atomizing air 中文意思是什麼
atomizing air
解釋
霧化空氣-
As to the work about theory analysis, at first, the paper describes the atomizing and humidifying process of the centrifugal nozzle with firing pin type, high pressure and little aperture and liquid physical properties. later, combining with the structure characters of this kind of nozzle, the paper studies on the theory of the atomizing and humidifying process by three phases, which is water film forming phase, water film falling into pieces phase, and heat and mass transfer between water and air phase in turn
理論工作方面，首先描述了撞針型高壓小孔徑離心式噴嘴的霧化加濕過程和液體的物理性質，然後結合撞針型高壓小孔徑離心式噴嘴的結構特點，將其霧化加濕過程分三個階段進行機理上的研究，這三個階段依次為液膜形成、液膜初次破碎及二次霧化、水與空氣的熱濕交換。 -
Through the special studies on impacts to atomizing and humidifying effect from such factors as the firing pin type, centrifugal structure, higher spraying pressure, less aperture, initial water temperature and original state of the air, some conclusions are obtained, such as : the centrifugal nozzle with firing pin type, high pressure and little aperture has bigger air eddy and atomizing angle. the spaying liquid has high velocity. the droplet is small, and the heat and mass transfer velocity is high
通過對撞針型結構、離心式結構、較高的噴水壓力、較小的噴嘴孔徑、噴水初溫及待加濕空氣初狀態對霧化加濕效果的作用原理的重點分析，得到：撞針型高壓小孔徑離心式噴嘴具有較大的空氣渦與霧化角，噴出的液體流速高、液滴小、水與空氣傳熱傳質速率高，撞針型結構提高了霧化加濕效率，高壓小孔徑的特點為霧化加濕提供了較大的能量，而噴水初溫的升高會減小水的粘性力和表面張力，從而優化加濕效果。 -
Experimental research on the flow characteristics of an air atomizing spray nozzle
氣動旋流霧化噴嘴流動特性 -
Air atomizing oil burner
噴氣霧化油燃燒器 -
Air atomizing burner
空氣霧化噴燃器 -
Hot air cnters into stirring and crushing and drying chamber from the bottom of drier with suitable atomizing speed. it exerts strong shearing, blowing, floating and rotating effect to raw material. therefore raw material is granulated through centrifuge, shearing, impacting and friction effect
熱空氣由入口管以適宜的進風速度從乾燥機底部旋轉進入攪拌粉碎乾燥室，對物料產生強烈的剪切、吹浮、旋轉作用。 -
Quantitatively analyses the concrete influences on atomizing humidifying performance of the nozzle aperture, initial temperature and the pressure of spray water and the water - air ratio through a single factor experiment
通過單因素試驗定量分析了噴嘴孔徑、噴水初溫、噴水壓力以及水氣比對霧化加濕的具體影響。 -
Air - atomizing nozzle
空氣噴霧嘴 -
Experimental study of a fog - atomizing evaporative cooler for compressor inlet air
壓氣機進氣用霧化式蒸發冷卻器實驗研究 -
Atomizing air intake
噴霧式進氣口 -
The improvement on conditioning and aeration of double fluids system by atomizing and controlling the air humidity was fully introduced in this paper, as well as solved the shortcomings of high moisture grades between the mirage soaked wind - pipeline and the surface of the grain, and between the superstratum and substrate after conditioning by a serios of managing measures, such as changing the way of ventilation, adjusting the aeration time by controlling the air - humidity of ventilation
摘要詳細論述了雙流體調質通風系統在水汽霧化、空氣濕度控制方面的改進，包括改變送風方式、調整干濕空氣通風時間等管理措施，較好地解決了調質過程中的水霧浸濕風道與糧面、糧堆上下層水分梯度大等的儲糧問題。
分享友人