basic control 中文意思是什麼
basic control
解釋
基本控制網-
Athough the dressage test was really one of basic control ; it undoubtedly formed a foundation for future competition
雖然當時盛裝舞步的比賽是非常基礎的馬匹掌控，但是毫無疑問，這為將來的馬術比賽打下了良好的基礎。 -
On the running theory of electrical power ergograph and the basic control theory basis, this paper expatiate on the mathematic model and modulating speed of ergograph, and expounds the principle and ways of design of hardware and software for measure and control system, and describes the hardware and software with some frames and interfaces, and importantly recommends the way of designing software
本文根據電力測功機的工作原理和控制理論基礎，主要闡述了測功機的數學模型和調速原理以及整個測控系統的硬體和軟體設計的原理和方法，並輔助框圖和界面對軟硬體進行了詳細描述，重點介紹了系統軟體的設計。 -
Basic control of tb is the key, they say
他們說對結核病的基礎控制是關鍵所在。 -
According to the shear - type floor model of frame structure, a basic control equation is constructed to analyze the nonlinear seismic responses of structure equipped with edd - bracing system. subsequently the dynamical finite element analysis are carried on to obtain the seismic response of a twelve - floor r. c frame with the three edd - bracing system under minute earthquake and disastrous earthquake, and the conclusions provide useful references for practical earthquake - resistant design
基於框架結構剪切型層模型，建立了耗能阻尼器對建築結構非線性地震反應的基本控制方程，由此進行了某十二層鋼筋混凝土框架結構設置三種耗能阻尼器在多遇和罕遇地震下的動力有限元分析，為進行實際結構設置耗能阻尼器的抗震設計提供了有益的參考。 -
This paper unite surveys works in dong gua shan mines construction under 1 km place researching four key technology in mine s survey, they are construction survey technology in km deep mine, km deep mine s connected survey technology, km deep level survey technology of longer distances link up in many heads opening and basic control survey technology, km mine s extension when the production must go on accurate fixed position survey technology, and all obtained success
本文結合在千米以下冬瓜山銅礦建設時期的測量工作，研究了深部礦山測量四個方面的關鍵技術，即千米深井施工測量技術、千米深井聯系測量技術、千米深井中段多頭開拓長距離貫通和基本控制測量技術、千米深井不停產延深精密定位測量技術，並取得了成功的效果。 -
This paper introduced the basic control mode of automatic control system of coagulant dosage, taking the technique of streaming current defection for example, and then the merits and demerits of each control mode and the applicability was analyzed
以流動電流檢測技術為例，介紹混凝投藥自動控制系統的基本控制方式，並且對各種控制方式的優缺點及適用條件作了分析。 -
Abstract : this paper introduced the basic control mode of automatic control system of coagulant dosage, taking the technique of streaming current defection for example, and then the merits and demerits of each control mode and the applicability was analyzed
文摘:以流動電流檢測技術為例，介紹混凝投藥自動控制系統的基本控制方式，並且對各種控制方式的優缺點及適用條件作了分析。 -
Converter static control is the basic control mode for the converter computer, the dynamic control for sub - lance is on the basis of static control
摘要轉爐煉鋼靜態控制是轉爐計算機的基本控制方式，副槍動態控制以靜態控制為基礎。 -
This thesis analyzes all kinds of throttle components, points out the advantage of adapting eev, and analyzes the start - up and the discharge characteristics of eev, and dynamic response of refrigeration systems when the opening degree of eev is changed, etc. eev is placed into a tumoff position while the unit starts up, and after being kept for a period of time it is placed into a bigger position, after some more time it is put into a basic control
本文對比分析了冷藏箱製冷系統各種節流元件的特點，指出電子膨脹閥應用的優勢，同時分析了電子膨脹閥的啟動特性、流量特性以及系統在閥開度變化時的動態響應。電子膨脹閥在啟動時應先使電子膨脹閥處于關閉位置，延時一段時間后，再將閥開至一個較大的位置，再延時一段時間后轉移到基本的控制。 -
This paper describes the components in the common electronic control system of engine and presents the basic control theory and algorithm in the electronic control unit
本論文對發動機的普通電噴系統的組成進行了分析，研究ecu的基本控制理論和演算法。 -
So, in the paper, proceeding from the automatic control of extrusion velocity and based on the basic control strategy presented firstly, the relation among parameters of the process such as pressure, temperature and displacement is investigated, and the model of the process has been built using system identification method. then, a corresponding controller is designed together with its control algorithm, and the control system is proved viable and effective by the results of simulation on the control system. in the end, the problem of the realization of the control system is discussed by using modularization method. the hardware of the control system is designed and a sofeware with a perfect manmachine interface is developed, too
因此，本文從擠壓速度的控制出發，首先探討並確立了本系統的基本控制策略；然後根據此控制策略的必然要求，對該工藝擠壓過程所涉及到的擠壓力、溫度、擠壓軸位移等參數間的關系進行了深入研究，利用系統辨識方法建立了擠壓過程關鍵階段的數學模型；在此基礎上完成了相應的控制器設計，給出了控制演算法，並對所設計的控制系統進行了模擬。 -
The steady and dynamic mathematic models of upfc are investigated, and the basic control performances and the control system structure are also discussed in this paper. then the upfc power flow control characteristics and the fundamental principles of upfc control arc put forward
論文首先分析了upfc的動靜態數學模型，介紹了upfc的基本控制特性和控制系統結構，並提出了upfc的潮流調節特性及控制的基本原則和分級控制策略。 -
The simplest use of control - flow words is to implement the basic control structures shown in figure a. 1
最簡單的流程式控制制詞的使用就是實作顯示于圖a . 1的基本控制結構 -
Key technique such as basic unit and variety of configuration, main technical target, basic control accuracy and production technology flow has been explicated in details
文中給出了生產線的基本組成及不同配置、王要技術指標、基本控制精度、生產工藝流程等關鍵技術的詳細說明。 -
The unilateral control strategies can be classified into two basic control modes : un - alternate switching mode and synchronous rectification ( sr ) mode. the theoretical analysis and simulations of these two control modes were given in detail, also with the experimental verification
對單邊控制策略下的兩種控制模式:非互補導通和互補導通即同步整流控制，分別進行了深入的理論和模擬分析及實驗驗證。 -
Firstly, the basic control structure is presented
給出了衛星姿態控制器的基本形式。 -
Basic control system
基本控制系統 -
The hardware was divided into basic control system, the input and output of analog signal, and the input and output of digital signal block to design main circuits
硬體分成基本控制系統、模擬量輸入、模擬量輸出、開關量輸入、開關量輸出以及通信等模塊來設計電路。 -
We use the full - distributed control technology as the basic control mode, and distributed the control system of the pneumatic servo sub - system and the electrical servo sub - system. also, we coordinate them through can - bus. the experiment results have proved that it is a good solution for the mixed - driven system
論文採用完全分散式控制技術，將氣動伺服與電動伺服分散控制，通過can總線實現氣動伺服與電動伺服之間的協調，很好解決了混合驅動問題。 -
Walkthrough : creating a basic control designer for a web server control
演練：為web服務器控制項創建基本控制項設計器
分享友人