axis angle 中文意思是什麼

axis angle 解釋
軸角
  • axis : n ( pl axes )1 軸,軸線。2 【植物;植物學】莖軸。3 【解剖學】第二頸椎,第二脊骨。4 【政治學】軸...
  • angle : n 【英史】盎格魯人〈cf Angles〉。n 1 角,隅,角落;棱,嬗角。2 【數學】角,角位,角的度數。3 【機...
  1. Searching satellite is to change the azimuth angle and pitching angle by making antenna circumrotate azimuth axis and pitching axis with controller, so antenna can point itself to different satellite according to the demands

    尋星就是通過控制器的控制使天線圍繞方位軸和俯仰軸旋轉,從而改變天線的方位角和俯仰角,使天線根據要求對準不同的衛星。
  2. From the standpoint of the gyrocompass the earth appears to be rotating about an axis making an angle ε with the true polar axis.

    從陀螺羅盤的位置觀察地球,好象地球是繞著偏離其極軸角的一個軸在移動。
  3. < uk > from the standpoint of the gyrocompass the earth appears to be rotating about an axis making an angle with the true polar axis. < / uk >

    < uk >從陀螺羅盤的位置觀察地球,好象地球是繞著偏離其極軸角的一個軸在移動。 < / uk >
  4. The model of influence upon the parallel between servo optic axis from the angle error of installation plans presented. whereby the theoretic analysis is carried out and the analyzing results are obtained. the method of obtaining the angle error through measuring the installation plans with three - coordinates measuring device and fitting the measurement data is put forward and pave a road for lessening the influence

    對安裝面角誤差影響隨動光軸平行性的問題也建立了數學模型,以此為出發點進行理論分析,給出了分析結果;提出用三坐標測量機測量安裝面,通過擬合得到安裝面的角誤差;從而為減小這一誤差源對隨動光軸平行性的影響鋪平了道路。
  5. Computes the axis and angle of rotation for a quaternion

    計算四元數的軸和旋轉角度。
  6. Based on this model, the effects of geometric and structural parameters, such as injection pressure, rear pressure, length - diameter ratio, inlet round angle - radius ratio and non - axis symmetry of nozzle, on the distribution of the cavitation inside the nozzle are analyzed

    基於這一模型進一步分析了噴射壓力、背壓和噴孔長徑比、噴孔入口圓角比、非軸對稱噴孔等幾何結構參數對噴孔內空穴分佈的影響。
  7. The western tongue has a synclinal bottom configuration, the axis of which plunges at a low angle towards the fault.

    巖體西支具有一向斜底的形狀,其軸以低角度向斷層傾沒。
  8. Proceed from the angle of energy and taking considerations on interference factor and drag of airfoil profile, a kind of new typed calculation method on the design of vane air foil was put forward according to the vortex aerodynamics model of the rotor of wind turbines with horizontal axis

    摘要根據水平軸風力機轉子的渦流氣動模型,從能量的角度入手,考慮干涉因子和翼型阻力,提出了葉片翼型設計的一種新型計算方法。
  9. Abstract : in this paper, the axis angle index measurement of stator turning and boring machine tools is realized by using 8031 micro - computer, open a new way to high accuracy the numerical display technical recinstruction

    文摘:本文介紹採用8031單片機實現定子車鏜床軸角分度的測量,為高精度的數顯改造開辟了一條新的途徑。
  10. Least squares solution of equation is used to calculate and adjustment transformation matrix at same time, transformation matrix is used to calculate the 3 - axis angle of star sensor. so is very fast and precise

    利用方程組的最小二乘解求取轉換矩陣,通過轉換矩陣計算星敏感器的三軸姿態角,使姿態計算和平差同時進行,具有較高的姿態計算精度和計算速度。
  11. The synchro / resolver signal transmit & receive card is the most important and difficult part which used special a / d and d / a ( axis angle converter ) to make conversion between the analog singnals related to angle and its digital counterpart, thus solve the issue of stimulation and test of synchro / resolver signal , improved the test precision and automatic degree

    其中同步器卡的開發是難點和重點,它採用特殊的數/模、模/數轉換器件?軸角轉換器,實現了角位-數字信號相互間的直接轉換,解決了隨動系統性能檢測中三相同步器信號激勵與同步器信號/分解器信號數字化檢測問題,有效提高了系統的自動化程度和檢測精度。
  12. The relation between area of ccd saturation and 0. 632 m 、 1. 06 m laser power / energy was measured. the ccd camera was disturbed by strong radiation from laser outside the field of view in experiment. the relation between the area of ccd saturation and off - axis angle was measured

    通過實驗,得到激光干擾ka - 320型面陣ccd光電探測器的像元飽和閾值、探測器靶面飽和閾值、局域損傷閾值,並得到了0 . 632 m與1 . 06 m波段入射激光功率與ccd靶面飽和程度的對應關系曲線,了解了面陣ccd探測器受激光干擾的各個階段。
  13. Considering the characters of 3 - axes coordinate system that is not included in ship rectangular frame or inertial frame, compensation conditions are deduced through studying the effects of ship - swing. the paper studies how to transfer line velocity and acceleration in the inertial frame to angular velocity and acceleration which correspond each axis, then gives the computer function scheme. servo control scheme which can overcome ship swing and realize moving - target accurate tracking is designed according to inconsistency of radar base angle and beam angle

