balance amplifier 中文意思是什麼

balance amplifier 解釋
平衡放大器
  • balance : n 1 〈常作 a pair of balances〉 天平,秤。2 平衡,均衡,對稱;抵消;比較,對照,對比。3 (鐘表的...
  • amplifier : n. 1. 【電學】擴大器;擴音器。2. 放大鏡;放大器。
  1. Equipment and instruments : electronic analytic balance, uv and vis spectrophotometer, 97rt fluorescence spectrophotometer, gas chromatograph spectrometer, high speed centrifugal machines, leica rm 2015 microtome, fluorescence microscopes, pcr amplifier, and so on

    :電子分析天平、紫外可見光分光光度計、 97rt熒光分光光度計、氣相色譜儀(附4種檢測器) 、高速離心機、病理切片機、熒光顯微鏡、 pcr擴增儀等。
  2. The expresson of phase balance among the degenerate amplifier of self - excitation and oscillator

    相位平衡條件在負反饋放大器的自激與振蕩器中的表述
  3. In wavelength conversion based on four - wave mixing ( fwm ) in soa, balance efficiency can be obtained in larger range when increasing saturation power of the optical amplifier and decreasing the saturation power of spectral hole burning and carrier heating

    而在基於soa的四波混頻( fwm )波長轉換中,在提高光放大器飽和功率的同時減小光譜燒孔( shb )和載流子加熱( ch )飽和功率可有效提高較大頻率間隔處的轉換效率,並保持其在較大頻率失諧范圍內的效率均衡。
  4. Theoretically several solutions are derived in the final scheme such as broadband matching technology which included negative - feedback technology, traveling wave technology and balance technology. in addition, the design will be optimized by eda software and the final test result indicates that our design is successful. the principle of microwave amplifier is introduced at first in this paper, especially its main parameters index sign, then the material performance and the influence of parasic parameter and model setting of the gaas phemt is discussed

    文中首先介紹寬頻帶放大器的主要參數指標,接著介紹了gaasfet的材料特性,以及phemt管芯寄生參數對實際放大器設計的影響,然後討論gaasphemt的大、小信號模型的建立與分類;結合gaasphemt模型和s埠參數分析了寬頻帶匹配技術的原理;最後論述本課題中各個放大器實現的具體方案,以及在放大器實現過程中應該注意的問題,給出了實際寬帶放大器的測試結果,並將軟體模擬結果與實測曲線進行對比。
  5. The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load

    本文在場效應管fet柵極上加上諧振網路(諧振網路是通過cst模擬得到的,它是串聯反饋迴路,介質工作在te01模,對于其後的fet ,它又相當於一個帶阻濾波器) ,然後設計輸入輸出匹配電路,使電路結構滿足起振條件,之後繼續用諧波平衡法模擬和優化,使振蕩器輸出功率合適,相位噪聲很低。
  6. Some new technologies such as dividing the memory array into separated sub - arrays, atd, pre - charge and balance, subsection decoding, multilevel sense amplifier, etc have been used

    設計中採用了諸如存儲陣列分塊技術,地址探測技術,預充電及平衡技術,分段譯碼技術,分級敏感放大器等一些新技術。
  7. 2 beams power balance experiment of single amplifier system was presided over independently by me, gaining the high precision power balance target and accumulating the experience for " sg - ii " power balance ; 7

    獨立負責進行了兩路單臺放大器系統的功率平衡實驗,達到了高精度功率平衡指標,為神光n裝置高精度功率平衡積累了經驗。
分享友人