arm size 中文意思是什麼

arm size 解釋
多葉形紡絲孔的葉片尺寸
  • arm : n 1 臂,【動物;動物學】前肢。2 【機械工程】(輪)輻;【電學】線擔,支路,支架。3 臂狀物;衣袖;...
  • size : n 1 大小,尺寸規模身材。2 (鞋帽等的)尺碼,號;(紙張的)開。3 巨大,大量;相當大的分量。4 〈口...
  1. The c arm of the system can rotate at a very high speed, up to 25 degreessec. at the same time, an automatic patient safety detector allows the use of fast rotations and angulations with enhanced patient safety through non - contact detection. the sensing system adapts to the patient s size and will automatically slow down and stop moving when a patient gets too close

    系統的c臂可作高速運轉,達到每秒25度的轉動;診斷儀同時配備新式自動安全偵測儀,能以高速運轉及多角度拍攝影像而毋須接觸病人身體,它的自動感應系統會因應病人的體形,自動調節運轉的速度,一旦太接近病人時,便會減速或自動停止,保障病人的安全。
  2. Wrap the proper-size cuff around the right arm and hold the arm level with the heart.

    用大小合適的袖套帶包裹右上臂,使上臂與心臟的高度相同。
  3. Lifting and lowering of the pringting arm of this machine is vertical, therefore, in case of half - tone printing, presence of screen wire and consistency of aberration are improved ; in case of spot printing, stability and uniformity of inking are enhanced ; fine adjustment and lock of the worktable is independent of each other, so positioning error caused by lock of the worktable can be controlled ; height and pressure of the printing blade and ink - returning blade can be stepless - regulated separately, which improver printing quality and service life of half - tone ; printing travel and half - tone fixing mechanism can be fast adjusted, which is suitable for printing area with different size

    本機印刷大臂升降為垂直升隆式,網線版印刷時網線表現率為色差一致性得到提高,實地版印刷的施墨穩定性及均勻性得以加強;工作臺微調與鎖緊獨立,因工作臺鎖緊而帶來的定位誤差得以控制;印刷刀、回墨刀高度及壓力均可單獨無級調節,提高了印刷質量和網版的使用壽命,印刷行程和網版固定機構大小可快速調節,方便不同規格的印刷面積。
  4. At arm s length, the angular size of our fists is about 10, fingers is about 1 and the tip of the thumb to the tip of the little finger of an extended hand is about 20

    將手伸直后,拳頭的角大小約為10度,手指約為1度,若把手掌張開,由拇指尖至小指尖的角距則約為20度。
  5. Hans, whose primary responsibility as interrogator was to make a positive identification, knew them by heart : his height and weight, head circumference and shoe size, scars, detal work, a tattoo under his left arm listing blood type

    漢斯作為問訊人,首要責任是確定他的身份,把他的所有特徵都牢記在心:身高、體重、頭圍、鞋碼、傷疤、牙醫記錄,以及左臂上表明血型的文身。
  6. The actuator is set in the joint axis in traditional arm, this increased the arm inertia, the dynamical property of robot is poor. if put the actuator on base, and transfer the movement and force to joints through tendons ( cable ), the weight and size of arm can be decreased. furthermore, consider from bionics, tendon ( cable ) - driven is more closed to the movement and force transfer mode of lives using muscles

    腱(柔索)驅動機構具有廣泛的應用前景,本文對其在其他領域的研究和應用情況進行了敘述,以在風洞中的應用為例,給出了一類腱(柔索)驅動機構的構型設計,創造性地運用正交補的方法分析了其工作空間,並研究了柔索受力、剛度條件及誤差補償的方法,為柔索驅動並聯機構在風洞中的應用打下了基礎。
  7. Each set includes one arm and one leg sleeve. large variety of accessories like leg sleeve and arm sleeve ( standard, short leg, short size, etc ) are available

    每套包括一件手臂套管及一件腳部套管。可配合多種配件一同使用。
  8. There are two innovations in the hardware system in currency sorter field. one of the innovations is that the powerful chip lpc2210 of arm series is applied on the test instrument for liquid crystal display module. and expand external memory ensure the large data volume because the ratio of small size tft - lcd and the quantity of test picture are increasing. because the powerful capabilities of processing datum of lpc2210, the test instrument is much faster and higher performance / price ratio than traditional test instrument and portable. the other one is the test instrument combine the

    本系統在該領域的創新點有兩點,一是將高性能arm核心晶元lpc2210應用到液晶顯示模塊測試系統中,並通過外部擴充存儲器,滿足了小尺寸tft面板在解析度不斷提高,測試畫面增加的情況下對測試系統大數據容量的需求。且由於arm系列晶元強大的數據處理能力,使得該測試系統相對傳統的測試機速度更快,性價比更高,且更加輕巧。
分享友人