blanking die 中文意思是什麼

blanking die 解釋
沖栽模
  • blanking : 沖孔；切料
  • die : vi （died; dying）1 死。2 滅亡，消滅；熄滅；枯死，凋落。3 漠然不受影響，感覺不到 （to） 。4 泄氣...
  1. Plates of fine blanking die. adjusting plates

    精沖模模板.調節板
  2. Plates of fine blanking die. square backing plates

    精沖模模板.方形墊板
  3. Plates of fine blanking die. round backing plates

    精沖模模板.圓形墊板
  4. Composite section blanking die

    組合式落料模
  5. Guide unit of fine blanking die. cages

    精沖模導向裝置.鋼球保持圈
  6. Anti friction bearing die sets of fine blanking die with fised punch. four pillar sets

    精沖模固定凸模式滾動導向模架.四導柱模架
  7. Anti friction bearing die sets of fine blanking die with fixed punch. center pillar sets

    精沖模固定凸模式滾動導向模架.中間導柱模架
  8. Anti friction bearing die sets of fine blanking die with fixed punch. diagonal pillar setse

    精沖模固定凸模式滾動導向模架.對角導柱模架
  9. Anti friction bearing die sets of fine blanking die with sliding punch. center pillar sets for laid die plate

    精沖模活動凸模式滾動導向模架.平放式中間導柱模架
  10. Anti friction bearing die sets of fine blanking die with sliding punch. center pillar sets for inlay die plate

    精沖模活動凸模式滾動導向模架.座入式中間導柱模架
  11. Anti friction bearing die sets of fine blanking die with sliding punch. diagonal pillar sets for laid die plate

    精沖模活動凸模式滾動導向模架.平放式對角導柱模架
  12. Pressure elements of fine blanking die. pedestals of piercing punches

    精沖模承力裝置.凸模座
  13. Anti - frictiom bearings of fine blanking die. guide bushings

    精沖模滾動導向裝置.導套
  14. Pressure elements of fine blanking die. pressure rings

    精沖模承力裝置.承力環
  15. Pressure elements of fine blanking die. pressure pads

    精沖模承力裝置.承力塊
  16. Sliding guides of fine blanking die. guide bushings

    精沖模滑動導向裝置.導套
  17. Plates of fine blanking die. square retaining plates

    精沖模模板.方形固定板
  18. Technical specifications of fine blanking die elements

    精沖模零件技術條件
  19. Plates of fine blanking die. round retaining plates

    精沖模模板.圓形固定板
  20. Technical specification of typical assembly of fine blanking die

    精沖模典型組合技術條件
分享友人
分享到 Line

分享到臉書