amplifier noise 中文意思是什麼

amplifier noise 解釋
放大齊聲
  • amplifier : n. 1. 【電學】擴大器；擴音器。2. 放大鏡；放大器。
  • noise : n 1 聲音，聲響。2 叫喊；嘈雜聲，噪音；喧鬧聲；吵鬧，騷動，騷擾。3 〈古語〉謠言，風聲。4 〈美國〉...
  1. Design of microwave ultra - broad band low noise amplifier

    微波超寬帶低噪聲放大器的設計
  2. In the forth chapter the series negative feedback and interstage mismatching are presentation, and a low noise amplifier whose operating frequency is 1. 5ghz 1. 8ghz is developed

    第四章詳細介紹了源極串聯負反饋和級間失配法，並設計和製作了1 . 5ghz 1 . 8ghz低噪聲放大器。
  3. Research of noise properties of fiber raman amplifier

    光纖拉曼放大器噪聲特性的研究
  4. Low noise amplifier ( lna ) is widely used in front end of a received set of mobile communication 、 wireless radio 、 blueteech technology and so on 。 the active device is the core of the circuit and has significant effects on the whole equipment, therefore, the design of the active device is vital in lna

    微波低噪聲放大器（ lna ）廣泛應用於移動通訊、無線電、藍牙技術等的rf前端。 lna中的有源器件是整個電路的核心，對整個放大器電路的性能有著重要的影響，因此有源器件的設計是lna的關鍵技術之一。
  5. Chapter 5 is about the design of millimeter wave solid circuit included frequency multiplier, low noise amplifier, medium power amplifier, mixer, if amplifier lastly, based on the work above, a millimeter wave t / r module is developed and the analysis of the result is also introduced

    第五章毫米波固態電路，詳細分析了毫米波倍頻器、低噪聲放大器、毫米波放大器、混頻器的理論，製作了毫米波混頻器、毫米波放大器、中頻放大器、倍頻器等有源電路。最後，在上述基礎上製作了毫米波t / r組件。
  6. It is important to connect the transducer and amplifier by a low-capacitance, low-noise, coaxied cable.

    傳感器和放大器之間的聯結採用低容抗，低噪音的同軸電纜是很重要的。
  7. By utilizing the comb - like reflection spectrum of a hi - bi fiber loop mirror to suppress the ase ( amplified spontaneous emission ) of a double - pass edfa, the noise figure of this amplifier is much improved

    利用雙折射環鏡的梳狀反射特性抑制雙通edfa的ase ，從而使放大器的噪聲性能得到了明顯改善。
  8. Microwave assembly detail specification for model wfb2002 low noise amplifier

    微波組件. wfb2002型低噪聲放大器詳細規范
  9. The measure module has bigger signal - to - noise ratio because adopting instrumentation amplifier, programmable gain amplifier and accumulate measurement

    信號檢測模塊採用儀表放大、程式控制增益放大、積累檢測方式等措施有效地提高了測量系統的信噪比。
  10. Then we introduce the character of the atmosphere channel, which we emphasized on the atmosphere scatter, absorption and scintillation ' s effect on the laser beam. in chapter, we explain why we used cassegrain telescope to collect the optical signal at first, then the lightsource, detector, front amplifier used in optical communication has been compared to that of fiber communication, the noise including shot noise, thermal noise and background light noise has been explained here for analysis the snr and ber in the next section

    在第三章介紹無線光接入系統的光收發單元，採用多孔徑卡塞格倫式的收發天線對消除減小大氣湍流影響有較大作用，針對大氣通道的特點無線光系統收發單元在光源、光探測器、前置放大電路上存在許多有別于光纖通信的技術，同時還闡述了光接收機包括背景噪聲的噪聲機制和接收靈敏度、誤碼率等指標，最後給出了一個整個傳送鏈路的功率預算。
  11. So, we designed a fully integrated low noise amplifier ( lna ) for 2. 4ghz rf front - end receiver on satellite

    針對此，本論文完成了一個2 . 4ghz衛星射頻前端接收電路的全集成差分cmos低噪聲放大器（ lownoiseamplifier ）的設計。
  12. Based on the analysis of transistor amplifier noise model, we select devices with low noise in reason. and the method how to reduce phase noise and phase jitter is also discussed

    依據晶體管放大器的噪聲模型分析合理選擇了低噪聲的元器件，對降低相位噪聲和相位抖動的方法作了一些探討。
  13. The design of the amplifier is described in detail and the noise in the circuit is calculated in the third chapter. several demodulating methods are compared and the design of the demodulator is described in detail in the fourth chapter

