air gap flux density 中文意思是什麼

air gap flux density 解釋
氣隙磁通密度
  • air : n 1 空氣，大氣。2 天空，空中。3 微風，和風。4 態度，樣子，風度，氣派；〈pl 〉高傲的架子。5 傳播，...
  • gap : n 1 （墻壁、籬笆等的）裂口，裂縫；豁口，缺口。 【軍事】突破口。2 （意見的）齟齬，分歧；隔閡，距離...
  • flux : n 1 流，流出；流動。2 漲潮。3 不斷的變動，波動。4 【物理學】流量，通量，電通量，磁通量。5 熔解，...
  • density : n. 1. 稠密；濃厚。2. 【物理學】濃度；密度；比重。3. 愚鈍，昏庸。
  1. Due to 12 / 8 poles doubly salient permanent magnet motor, planar finite element method ( fea ) is applied to analyze the magnetic field inside the motor. and a series of static characteristics are investigated, such as field distribution, air gap magnetic density, field flux, inductance, static torque

    針對12 / 8極永磁式雙凸極電機，採用二維平面有限元法對電機內磁場進行分析計算，研究了電機磁場分佈、氣隙磁密、繞組磁鏈、繞組電感、靜態轉矩等一系列電機靜態特性。
  2. Firstly, the dissertation has analyzed the relationship between electromagnetic force and air gap, and obtained fitting formula of force and flux density using computed results

    本文首先分析了電磁力與懸浮氣隙磁場之間的關系，並利用計算結果得出了懸浮力與氣隙磁通密度的擬合公式。
  3. In order to realize flux feedback control, the request of air gap flux density measurement is studied. using the 3d magnetic field analysis software, how and where to install the magnetic field sensors have been discussed. then two magnetic fields measuring methods have been chosen : the hall effects measurement and the electromagnetic induction method

    為實現磁通反饋控制，分析了懸浮磁場對磁通密度測量的要求，利用三維磁場分析軟體對磁場測量元件的安裝方式與安裝位置進行了分析，選擇了兩種磁場測量方法:霍爾效應法與電磁感應法，並分別設計了測量及信號放大、濾波電路，實現了懸浮磁場的測量。
  4. In single magnet modeling, from the air gap magnetic - flux density, single magnet linear model which take the flux density as the state variable is obtained, and used the fitting formula which the magnetic field analysis had obtained to revise the model parameters

    在對單鐵的建模中，從氣隙磁通密度的角度出發，得到了以磁通密度為狀態變量的單鐵線性模型，並採用磁場分析得出的擬合公式修正了模型參數。
  5. The motor ' s magnetic field is analyzed with finite element method ( fem ) by ansys software. the emf and electro - magnetic torque are calculated with path method base on the air gap magnetic flux density ( b )

    運用有限元分析軟體ansys對電機內部磁場進行模擬分析，得出電機內部磁場磁密及磁場強度分佈情況，在此基礎上運用路徑法對電樞反電動勢、電磁轉矩等電磁參數進行了分析計算。
  6. Next, consulting current feedback control, the flux feedback control algorithm is designed. this algorithm has two loops, the inner loop is flux feedback loop, the outer one is air gap feedback loop ; the outer loop uses pid controller whose output is expected flux density, the inner uses the proportional or pi controller whose output is the magnet control voltage

    其次，參照電流環控制的串級思想，設計出了基於磁通反饋的懸浮控制演算法，該演算法也採用雙環控制，內環為磁通環，外環為位置環;外環採用pid控制器，輸出為期望磁通密度，內環採用比例或比例積分控制器，輸出為電磁鐵控制電壓。
分享友人
分享到 Line

分享到臉書