and telecommunications - pressure converters, electro - pneumatic proportional valve, filter valve, shuttle valve, gas - electric relay and gas indicator, delay pneumatic valve and cylinder fcl, plumbing fcl, mufflers and exhaust cleaner, the excess flow valve with silencer, a one - way valve, rapid valve, rapid joints, rapid valve with fcl, rapid joint sub - cluster gas, micro joints, gas pipes, pipe from the devices, and helical coils, pipes, channels, scissors, multiple fastener, high - speed rotary joint, 10000 threaded joints, and insert the tube joints, rotary joints began, 68. 25 rapid joints and hoses, hose fittings and rapid non - electrostatic

    空氣過濾組合空氣過濾器減壓閥油霧器過濾減壓閥油霧分離器微霧分離器穩定啟動電磁閥壓力表微型減壓閥減壓氣閥三通釋放式截流閥壓力開關管接頭單向閥t型隔板隔板托架膜片型流量開關漿葉型流量開關增速繼動器鎖定閥精密減壓閥壓力開關機械式壓力開關氣控比例定位器電-氣比例定位器電訊號-氣壓轉換器電-氣比例閥過濾減壓閥梭動閥氣-電繼電器氣源指示器氣動延時閥氣缸限流器管道限流器消聲器排氣潔凈器限流閥帶消聲器單向止回閥快速排氣閥快速接頭快速排氣閥帶限流器快速接頭集束分氣微型接頭氣喉管喉管脫離器螺旋管排管管道剪刀多管扣件高速旋轉接頭萬用螺紋接頭插入式管接頭旋式緊鎖接頭難燃性快速接頭和軟管不帶靜電快速接頭和軟管
  5. Exhaust gas oxygen sensor ( ego ) which is installed in the exhaust pipe of the engine is a significant component in the electronic fuel injection. it has the ability to probe the concentration of oxygen in the exhaust pipe, and can transfer concentration signal to voltage signal which is passed to electronic control unit ( ecu ). in this way the air - fuel ratio can be controlled to the strait range of stoichiometrical point and the three - way catalytic converter consequently can work better

    車用氧傳感器是電噴系統的關鍵部件，安裝在發動機的排氣管上，能夠探測排氣管中的氧氣的濃度，然後將濃度信號轉變成電壓信號並傳送給電控單元ecu ，從而把空燃比控制在理論空燃比附近，配合三元催化反應器進行后處理凈化。
  6. The deficient mill output has been finally resolved by two renovation programs for the classifier and the central air pipe of d - 12 - d double - in and double - out mill, one of the biggest pulverizes ; higher ah inlet gas temperature and exhaust gas temperature also rectified by refractory modification and the tuning of sootblower " s running mode

    對世界最大的d - 12 - d雙進雙出磨煤機的分離器和磨煤機中心風管等部位通過兩種方案的改造試驗最終解決了該磨煤機的出力不足問題；通過對衛燃帶改造和調整吹灰器的運行方式解決了空預器入口煙溫和排煙溫度高的問題。
  7. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  8. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  9. Heat pipe and evaporative cooling technology were combined to recover energy of central exhaust air

    摘要提出了用於暖通空調領域新、排風能量回收的熱管式兩級蒸發冷卻空調系統。
  10. After exhaust pipe and fan system are modified, the total loudness is reduced from 11. 5 to 9. 6 sone, the fluctuation strength and sharpness are reduced. at the end of this paper, a standard of subjective and objected evaluation method of room air - conditioner is also offered

    此外，在文章結尾，作者在對現有空調器進行大量噪聲測試和總結的基礎上，首次提出了《房間空氣調節器聲質量主、客觀評價規范》 ，並在生產中進行實際應用。
分享友人
分享到 Line

分享到臉書