boiler fouling 中文意思是什麼
boiler fouling
解釋
鍋爐灰垢-
The listed influences of coal quality upon fouling coefficient of heating surfaces have comparatively large difference with recommended values in some standards currently in effect at abroad, needing to accumulate data from boiler test, design, and operation for correcting the said influences
所列舉煤質對受熱麵灰污系數的影響與國外某些現行標準的推薦值有時相差較大，需要鍋爐試驗、設計、運行中積累數據對其進行修正。 -
To reduce the loss due to the fouling of the heat exchanger surface and improve the economic efficiency of the boiler, we must judge the soot deposition level exactly and reliably, then we can schedule the soot blowers to cure the loss caused by soot deposition
為了減少受熱面污染造成的損失，提高鍋爐經濟性，勢必要求準確可靠地判斷鍋爐受熱面的灰污染狀況，通過對吹灰器等加以調度來減少由於受熱麵灰污染帶來的損失。 -
The ash fouling online monitoring models are built for furnace, convection heating surface and tri - sectional regenerative air preheater based on the analysis and summarization the researches on the ash fouling monitoring technic and models of boiler. clean factor ( cf ) is chosen to express the effect on heat transfer of ash fouling and is calculated by heat transfer steady - state model
在分析研究總結現有的鍋爐各類受熱面的各種灰污監測技術和模型的基礎上，建立了鍋爐爐膛、對流受熱面和三分倉空預器的灰污在線監測模型，以清潔因子表徵受熱麵灰污對鍋爐受熱面傳熱的影響。 -
And the law gained from differential calculus is coincident well with the calculated result. grounded upon the research on the sootblower operation, the effect on all kinds of boiler performance of ash fouling on heating surface is analyzed roundly. and the sootblowing income is divided into five categories
在現有吹灰器研究和運行水平的基礎上，全面分析電站鍋爐各部位受熱麵灰污對鍋爐各方面性能的影響，將電站鍋爐吹灰的收益和成本各歸納為五類，得出不同受熱面吹灰的收益和成本不盡相同的結論。 -
Influencing factors of boiler heating surface fouling monitoring
鍋爐受熱面污染監測影響原因的分析 -
Through analysis and comparison of formation mechanisms for slagging and fouling on beating surfaces of coal - fired boilers, as well as experiences of applying steam sootblowers, hydraulic sootblowers, and fuel - gas pulsating sootblowers on boiler no. 6 in dezhou power plant, in has pointed selected type of sootblowers should be directed against the fouling property and soot cleaning requirements of different heating surfaces in the large - scale coalfired boiler
摘要通過對蒸汽吹灰器、水力吹灰器、燃氣脈沖吹灰器在德州電廠6號爐應用結果的分析比較，指出大型燃煤鍋爐應根據不同受熱面的積灰特點及清灰需要，有針對性的選擇吹灰器類型。 -
Shenhua coal was burned in the conditions of no reburning, reburning and reburning with injected calcium in 2. 11 mw boiler with four cornered combustor to study the fouling and slagging characteristics with coal reburning and injected calcium
摘要為了研究再燃、噴鈣時爐內沾污結渣特性，採用低熔點神華煤在2 . 11mw四角試驗爐中分別進行無再燃工況、有再燃工況和噴鈣再燃工況試驗。 -
In this paper, a method for the on - line monitoring of fouling and slagging on utility boiler heat surfaces is put forward, and the basic principle of which is stated. on the basis of the method, a suit of on - line monitoring system of fouling and slagging is developed to guide and optimize the process of sootblowing
本文以燃煤機組為研究對象，提出了一套適用於電站煤粉鍋爐的受熱面積灰、結渣監測方法，闡述了監測方法的基本原理，並在此基礎上開發了一套積灰、結渣在線監測系統來指導和優化吹灰過程。
分享友人