angular displacement 中文意思是什麼

angular displacement 解釋
角加速度傳感器
  • angular : adj. 1. 有角的，角形的；尖銳的。2. 用角度量的；角的。3. 瘦骨嶙峋的。4. 不靈活的，生硬的。adv. -ly
  • displacement : n 1 轉位，移動；取代，置換；（人的）流離失所。2 撤換，免職。3 【機械工程】（活塞）排氣量；【航海...
  1. The radome causes an angular displacement of the tracking aerial polar diagram.

    天線罩使跟蹤天線的極圖產生了角位移。
  2. This requires a servo follow-up system to keep the operating angular displacement between gimbal and case down to acceptable low limits.

    這就需要有一隨動系統使框架與殼體間的工作角位移保持在滿意的小范圍之內。
  3. The former includes air - bearing table system, rolling base driving system, angular displacement sensing system, and two foldable flexible plates with piezoelectric patches bonded ; the latter includes sensing signal processing and actuation signal generating circuits, and computer system composed of pc and two tms320f240

    整個控制系統的處理器是一個由兩塊tms320f240和586微機組成的主從復合系統，通過對計算負荷的合理分配，有力地保證了控制的實時性。
  4. Grating angular displacement measuring system

    光柵角位移測量系統
  5. Rules for the inspection of raster angular displacement sensor for export

    出口光柵角位移傳感器檢驗規程
  6. Verification regulation of angular displacement transmission chain error tester

    角位移傳動鏈誤差檢查儀檢定規程
  7. Angular displacement grationg

    角位移光柵
  8. Angular displacement measuring systems with absolute and incremental encoders ; concepts, requirements, testing

    帶絕對編碼器和增量編碼器的角位移測量系統.概念要
  9. Computer simulation result shows that the error is mostly less than 0. 1, if using this method to calibrate against the angular displacement for airplane ’ s rudders

    最後，進行了誤差分析和計算機模擬，結果表明，採用本方案標定精度可達0 . 1 。
  10. We must calibrate sensor against angular displacement for airplanes ’ aileron, jaw rudder and elevator, and so on, when making airplanes and testing on their flying capabilities. all the methods reported aren ’ t applicable because of its special working environment here

    在飛機生產和對飛機進行飛行性能試驗的過程中，都要對飛機的副翼、襟翼、方向舵和升降舵等轉動系統的角位移傳感器進行標定。
  11. Angular displacement grating

    角位移光柵
  12. Four groups ’ measurement data are given based on built system, and the results and the error analysis of measurement range of 1. 5, angle step of 0. 06 is discussed in detail. a list table of fitting curve and angular displacement is given as well

    利用建立的測量系統給出了四組測量數據，詳細討論了測角范圍為1 . 5 、角度遞增0 . 06的測量結果與誤差，並給出標定擬合直線與角位移的查找表。
  13. By means of building modelling with the target angular displacement and its sliding model variable structure controller of transmission ratio control electromotor, the parameters of entire controller are defined

    通過對速比控制電機目標角位移、角位移滑模變結構控制器的建模，來確定整個控制器的設計參數。
  14. The angular displacement and angular velocity of the upper limb during elbow extension activities in spinal cord injury patients and normal individuals

    6脊髓損傷患者與正常人在伸肘活動中上肢的角位移及角速度比較
  15. In some makes of engine the helically splined coupling is not used and the angular displacement of the shafts is effected by centrifugally actuated devices of the swinging link or inclined plane type

    在一些發動機的製造中，並不使用螺旋式花鍵套管，通過搖桿或斜面型的偏心操縱裝置，曲軸相位角起到同樣作用
  16. Based on the theory of mechanical optimization and finite element analysis, elbow - bar mechanism of the mp1040b moulding machines made by beiren group is investigated in the dissertation. firstly, a kinematic model representing the bar mechanism is built and the nonlinear system of equations is solved through the method of gradient. meanwhile, the angular displacement, angular velocity, angular acceleration and the corresponding curves of each component in a motion period are obtained

    本文以北京人民機器廠mp1040b型模切機肘桿機構為研究對象，以機械最優化理論和有限元技術為基礎，首先對模切機肘桿機構建立數學模型，通過梯度法求解此非線性方程組，並得出機構在一個運動周期中各構件的角位移、角速度、加速度等運動參數及曲線。
  17. 2 it can made horizontal, acial and angular displacement when being installed. it can t be restricted by the obstruction of pipe and the non - parallel of flange

    2安裝時可產生橫向軸向角向位移，不受管道不通心，法蘭不平行的限制。
  18. That part of a track or band on a magnetic drum, a magnetic disk, or a disk pack that can be accessed by the magnetic heads in the course of a predetermined angular displacement of the data medium

    磁鼓、磁盤或磁盤組上的一條磁軌或一組磁軌的某個部分，在數據媒體旋轉到預定的角度時，磁頭能在該部分存取數據。
  19. The target angular displacement tract simulation shows good performance the controller on the condition of disturbance

    在對角位移目標軌跡跟蹤的模擬中，控制器能夠較好地實現在有外在負載干擾下對角位移目標軌跡的跟蹤。
  20. Electrical power pulse signal will be entered into angular displacement or displacement of the central line control components

    步進電機是將電脈沖信號轉變為角位移或線位移的開環控制元件。
分享友人
分享到 Line

分享到臉書