    針對三軸軸系既非甲板坐標系又非大地坐標系的特點,既研究了船搖對正交三軸雷達系統的影響,推導實現船搖不變性的補償條件,又研究了將目標在大地坐標系中的線速度和線加速度濾波值折算到各軸對應的角速度和角加速度值的計算關系,並作出了計算機功能框圖。
  14. Mathematical expression of included angle between optical axis and ray axis

    光軸與光線軸夾角的數學表示
  15. Rebounding displacement of slope and axial force of anchor bars increases as the increment of the included angle of the rebounding displacement vector and x positive axis will reduce as the increment of horizontal tectonic stresses. the reduction of lithologic characters and weak interplayer have unfavorable influence on stability

    支護錨稈軸力也增大;隨著水平構造應力的增加,回彈位移矢量與水平x軸正方向所形成的角度將減小;邊坡巖體巖性參數的弱化和軟弱央層的存在都對邊坡的穩定造成不利的鍘惻。
  16. The stability of electric power system has been being focused for a long time toprevent a power system from losing synchronism after sudden fault , researchers have done much work and got many accomplishments this paper applied the direct feedback linearization ( dfl ) technique on the power system , a strong nonlinear system simulation results by matlab proved this method efficiency main works and results are as follows : this paper compared some existing methods in excitation control , fast valve control and coordinated control respectively, analyzed the developments and actuality of nonlinear control research in brief, illustrated why ransient stability could be greatly improved by using the fast valve control in chapter 3 , indicated the importance of coordinated control farther this paper introduced the inverse system theory, based on which , discussed the dfl theory, pointed out which had consistency with the inverse theory, expanded the dfl theory combined the idiographic model equations , made which adapt to the model of a single machine - infinite bus power system this paper referenced abundance articles and educed a set of equations , which could describe the dynamical process of excitation and fast valve control for synchronous generators in the equations , there were several very important parameters of power system - - rotor angle ( ) , rotor speed ( ) , generator q axis voltage ( eq ) , transient voltage ( e ' q ) , active power ( pe ) , mechanical input power ( pm ) , valve opening ( ) , generator terminal voltage ( vt ) , based on the model , nonlinear coordinated controller and terminal voltage optimal controller have been designed by using the expanded dfl theory and lq optimal control theory the simulation results showed that the controller could keep power system transiently stable under the effects of a symmetrical 3 - phase short circuit fault , which achieved better postfault regulation compared with another two routine methods , one is the proportion excitation controller and proportion fast valve controller, the other is the proportion excitation controller and the optimal fast valve controller, which could exert good performance when met 1ittle disturbance either

    在介紹逆系統理論的基礎上,詳細介紹了dfl理論,通過比較闡明了dfl理論其本質是逆系統方法的一類,並結合具體課題推導出的模型方程將dfl理論進行了擴展,使之適應于電力系統這個強非線性對象。通過參考大量的書籍文獻推導出一套實用的可將大型汽輪發電機勵磁與汽門綜合起來進行控制的模型方程,此模型方程涵蓋了電力系統中特別引人注目的幾個量- -轉子角、轉子轉速、發電機q軸電勢eq 、暫態電勢e ' q 、有功功率pe 、機械功率pm 、汽門開度、機端電壓vt ,在此基礎上建立了實用的電力系統簡化的數學模型,並將擴展的dfl理論應用於此模型系統,結合線性二次型最優控制理論設計出大型汽輪發電機的非線性綜合控制器及機端電壓最優控制器,通過模擬實驗與採用常規的按電壓偏差進行調節的比例式勵磁控制器+汽門比例控制及採用常規的按電壓偏差進行調節的比例式勵磁調節器和基於二次型性能指標設計的最優快控汽門(考慮發電機的飽和因素)進行了對比,證實了採用此種控制器可以有效地提高電力系統的暫態穩定性,並且在電力系統遭受小干擾時同樣具有良好的調節性能。
  17. An equal angle section, being a singly - symmetric section, will buckle in a torsional - flexural pattern about any axis except for flexural buckling about the unsymmetric axis

    等邊角鋼截面為單軸對稱截面,除繞非對稱軸失穩為彎曲失穩外,繞其他任意軸均為彎扭失穩。
  18. During the process of measuring valve phase, the grating displacement sensor and photoelectric axis - angle encoder are applied to measure the displacement of valve and the angle of curving shaft respectively. their signals are sampled and imported into computer. then the three signals are compared to find the relationship of valve phases in order to offer the reliable measuring parameters for the researchers and quality controllers

    在氣門相位測量中,採用光柵位移傳感器和光電軸角編碼器,分別將發動機進、排氣門位移量和曲軸旋轉位移量的變化信號通過采樣,輸入計算機,對三路信號加以比較找出氣門的相位關系,從而為設計開發人員、品質控制人員提供可靠的測量參數。
  19. The main task including : when the raster ruler and axis - angle coder move forward or backward, they will bring pulse signals which are length signals and angle signals. these signals will be sent to signal processing circuits to be pretreated. then the signals will be sent to direction differentiation circuits to differentiate the directions

    主要完成以下任務:把光柵尺和軸角編碼器前進或後退產生的長度信號和角度信號,送信號處理電路進行處理,再送鑒相倍頻電路進行鑒相處理,送單片機計數,由另一片單片機把計數的結果數據經過串列通訊電路送至pc主機去進行處理。
  20. Fpga implementation of radar axis - angle measuring and software hardware co - simulation

    的雷達軸角測試系統實現及軟硬體協同模擬
分享友人