burner combustion 中文意思是什麼

burner combustion 解釋
燃燒器燃燒
  • burner : n. 1. 燒…人；氣焊工，氣割工。2. 燃燒物；爐子；燈；燈頭，燈口；噴燒器，噴燈；噴嘴；燃燒室。3. 火藥柱。
  • combustion : n. 1. 燃燒，發火，點火。2. （有機體內營養料的）氧化。3. 騷動。
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Steps are revealed that must be taken when boiler without designed capability of peak shaving takes part in peak shaving operation : one is combustion adjustment, the other one modification of burner

    明確了沒有設計調峰能力的鍋爐在參與電網調峰運行所應採取的措施：燃燒調整與燃燒器改造。
  3. After technical innovation of no. 12 generator of qingshan power plant, the combustion adjustment test was performed and it was demonstrated that operation condition of the generators was improved by using of horizontal concentrated powdered coal burner technique

    摘要湖北青山電廠12號爐進行技術改造后進行了相應的燃燒調整試驗，試驗證明水平濃縮煤粉燃燒器技術的應用改善了機組的運行狀況。
  4. Mean while, the iouver concentrator structure principle is analyzed, the iouver puiverized coal concentrator is studied on the bases of both laboratory and production. lt is discovered from the experiments that the louver horizontai rich / lean combustion pulverized coal burner has advantages of simple in structure, low resistance and adjustment of pc concentration

    同時，重點分析了百葉窗濃縮器的結構原理，並在試驗臺上和現場對百葉窗煤粉濃縮器進行了大量的試驗研究，結果表明：百葉窗式水平濃淡煤粉燃燒器具有結構簡單、阻力損失小、分離調節方便等一系列優點。
  5. We offer perfectly matched mechanical, pneumatic and electronic system components for atmospheric and forced - air burner - heater units, condensing burners, forced - air burners, gas - fired motors and industrial, heating production processes and combustion systems

    我們提供最佳的機械氣動和電子控制系統元件，應用於大氣式和鼓風式燃燒加熱裝置冷凝式鍋爐鼓風式燃燒熱燃氣發動機以及工業產品熱工過程和燃燒系統。
  6. The influence to the boiler burner of air - surrounding - fuei combustion style is aiso researched

    介紹了水平濃淡可調燃燒技術，分析了風包粉煤粉燃燒方式對鍋爐燃燒的影響。
  7. Provides more uniform flow of fuel oil to burner for best possible combustion

    提高重油的流動性，取得最佳燃燒效果。
  8. Production test of the production line is showed that anneal furnace combustion system with regenerative radiant - tube combustor compare with conventional radiant tube burner not only have superiorities on saving energy and environmental protection but also have advantages on temperature distribution and temperature control properties

    生產線試生產的情況表明，退火爐燃燒系統使用蓄熱式輻射管燃燒器比使用常規輻射管燃燒器不僅在節能、環保方面具有優勢，而且在加熱均勻性和爐溫控制方面也有一定優越性。
  9. A combustion model has been built and burning process has been simulated by computer in blast furnace stove with ceramic grid - burner

    摘要建立了高爐熱風爐燃燒數學模型，應用計算機模擬研究方法對中空柵格陶瓷燃燒器的火焰形態進行了模擬研究。
  10. The paper introduced the run characteristics and their designed load performance of large - scale units with output of 200mw and over in hubei province, as well as their improved load performance after the modification of burner for low - load stable combustion

    摘要簡要介紹了湖北省200mw及以上大型燃煤鍋爐機組的運行特性、設計調峰性能，以及經過對燃燒器進行低負荷穩燃改造以後，調峰能力的改善。
  11. Mechanism of oil saving and steady combustion of sc - df burner and its application

    燃燒器的節油穩燃機理及應用
  12. By carrying on experimental study to the ignition performance of the natural gas high speed burners under different conditions, the influence factors are probed such as the type of the gas source, the combustion air pressure, the gas pressure, the proportion of air and gas, gas flow and electrode to the ignition performance of natural gas high speed burner

    摘要在不同的條件下對天然氣高速燒嘴的點火性能進行了實驗研究，探討了氣源種類、助燃空氣壓力、燃氣壓力、空氣與燃氣的比例、氣體流量、點火電極等因素對天然氣高速燒嘴的點火性能的影響。
  13. Combustion system of power plant boiler is taken as the research object of this thesis. the research mainly focuses on the faults of boiler combustion system, such as flame center deflection, powder feed inequality or break, primary air pipe jammed, spontaneous combustion, and backfire or kill in burner spout

    本文以電站鍋爐燃燒系統為研究對象，主要圍繞鍋爐燃燒系統運行中可能出現的爐膛火焰中心偏斜、給粉機下粉脈動、一次風管道內堵粉、自燃、燃燒器噴口回火、滅火等故障展開研究。
  14. In order to save oil for ignition and raise cyclic operation capability of utility boilers, eih for oil - free ignition and stable combustion is adopted to de ? gn the burner and experimental system in this thesis

    本文根據煤粉氣流的著火理論，針對火電廠節約點火用油和提高調峰能力，採用了電磁感應加熱無油直接點火與穩燃技術設計燃燒器結構和實驗系統。
  15. The lower nox combustion generates when the special designed gas reburning burner is used in the experiment

    利用特殊設計的煙氣再循環式燃氣燃燒器做實驗，發現得到較低的no _ x排放。
  16. Improves combustion in burner and increases efficiency

    改善燃燒狀況，提高燃燒效率。
  17. Boiler combustion efficiency is improved due to the retrofit for burner material, air flow adjustment mechanism and air direction of entering burner, and cold and hot commissioning

    通過對燃燒器材料、調風機構、進風方式及調節等方面進行改造，並經過冷、熱態調試后， # 1鍋爐燃燒狀況得到改善，經濟性得到提高。
  18. Effect of gear baffle on isothermal flow from radial bias combustion burner

    齒型擴口對旋流燃燒器流動特性影響的研究
  19. Through the experiments we can safely get the conclusion that the cyclone burner cannot only insure the complete combustion of cws, but also can reach the need of environmental protection. in comparison with the cold experiment ( including in the infinite field and finite filed ), numerical simulations were done using k - e standard model

    結合實驗結果，本文提供了在不同燃燒環境下，選擇水煤漿旋流燃燒器的各種依據，其既能保證足夠的迴流區和迴流量，使水煤漿能夠穩定的著火燃燒，又能保證有效的避免結渣。
  20. After combustion adjustment test, an optimized adjustment project is worked out. by analysis of mechanism of stable combustion of different burners, burners are modified according to principle of buner selection. after authentication and analysis of buner modification, combustion adjustment project is optimized again, burner modification scheme is validated

    通過對不同燃燒器穩燃機理的分析，確立燃燒器選型原則，實施了燃燒器改造，並對燃燒器改造情況進行了鑒定與分析，再次對燃燒器改造后燃燒調整的方案進行優化，制定了燃燒器整改方案和實施計劃。
分享友人
分享到 Line

分享到臉書