angular error 中文意思是什麼

angular error 解釋
角度誤差
  • angular : adj. 1. 有角的，角形的；尖銳的。2. 用角度量的；角的。3. 瘦骨嶙峋的。4. 不靈活的，生硬的。adv. -ly
  • error : n. 1. 錯誤；失錯。2. 謬見，誤想；誤信；誤解。3. 罪過。4. 【數學】誤差；【法律】誤審，違法；（棒球中的）錯打。adj. -less 無錯誤的，正確的。
  1. Second, we estimate the angular velocity error making use of accelerometer ' s redundance information. system simulation testified this method is feasible

    第二，利用九加速度的冗餘信息估計殘差，對如何提高角速度的解算精度作了研究。
  2. It will produce very big angular velocity, angular acceleration and angular jerk when tracking fast moving targets. this may lead bigger tracking error and fail to track targets

    目標速度的提高將會產生大的角速度、角加速度乃至更大的角加加速度，導致光電經緯儀電視跟蹤動態誤差急劇增大，目標逸出視場，跟蹤失敗。
  3. A numerical simulation of a planar 3r manipulator is performed. the results show that the non - linear torsion springs have important influences on the joint error and tip error of manipulators. moreover, the influences of linear part of non - linear, the lumped mass of the rigid links and the angular acceleration of joint actuators on the non - linear dynamic character of flexible joint manipulator are discussed

    首先，建立了剛性桿非線性關節機器人的動力學模型，之後通過一平面3r機器人進行了數值模擬，說明了在一定情況下，關節的非線性對剛性桿機器人關節變形和末端誤差具有重要影響，並在此基礎上，討論了關節線性項、桿的集中質量和關節驅動加速度對機器人關節非線性特性的影響。
  4. Angular calibration of radar antenna system is composed of the calibration of angular error sensitivities ( also called directional sensitivity ), adjustment of cross - coupling of azimuth and elevation signals, and the calibrations of system errors such as antenna axial system error, dynamic delay and so on

    雷達系統天線的角度標校包括對系統角誤差靈敏度（又稱定向靈敏度）的標定、方位俯仰信號交叉耦合的調整以及對天線軸系誤差、動態滯后等系統誤差的標定。
  5. Error analysis on getting inertial angular position with linear accelerometers is improved

    改進了對線加速度計測量慣性姿態角的誤差分析。
  6. Two types of alignment algorithms on moving base were put forward in this paper, one with angular velocity matching, and another with acceleration matching. the error models and measurement models in consideration of ship flexure and lever - effect were deduced respectively. the alignment methods were verified by simulation

    提出了兩種動基座傳遞對準的方法，一種是採用角速率匹配，一種是採用加速度匹配，並分別推導了在考慮船體變形和桿臂效應時傳遞對推的誤差方程和量測方程，通過模擬驗證了這兩種傳遞對準方法的正確性。
  7. Verification regulation of angular displacement transmission chain error tester

    角位移傳動鏈誤差檢查儀檢定規程
  8. The analyse of theary about effect on angular error for reflective characterisitic of move angular cone prism

    角度誤差影響運動角錐棱鏡反射特性的理論分析
  9. In this paper, by analyzing the measuring of instantaneous speed, it was found that the main error is come from the angular measuring error, and then the method to decrease the error is given and the measurement precision is improved greatly

    摘要通過分析柴油機飛輪瞬時轉速的測量誤差，指出角度誤差是飛輪瞬時轉速的主要誤差來源，從而提出了減少誤差的方法，提高了瞬時轉速的測量精度。
  10. Angular travel error

    角距誤差
  11. Calibration results indicate that this angular rate gyro has good linearity with correlation coefficient of 0. 9996, and high precision with standard error of 0. 0036

    標定結果表明，該角速率陀螺線性度好，相關系數為0 . 9996 ；精度高，標準誤差為0 . 0036 。
  12. Abstract : angular glint error ( age ) is the main factor affecting angle tracking of millimeter wave ( mmw ) radar seeker so must be suppressed

    文摘:角閃爍誤差是影響毫米波導引頭末制導階段雷達跟蹤精度的主要因素，必須對其進行抑制。
  13. Computer simulation result shows that the error is mostly less than 0. 1, if using this method to calibrate against the angular displacement for airplane ’ s rudders

    最後，進行了誤差分析和計算機模擬，結果表明，採用本方案標定精度可達0 . 1 。
  14. The concept of acceleration delay compensation is put forward in this dissertation. by using acceleration delay compensation and tv tracker compensation technology the tracking capability of o - e theodolite tv tracking system is promoted to track fast moving targets at maximal 50 / s angular velocity and maximal 30 / s2 angular acceleration other than maximal 30 / s angular velocity and maximal 12 / s2 angular acceleration before while the maximal tracking error is still less than 3

    提出了加速度滯后補償的概念，並將其應用到提高電視跟蹤穩態精度中；結合電視跟蹤器補償技術，在保證最大跟蹤誤差不大於3的條件下，將目前的光電經緯儀電視跟蹤系統跟蹤最大角速度30 / s 、和最大角加速度12 / s2能力，提高到跟蹤最大角速度50 / s 、最大角加速度30 / s2 。
  15. The current loop technique improves the stabilization bed ability to reduce base disturbance direct drive constraint couple and enhances the torque sturdiness. the stabilization error is reduced with current loop technique under same base angular disturbance

    在轉臺穩定系統中使用電流環技術，提高了轉臺對直接帶動約束耦合的抑制能力，提高了系統的力矩剛度，在同等的擾動條件下，降低了穩定誤差。
  16. Four groups ’ measurement data are given based on built system, and the results and the error analysis of measurement range of 1. 5, angle step of 0. 06 is discussed in detail. a list table of fitting curve and angular displacement is given as well

    利用建立的測量系統給出了四組測量數據，詳細討論了測角范圍為1 . 5 、角度遞增0 . 06的測量結果與誤差，並給出標定擬合直線與角位移的查找表。
  17. Angular error of closure

    角度閉合差
  18. For example, the vehicle ' s angular and linear vibrations will result in the coning error, the sculling error and the scrolling error, so perfect algorithms should be designed to reduce the errors

    有些誤差，如運載體的角振動和線振動所引起的圓錐誤差、劃船誤差及渦卷誤差，則必須通過設計合適的演算法來解決。
  19. Introduce the traditional two samples rotation vector algorithm and three samples rotation vector algorithm, which fit the incremental angular condition. but, the output of fiber optic gyro is angular rate of the vehicle, the error would increase serious if use traditional algorithm

    由於光纖陀螺儀輸出為角速率信號，而傳統的旋轉矢量演算法輸出為角增量信號，採用角增量提取演算法，旋轉矢量精度會大幅大降。
  20. At last, the paper did a detailed analysis on the measurement principle, measurement method, measurement data and measurement precision. explicit the purpose and meaning of measuring the static precision of turn table. after comparison the author decided the reasonable and fitting method to measure the turn table ’ s static precision which include turn table ’ s angular error, intersection and perpendicularity

    最後，本文將重點放在了轉臺機械臺體的靜態精度測試方面，明確對轉臺機械臺體靜態精度測試的目的，指出靜態精度測試包含的三個內容，即轉臺的回轉精度測試、軸系相交度測試和軸系垂直度測試。
分享友人
分享到 Line

分享到臉書