bypass pipe 中文意思是什麼
bypass pipe
解釋
旁通管-
To provide necessary data for design bypass pipe, an enlargement to bi liu river reservoir, the following problems have been studied by hydraulic model and theoretical analysis : the energy losses in water head of the bypass pipe system and of the flow - control valve and their scale effects, measurement and calculation of the discharge of the bypass pipe system during the bypass pipe system operation with and without the new water power station, the hydraulic characteristics of the water tunnel and draw - off pipe, the flow rate of the aqueduct bridge and the draw - off pipe and the water elevation of the flow in the aqueduct bridge during the old water power station operation with and without the new water power station
大連市碧流河水庫供水工程取水頭部由引水渡槽、節制閘、進水閘、泄水閘等建築物組成。由於本工程場地條件限制，增設旁通管后布置非常緊湊，管道急轉角度大且轉彎距離較小，對于管內水流流態是否滿足要求，需要經過模型試驗進行論證，以確保工程的可靠性。旁通管具有上水與泄水要求，對其過流能力也要經試驗確定，為碧流河水庫增建旁通管設計提供依據。 -
The paper analyzes the non - lineal relations of the quantity of heat exchange and water flux of coil exchanger in part - load operating condition, the shortage of deciding the water flux in bypass pipe, the disadvantage that the operating condition of pumps and chiller ca n ' t be met with the load change of the air conditioning system in different operating condition of using pressure - difference bypassing control in primary water pump system. using load control method in the change of the operating condition of primary water pump system can realize that the load change is small and reasonable in the on / off condition of pumps and m m chiller by comparing load control method in primary variable - flow water pump system with pressure - difference bypassing control method, back water temperature control method
本論文從目前空調工程中使用的變流量水系統入手，研究了盤管換熱器在部分負荷下水流量與換熱量的非線性關系，分析了文獻中介紹的旁通管通流能力選擇的不足之處和一次泵水系統採用壓差旁通控制時，工況轉換不能滿足系統控制要求的缺陷；比較了一次泵變流量水系統中壓差旁通控製法、回水溫度控製法、負荷控製法的精確性，並得出了在一次泵水系統的工況轉換時，採用負荷控製法能使冷水機組及其相應水泵在啟停時的負荷變化范圍較小，更符合建築物的冷量需求，節能效果較好的結論。 -
Seven body bosses provide purge, flush, drain or bypass connections. ( purge / flush shown. ) bottom boss is furnished with standard pipe threads
七個閥體凸起部提供清洗，沖刷，排泄或旁路連接。 （圖示為清洗/沖刷） 。底部凸起部配置標準管道螺紋。
分享友人