air supply method 中文意思是什麼
air supply method
解釋
送風方式-
In this paper, the standard three - dimensional k - two - equation turbulence model which modifies the item of buoyant effect and simple algorithm are adopted, wall functions are used to deal with the boundary condition and a simplified method - box method is used to model the supply air boundary condition
本文數值計算採用經過浮升力項修正的k -兩方程模型和simple演算法，壁面邊界條件採用標準壁面函數，風口邊界條件採用盒子方法。廠房內的氣流運動主要受風口出流動量的制約，因此選擇合理描述入流邊界條件的風口模型對數值模擬至關重要。 -
In this article, simulations of air distribution in the vav air - conditioned office are carried out in the cases of different air - supplying diffusers including slot diffuser, sqaure grille, bar grille and square diffuser to supply air, the standard three - dimensional k - ? two - equation turbulence model with correctional item of buoyancy effect and simple algorithm are adopted, and wall function method is used to handle boundary conditions
本文採用經過浮升力項修正的-兩方程模型和simple演算法，應用壁面函數法處理邊界條件，對利用包括條縫風口、方型百葉風口、長條型百葉風口和方型散流器不同型式送風口送風的變風量空調房間內的氣流組織進行了模擬。 -
Standard test method for effect of air supply on smoke density in flue gases from burning distillate fuels
空氣供給對燃料餾分燃燒產生的煙道氣中煙密度影響的標準試驗方法 -
Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion
確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。 -
Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion
確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變；實驗臺的流量測量採用風機動力性能測試標準中流量方法等。 -
According to thermal state similitude model experiment of the langya mountain hydropower station, we adopt different velocity of air ventilation and exclude air proportion of upriver and downriver, this paper contrast the air distribution of the dynamo floor on each method, and educe the best projects of arch crest supply air that adapt to langya mountain hydropower station ’ s dynamo floor : g = 17. 4 10 ~ 4m ~ 3 / h, 22 vents, d = 600mm, the scale of volume 1 : 3, t0 = 16. 9. it ’ s also thought that improved any side of volume can reduce its temperature. when study on the air supply of langya mountain hydropower station ’ s underground dynamo floor by cfd software, it proved that cfd software is correct when compare with model experiment. when arrange the number of 5 kinds of vents, it concluded that the number of vents 14 to 22, it can ’ t change velocity, in 36 to 40 can lead to reduction of velocity. when vent in 14 to 36, the parameter kt doesn ’ t change, when the number is as large as 36, kt reduces
在此基礎上，模擬了5種風口布置方案和送風量的改變對發電機層溫度場和速度場的影響，獲得了些可供參考的結論:在風量和送風速度不變的條件下，風口個數在（ 14 ~ 22 ）小范圍變化時，工作區平均風速基本不變，大幅度增加風口個數（ 36 ~ 44 ）就會導致工作區平均風速的降低，風口數在14 ~ 36之間對工作區的溫度不均勻系數影響不大，當風口數> 36時，溫度不均勻系數隨著風口數的增多而變小，速度不均勻系數一直隨著風口數的增加而減少;在風口布置和尺寸不變的情況下，送風量變化時，工作區平均溫度隨送風量增大而降低，平均溫度的降低量逐漸趨于減少，能量利用系數先是隨著送風量的增加而增大，后隨送風量增加而減少。 -
Abstract : introduces a method to eliminate influence of power supply and air - feed system on exact measurement of micro - thrust of electric rocket in the gravity field, so micro - thrust can be measured accuratelg and automatically
文摘:介紹了在重力場中，消除電火箭自重及其供電供氣系統對微小推力測量影響的方法，從而實現電火箭微小推力自動準確的測量。 -
There is no thoroughly rounded theory about displacement ventilation system in our country at present and our research begins recently. the study work of this paper will be useful for further optimization design of displacement ventilation system. this dissertation includes five parts. the first part introduces the development of the displacement ventilation and the background of research in domestic and oversea. in the second part, it gives working principle of displacement ventilation system and it ’ s advantages to the mixture ventilation. the study also gives a series of indexes to evaluate displacement ventilation system and specifies air supply terminal device and so on. it is needed to simulate and analyse the velocity field, temperature field and distribution of flow field. this is the third part. the forth part specifies the simulative method for thermal stratification of displacement ventilation system. it gives some factors affecting thermal stratification height such as inlet temperature, inlet velocity, heat transfer of wall body, distance of heat source and so on
本文的研究工作主要包括以下幾個方面的內容: （ 1 ）綜述了國內外相關的研究現狀和研究背景; （ 2 ）簡介了置換通風的工作原理，並分析了它相對于混合通風的優良特性及評價指標、末端裝置等; （ 3 ）對採用置換通風方式房間的溫度場、速度場和氣流分佈進行了模擬計算與分析; （ 4 ）對採用置換通風方式房間的熱力分層高度進行了模擬計算，並分析其影響因素，如:送風溫度、送風速度、圍護結構傳熱和熱源分佈等; （ 5 ）擬合了無量綱熱力分層高度相應于送風溫度t 、送風速度v 、熱源間距離l和圍護結構傳熱q的經驗公式。 -
The paper studies the static pressure control and minimum total supply air volume control of vav air - conditioning system by experiment at present vav air - conditioning system are all modelled by the method of mechanism analysis
本論文對變風量空調系統中的定靜壓控制和最小總送風量控制進行實驗研究。 -
The article bases on the simulation computation and makes a contrast between the energy consume and comfort of rooms with different air supply method
本文基於模擬計算，對標準客房採用不同送風送風方式的節能性和舒適性進行了對比。
分享友人