binder fiber 中文意思是什麼
binder fiber
解釋
粘合纖維-
Taking the andalusite from south africa and alumina fiber as raw materials, adding aluminum sulphate as binder, fabrication and properties of alumina fiber reinforced andalusite composite was studied through wet dispersion, mould pressing and sintering processes
以紅柱石和氧化鋁纖維為原料，用硫酸鋁作為結合劑，經過分散、混合、半干法成型、高溫燒成工藝，對氧化鋁纖維增強紅柱石基復合材料的制備及性能進行了研究。 -
Biomax follows researchers reports on the necessary amount of elements such as protein, lipid, fiber, vitamins, mineral, and amino acids, attractant and binder and can guarantee the consistent production of high quality feed
是從學者專家研究報告中，從蛋白質脂肪纖維質維他命氨基酸礦物質之需求量及餌料引誘劑黏劑之開發與幼魚蝦之嗜食配合研製成理想之餌料。 -
Nonwovens usually consist of at least two components; the fiber and the binder.
非紡織物通常至少含有兩種成分，即纖維和粘合劑 -
But the chemical properties have no remarkable influence on it ( 3 ) as the water - to - binder reduces wich is one of key factors in the perpormance of reactive powder concrete with steel slag, the fluidity decreases but the strength increases ; incorporation of 4 percent steel fiber in volume can decrease fluility and increase strength ; heat - curing benefits the increase of strength which can still develop in 28 day water curing after heat - curing
（ 3 ）水膠比是影響其性能最為關鍵因素之一，隨著水膠比的降低，流動性下降和強度的提高都很明顯；摻入4的鋼纖維對流動性的影響比較明顯，同時也不同程度地提高了強度；熱養護有利於強度的提高，經熱水養護後放置水中至28天齡期，其強度有較大提升，並沒有出現強度倒縮現象。 -
The influence factors of brittleness of hslc such as w / b ratio, sand percentage, type of aggregate and binder constitution are analyzed by the experiment : in order to improve the toughness of hslc, we study the function of fiber, polymer, aggregate and low - layer steel fiber on improving toughness, and explain the mechanism of improving toughness of them
最後採用這四種技術復合增韌，得到了和理想結構模型相符的高強高韌性輕集料混凝土，較基準輕集料混凝土抗壓強度增加16 . 3 ，抗彎強度增加97 ，沖擊韌性提高171 . 9 ；劈裂抗拉強度增加52 . 6 ，韌性指數提高19 . 2倍，並且具有耐久、經濟等優良性能。 -
By using the high pure alumina micro - powder ( > 99. 0 % ) and the polymorphous alumina fiber as materials, by adding alumina sulfate as the binder or polypropylene - amide as the disperser respectively, through mixing, dispersing, and compression molding, at different temperatures of 1200 c, 1350 c, 1400 c, 1500 c, and 1550 c with no pressure, the alumina fiber - alumina composites were made
本試驗採用高純氧化鋁微粉（ 99 . 0 ）和多晶氧化鋁纖維為原料，分別加入硫酸鋁和聚丙烯酰胺作結合劑和分散劑，經混合、分散、壓力成型及在1200 、 1350 、 1400 、 1500 、 1550下無壓燒成制得氧化鋁纖維? ?氧化鋁復合材料。 -
406 is non - asbestos clutch facing which adopts refined glass fiber, high - temperature resistance composite fiber materials, high quality metals such as soft copper and so on, uses imported wear and lubrication materials, high grade heat resistance resin binder through special process
406無石棉離合器面片，採用精製玻纖，耐高溫復合化纖材料，優質軟金屬銅等，選用進口耐磨材料，潤滑材料，高檔耐溫樹脂經過特殊工藝復合粘結而成 -
405 is non - asbestos clutch facing which adopts refined glass fiber, high - temperature resistance composite fiber materials, high quality metals such as soft copper and so on, uses imported wear and lubrication materials, high grade heat resistance resin binder through special process
405無石棉離合器面片，採用精製玻纖，耐高溫復合化纖材料，優質軟金屬銅等，選用進口耐磨材料，潤滑材料，高檔耐溫樹脂經過特殊工藝復合粘結而成 -
Comparing the tension test results of a series of carbon fiber products, the one with the best price - performance ratio is picked out among them to be used in the field experiment. the corresponding epoxy resin binder both and anchorage - tension system are also developed
通過對十余種碳纖維製品的抗拉試驗，選擇出「性價比」較高的碳纖維布作為試驗路段的筋材，並初步研製出與之配套的環氧樹脂膠和錨固張拉系統。 -
Secondly, preparation of reactive powder concrete with air quench steel slag and its performance are mainly studied through experiment. the results show that : ( 1 ) when binder - to - sand ratio is 1, silica fume percentage of binder is 15, and steel fiber percentage in volume is 4, reactive powder concrete prepared can get best overall performances
其次，作者主要對鋼渣活性粉末混凝土配製及其性能進行了試驗研究，結果表明： （ 1 ）膠砂比為1 : 1 ，硅灰摻量為15 ，鋼纖維摻量為4時所配製的活性粉末混凝土的綜合性能比較理想。 -
The binder was stable in storage, gave transparent and elastic membranes, and was suitable for pigment printing of cotton and synthetic fiber fabrics
該粘合劑儲存穩定，成膜無色透明，彈性強，適合純棉與合成纖維織物進行塗料印花。
分享友人