anvil ratio 中文意思是什麼

anvil ratio 解釋
砧錘重量比
  • anvil : n. 1. （鐵）砧。2. 【解剖學】（耳朵里的）砧骨。3. （電鍵的）下接點。4. 砧琴〈一種敲擊樂器〉。
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. Based on ladle refining, wide flat anvil forge with great forging ratio, heat treatment process of " normalizing + spheroidizing + diffusion hydrogen ", the cold roll blank has been forged succesfully, and the percent of pass is up to 90. 5 %

    採用鋼包精煉爐冶煉、寬平砧大壓下量鍛造、 「正火+球化+擴氫」的熱處理工藝，成功製造了冷輥坯，合格率達90 . 5 。
  2. Abstract : based on ladle refining, wide flat anvil forge with great forging ratio, heat treatment process of & quot; normalizing + spheroidizing + diffusion hydrogen & quot;, the cold roll blank has been forged succesfully, and the percent of pass is up to 90. 5 %

    文摘:採用鋼包精煉爐冶煉、寬平砧大壓下量鍛造、 「正火+球化+擴氫」的熱處理工藝，成功製造了冷輥坯，合格率達90 . 5 。
  3. By means of analyzing the influence upon the stress distribution affected by parameters of half conical angle of anvil and ratio of height to diameter, the structural optimization method was advanced

    通過分析頂錘半錐角、高徑比等參數對應力分佈的影響，提出了結構優化的方法。
  4. The ratio of v - anvil width in the fmv forging method is optimized with numerical simulation according to the principle of larger deformation in the ingot center and smaller load

    按照工件心部變形大、載荷小的原則，得到的優化結果是：上下砧寬比= 1 : 1 . 5時壓實效果最好。
分享友人
分享到 Line

分享到臉書