bias current 中文意思是什麼
bias current
解釋
偏流-
As a mix - mode chip, the application - specific controller including analog signal and digital signal processing block can be applied to receiving, amplifying, processing, controlling signals of pir, and offer a wide application in some fields. in analog circuits, by sub - threshold mosfet, a self - bias current source is presented, which has a high power supply restrain ratio and a complementary to absolute temperature characters
這款晶元是一款數模混合晶元，包括模擬信號處理（含模數介面模塊）和數字信號處理兩大模塊，完整實現對紅外信號的接收、放大、處理、控制，產生有效數字電平驅動繼電器、可控硅等負載，應用於自動燈等多種場合。 -
The displacement current mechanism is operative only for capacitors under reverse bias or very weak forward bias conditions which maintain a space-charge layer.
位移電流的機理只對反向偏壓或要維持空間電荷層所需要的非常弱的正向偏壓條件下的電容器才有用。 -
This condition, known as reverse bias, is not conducive to current flow through the junction.
這種叫做反向偏置的狀態不利於電流穿越結。 -
For phonetic signal modulation, if the pass band range of the band pass filter ( bpf ) is 300hz - 3400hz, the anti - noise properties of laser are approximately independent of bias current and parameters of the cavity ; when the pass band range of bpf increases to a certain degree, modulating bias current and parameters of the cavity can improve the anti - noise properties of laser
對語音調制情況，如帶通濾波器的通帶范圍取為300hz - 3400hz ，則激光器的抗噪聲性能基本不依賴于偏置電流和腔內參數；當帶通濾波器的通帶范圍增大到一定程度，調整偏置電流和腔內參數可以實現半導體激光器的高抗噪聲性能。 -
We apply the agrawal ' s theory model of soa, and study the temporal characteristics of the output pulse for input picosecond optical pulses with different sharpness edges passing through a semiconductor optical amplifier, and find that the peak power and the pulse width of the output pulse depend on the input pulse peak power, the sharpness degree of the input pulse edge and the bias current of soa
本文應用agrawal的關于soa理論模型，詳細研究了具有不同陡峭邊沿的皮秒超高斯光脈沖經soa后的時域特性的變化，發現輸出脈沖的峰值功率、脈沖寬度與輸入脈沖的峰值功率、輸入脈沖邊沿的陡峭程度以及soa的偏置電流密切相關。 -
The g2 adjustment is a service or factory level adjustment, normally only done at the factory or at installation, which adjusts the bias current for each tube individually so that they all come on at the same time
每一隻投影管都需要一定量的偏置電流才能夠正常工作，然而，每隻管及其相應的電路參數都會有些差異，因此所需的偏置電流也不太一樣。 -
The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement
偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。 -
The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier
本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。 -
By changing the negative bias current density, gaseous ratio and total pressure, nanocrystalline diamond film is prepared by ion - assisted bombardment method at the substrate temperature of 700 ? 00 ? and mixture gaseous of ch4 and h2 the effect of growth parameters on the diamond film is studied. the diamond film presents very low compressive stress and excellent field emission character
採用離子輔助轟擊法，以ch _ 4 、 h _ 2為源氣，襯底溫度為700 900 ，通過改變襯底負偏壓、 h _ 2和ch _ 4氣體比例以及工作氣壓，制備出納米金剛石薄膜，並對工藝參數對金剛石薄膜沉積的影響進行了研究。 -
Second, since input bias currents are not always small and can exhibit different polarities, source impedance levels should be carefully matched to minimize additional input bias current - induced offset voltages and increased distortion
其次，因為輸入偏置電流不一定都小，且可能體現不同的極性，而且源阻抗水平應該仔細地進行匹配，以將輸入偏置電流引起額外失調電壓和增加的畸變減到最小。 -
Subcircuit models are designed and simulated, which includes bias current source, voltage reference, error amplifier, pwm comparator, driver circuit, protection circuits for over - temperature, over - current. at last, combined with periphery component, the circuit is simulated, and the result meets the anticipant requirement
並對集成電路內的各個模塊包括電流偏置電路、基準電壓電路、誤差放大電路、三角波振蕩發生電路、 pwm比較電路、驅動電路、過熱保護電路和過流保護等進行了具體的設計和模擬，並對整體應用電路進行了模擬，結果均達到了預先設定的指標。 -