    第四章，對幾種信號解調方式進行了比較，並對系統採用信號解調電路的設計原理和方案進行了詳盡的分析。
  14. Because power management in this thesis aims at amplified spontaneous emission noise of erbium ? oped fiber amplifier ( edfa ), the thesis introduces the simplified stark ? split energy levels of er3 ", amplified working mechanisms of er3 * and working performance of edfa in details

    因為本文所採用的功率管理主要是針對edfa摻餌光纖放大器所產生的自發輻射噪聲去採取均衡措施，所以論文中詳細介紹了edfa中鉺離子的stark分裂的簡化的能級模型、鉺離子的放大工作機理及edfa的工作特性。
  15. Because of the using of interpolation, noise shaping and switching amplification in the digital audio amplifier technology, the power supply modulator is not only much efficient but also behaving good in envelope amplification, this advantage is hard to implemented with conventional technology

    數字音頻功放技術是近年發展起來的高效率音頻放大技術，該放大技術採用了過取樣、噪聲整形等數字音頻處理演算法和開關功率放大。採用該技術實現的電源調制器不但具備很高的效率，而且能高指標地放大包絡信號，是常規的電源調制技術無法實現的。
  16. In order to obtain high resolution of the instrument, the effect of input noise of amplifier must be decreased. hereby, an amplifier circuit based on the chopping theory was developed for it

    由於該微摩擦測試儀要求的分辨力很高，而運算放大器本身的輸入噪聲嚴重影響系統的解析度，為此設計完成了基於斬波放大原理的放大電路。
  17. Forward spontaneous raman scatter noise in the fiber raman amplifier

    光纖拉曼放大器中的前向自發拉曼散射噪聲
  18. Based on our theoretical predictions, we find optimal splicing parameters on fsm - 30s fiber splicer for low loss joints between erbium doped fiber and other single mode fibers. we also experimentally demonstrate a novel three - stage erbium - doped fiber amplifier with high gain, low noise figure, and high output power. finally, a prototype of a gain - clamped fiber amplifier is obtained with high gain ( 26 db ), low noise figure ( 5. 3 db ), high output power ( 17 dbm ), and large bandwidth ( 31 nm )

    文章研究了摻鉺光纖（ edf ）與其他光纖低損耗焊接問題，得到光纖熔接機低損耗熔接的最佳參數，這對摻鉺光纖放大器的科研生產具有一定的指導意義；研究了新型的三段級聯泵浦優配的摻鉺光纖放大器的優化光路結構，得到高增益，低噪聲，大輸出功率的摻鉺光纖放大器；最後研製成功高增益（ 26db ） ，低噪聲（ 5 . 3db ） ，大輸出功率（ 17dbm ） ，寬帶（ 31nm ）增益箝制摻鉺光纖放大器樣機。
  19. In order to measure the characteristics of such semiconductor optical amplifier, we adopted a set of measurement system. this measurement system can be used to measure the characteristics of all kinds of active or inactive optical passive components. such device presents good polarization insensitivity ( < 0. 9db ), wide 3db bandwidth ( > 33nm ) at 0 - 200ma and different input signal light wavelength and power, the maximum fiber - to - fiber gain of 10db, lossless operation current of 50 - 75ma for different input signal light wavelength and power, large extinction ratio ( > 50db ) and lower noise figure ( nf ) ( < 8db )

    與張瑞英博士一起，首次利用該種有源區結構制備出偏振不靈敏半導體光放大器，並在0 - 200ma注入電流范圍內獲得33nm的3db帶寬，在不同信號波長，不同信號功率0 - 200ma的注入電流范圍內，偏振相關損耗均《 0 . 9db ，在耦合差損為7db / facet的條件下，最大fiber - to - fiher增益達10db ，無損操作電流為50 - 70ma ，消光比達50db以上，而噪聲指數則低於8db ，最小可達4 . 6db 。
  20. The article analyzes background noise, amplifier noise and detector noise in detail from fixed character of infrared dim - small target image, also processes the infrared image and separates targets from the image

    文章主要對紅外弱小目標圖像中的背景輻射噪聲、放大器噪聲、探測器噪聲進行了詳細的定性分析，並對紅外圖像進行處理，從圖像中分離出了弱小目標。
分享友人
分享到 Line

分享到臉書