amorphous state 中文意思是什麼
amorphous state
解釋
非晶態-
Magnetic properties of nanocrystalline two - phase permanent magnetic alloys by crystallizing from amorphous state
非晶晶化法制備納米晶雙相永磁合金的磁性 -
The xrd and ft - ir patterns show that the powder was transformed from amorphous to crystalline state with the increasing of urea. synthesis of ca, ca : yag powder by the mixed method was investigated
通過xrd和紅外透射光譜的研究表明，隨著原料中燃燒劑尿素含量的升高，所得粉體由無定形態逐漸轉變成結晶態。 -
In this pcm, polyethylene glycol ( peg ) has been taken as functional branches, with which the energy storage and energy release can be proceeded by phase transition between its crystal state and amorphous state
利用聚乙二醇從結晶態到無定形態之間的轉變，實現該材料的儲能和釋能，整個過程中材料始終保持為固體。 -
For the powder milled to amorphous state, because of its very fine structure, it is easy to occur phase transformation and has good size stability when sintered
研磨到非晶態的粉末由於元素達到原子尺度混合，大大縮短了擴散距離，不僅易於發生固態相變，而且燒結體尺寸穩定性好。 -
Peo can be completely intercalated into the interlayer of v2o5 xerogel in form of amorphous state at x = 0. 5, whereas partial peo can not be intercalated into v2os xerogel interlayer and exists outside of v2o5 xerogel interlayer in form of crystalline state at x = l, 2
當x為0 . 5時， peo的嵌入較完全，在層間以非晶態形式存在；當x = 1 、 2時，部分peo未能嵌入氧化物干凝膠層間而存在於其主體之外，以晶態形式存在。 -
Peo can be completely intercalated into the interlayer of v2o5 - moo3 xerogel in form of amorphous state at x 1, whereas partial peo can not be intercalated into v2o5 - moo3 xerogel interlayer and exists outside of v2o5 - moo3 xerogel interlayer in form of crystalline state at x = 2
當x約為1時， peo的嵌入較完全，在層間以非晶態形式存在；當x = 2時，部分peo未能嵌入氧化物干凝膠層間而存在於其主體之外，以晶態形式存在。 -
Compared with different inducing methods by lots of experiments, a simple and effective inducing method is confirmed, the opimal technological conditions and formula about the soluton of electroless deposition ni - p alloy are also obtaned. the influence of different technological parameters on the deposition rate is studied. analyzed the pefformance of ni - p alloy on the differen substfates and its corresponding tricture, the result is shown tha the electroless plating nickel process can obtained the ni - p alloy film having brightuess - integrity sdse, strong binding energy and high rigidity at the temperatur about 350wt00oc, the electroless plating nickel film would trallsform from amorphous to crystal state
本文通過大量實驗，對幾種誘發材料與過程進行分析，研究確定了簡便有效的誘發方法，以及與之相匹配的化學鍍ni - p合金溶液優化配方和工藝條件，討論了各工藝參數對鍍速的影響，並對銅及黃銅基體上得到的ni - p沉積層進行了性能和結構分析，得到外觀光亮完整、結合力強、硬度高的鍍層。 -
While discussing the different electrochromic properties of these films, the effect of annealing on the microstructure of films was found. it was clarified that why amorphous tungsten oxide film, crystalline nickel oxide and tungsten oxide films with different crystallization exhibited different electrochromic capabilities. the semisolid - state smart window was encapsulated on the basis of the electrochromic tungsten oxide and nickel oxide films mat were obtained from the initial researches and showed the best electrochromic performances
在研究薄膜所呈現出的不同電致變色性能的同時，揭示了熱處理對薄膜微觀結構的影響，分析了導致非晶態與不同結晶度情況下氧化鎢薄膜電致變色性能差異的原因，以及不同結晶度情況時氧化鎳薄膜電致變色性能變化的規律和微觀機理。 -
The results indicated that tbco films prepared by magnetron sputtering were in amorphous state, while cr underlayers were in polycrystalline state
用磁控濺射制備的tbco薄膜為非晶態， cr底層為多晶態。 -
The dependence between the ratio of znso4 / ( znso4 + feso4 ) in solution and the deposits microhardness was studied. lt showed that amorphous state deposit had higher value
隨后研究了鍍層的顯微硬度隨鍍液中znso4 （ znso4 + feso4比值的關系，結果表明，鍍層為非晶態時，顯微硬度最高。 -
Abstract : the influence of re - addition way and sintering temperature on such physical and chemical characteristics as the ability of enameling glaze has been investigated in this paper. and the research has shown that the structure of glaze will be transformed from amorphous state into crystalline state and the grains will be refined while the sintering temperature and re content are increased
文摘:本文研究了在瓷釉中加入稀土的方式、燒結溫度對瓷釉的塗搪性等物理性能以及化學性能的影響，並發現，隨著燒結溫度和稀土含量的增加，瓷層結構由非晶態向晶態轉變，晶粒細化。
分享友人