In the fourth chapter, a fourth - order chebyshev low - pass filter employs new low voltage, highly linear, wide inputting range transconductor is proposed, then we presents a new circuit to tune gm value of transconductor accurately, which employs a new switched - capacitor circuit to change the bias current of transconductor, a third order elliptical function low - pass filter with accurate tunable frequency has been designed using transconductor that is not only with voltage common - mode negative feedback, but also with varying bias - triode transistors which can improve the linearity of this circuit
第四章：提出了一種新的低電壓、高線性度、寬輸入范圍跨導，並由此設計實現了四階切比雪夫（ chebyshev ）低通濾波器，接著提出了一種寬輸入范圍且具有電壓共模負反饋的全差分跨導，並採用一種新的開關電容電路實現跨導值gm精確可調，從而可以設計得到高性能具有精確截止頻率的跨導-電容三階橢圓函數濾波器。 -
The results that increasing of bias current and shunted resistance and lowing critical current and connected inductance can decrease the transmission time are shown ; ( 4 ) a new type of circuit, ladder shape multiplayer jtl. structure is provided by author, thus output signal of rsfq circuits can be amplified before transfer to room temperature electronics system. it has highly gain of amplify relatively and the double peak structure are avoided through decreasing parasitic capacitance
（ 4 ）針對目前超導與室溫介面電路的電壓放大器存在的「雙峰」和放大增益效率較低的不足，提出了一種全新的階梯式多層jtl電壓放大電路結構，較好的解決了以上的問題，通過初步的模擬分析證實，該電路的構思極負有創新性。 -
The electro - chemical measurement system used to perform dpsv measurement is constructed with two parts, a low - current measurement system consists of low input bias current operational amplifier and a high resolution sar adc and a potentialstat consists of high resolution dac and high current buffer amplifier
對于微分脈沖伏安溶出測量，我們使用高精度高速saradc和低偏置電流運放構成微電流采樣系統，使用高精度dac和高速大電流緩沖放大器設計了恆電位計，並與微控制器共通組成電化學測量系統。 -
However, the emission wavelength of a dfb - ld needs to be carefully turned on the predetermined wavelength grid by adjusting both laser temperature and bias current. furthermore, dfb - ld has such drawbacks as a relatively large variation of the lasing wavelength with ambient temperature ( ~ 0. 1nm / c ) which restricts its application in dwdm systems
然而dfb - ld的激射波長受溫度（ 0 . 1nm ）和偏置電流的影響較大，只有通過調節dfb - ld的溫度和偏置電流，其激射波長才能被調諧在預置的波長處。 -
Firstly, design the software phase - closed loops ; secondly, realize the double closed loops control of the instantaneous value and the virtual value. furthermore, the dynamic flux imbalance of the output transformer caused by ordinary pi arithmetic is analyzed in detail. a new solution for flux balance by sampling the instantaneous primary current of the output transformer and introducing the on - line calculated bias current component into the voltage regulation arithmetic is presented
系統軟體實現了ups的各個功能模塊，首先設計了軟體鎖相環；然後實現了輸出電壓瞬時值和有效值雙閉環反饋控制；並且在深入分析基本數字pi演算法所引起的輸出變壓器動態偏磁問題的基礎上，提出了一種改進演算法，實時消除了變壓器的偏磁。 -
Input bias current
輸入偏壓電流 -
Again, consider using amplifiers that exhibit a smooth input bias current transition throughout the applied input common - mode voltage
再者，所用的放大器也要考慮在加到輸入端的整個共模電壓（范圍內）輸入偏置電流轉換保持平滑。 -
The results of numerical simulation show that for various kinds of noise without modulation the anti - noise properties and the output quality of laser can be improved by selecting appropriately bias current and parameters of the cavity
數值模擬的結果表明，對于無調制時的各種噪聲，適當選取偏置電流和腔內參數可以提高微腔半導體激光器的抗噪聲性能或激光輸出的質量。 -
To reduce power dissipation of the amplifier, a kind of on / off technology is used in the circuit. with a little bias current circuit to control the main bipolar transistor operation, the transistor will be in a state of on / off
採用器件旁路小電流工作電路，實現對低噪聲放大器主要工作晶體管的控制，使該晶體管按需要分別處于工作或關斷狀態，保證了放大器的極低功耗。
分享友人