calculated feed 中文意思是什麼

calculated feed 解釋
計算入料
  • calculated : adj. 1. 有計劃的，有意的，故意的。2. （預備）供…之用的，合於…之用的。3. 算清了的；被預測出的。
  • feed : feed1fee 的過去式及過去分詞。vt 1 給…飲食，給…東西吃；給（嬰兒）餵奶。2 喂養，飼養，使吃草，放牧...
  1. Furthermore, referring to the literature and considering the specific experimental conditions given by the research, expression of the change of feed rate with time is presented, to obtain the linear growth of the diameter of pre - sintered glass beads, thus the distribution of beads size is relatively well controlled and raw material is spared in some extent. eventually, during the experiment discrete change of feed rate is implemented, and the practical changes of average diameter are plotted, then the results are compared with the theoretical calculated data

    另外，本文通過對造粒技術、燒結過程的大員文獻調研，結合本研究的具體情況，通過控制進料速率呈連續性變化，基本實現了燒結前球坯直徑的線性生長變化，從而更有利於實際生產中的產品粒度控制以及做到節約用料，並在試驗操作中以離散型進料速率變化來加以比較驗證。
  2. Experimental data agreed with those calculated the compositions of musks in the equilibria liquid phase were different from the feed, that is, musk ketone was richened in dimethyl sulfoxide ( or acetonitrile ) phase while musk xylene was richened in heptane ( or cyclohexane ) phase

    平衡雙液相中兩種麝香的比例不同於原料，兩液相中兩種麝香分別得到了富集，其中二甲基亞碸（或乙腈）相中富含酮麝香、庚烷（或環己烷）相中富含二甲苯麝香，這種液相分相可用於分離麝香混合物。
  3. To illustrate the effect of variable feed rate, the pressure and power draw changes with fluctuations in feed rate are calculated on the table below

    瞬間的壓力變化及峰值出現是由熔融粘度瞬間變化導致的。
  4. The combination of fdtd method with physical optics is also used to analyze paraboloidal reflector antenna in millimeter band. using fdtd method, we obtains precise near fields of the feed because the computing areas include all the feed structure. the current on the paraboloidal reflector can be calculated by using physical optics, and then the far field of reflector can be calculated

    在毫米波拋物面天線的分析計算中，把fdtd與物理光學法結合起來， fdtd用於具有精細結構的饋源及饋電波導一體計算，得到饋源的幅度和相位方向圖，以此為依據調整饋源結構，使饋源的幅度和相位方向圖為最佳狀態。
  5. When nals was used as the collector in the process, the optimal conditions were the ph of feed solution 5. 0 - 6. 0, air flow rate 100ml / min, the liquid column depths 20cm, the surfactant concentration determined by its cmc and feed concentration. under this condition, the 3 can be above 20. also, the optimal ph ( 5. 0 ) was calculated theoretically for the recovery of the cu ( ii )

    對以十二烷基硫酸鈉為捕集劑的泡沫吸附分離過程的工藝參數進行了研究，並得出本分離系統所確定的最佳工藝參數為： ph5 . 0 6 . 0 ，氣體流量100ml min ，液位高度20cm ，最佳表面活性劑濃度由其臨界膠束濃度和原料液濃度確定，此時（濃縮比）可達20以上；同時還從理論上推算出泡沫吸附分離銅的最佳ph值范圍為5 . 0左右。
  6. Abstract : the effect of powder feed height on the thickness and density of powder rolled strip was calculated by using " deduction from ends of strip ”. the critical feed height ensuring uniform thickness and density of strip has been obtained. the effect of apparent density on the critical feed height is given as well

    文摘:本文通過「帶材尾端反推法」計算出粉末軋制工藝中粉末堆料高度對粉末軋制帶材厚度、密度的影響，並得出保證帶材厚度、密度均勻的臨界堆料高度；同時指出了松裝密度對臨界堆料高度的影響。
  7. The result shows that the heat transfer coefficient within the hollow fiber module with laminar flow can be calculated based on the correlation. by analyzing the equation, it was founded that the heat transfer coefficient under laminar flow is almost independent of the feed flow rate. numerical simulation of temperature distribution in hollow fiber membrane module with laminar flow was carried out

    首先採用純水為研究體系，研究分析了中空纖維管內的傳熱系數，研究表明，纖維管內的流動屬于層流狀態，其邊界層傳熱系數可用關聯式來計算，由此式看出，層流狀態下，流速對傳熱系數的影響很小。
  8. The flow field and pressure drops in the hydrocyclone were calculated numerically based on the k - e model modified for anisotropy and simple algorithm. the effects of operating parameters such as split ratio and feed flowrate on pressure drop were analyzed. the calculate results was compared with those obtained in experiment

    因此，本文採用各向異性-模型及simple （ semi - implicitmethodforpressure - linkedequations ）演算法對水力旋流器內流場及壓力降進行了數值模擬，分別考察了溢流比、進料流量及溢流管幾何尺寸等對壓力降的影響，並把得到的數值計算結果與實驗值比較，證明本文的計算結果是可以接受的。
  9. Various methods for solving these problems are described. the design method of a serpentine feed is presented systematically. the key components are designed and calculated in detail

    本文系統地敘述了波導慢波線的設計方法，並給出了其中關鍵器件的設計，其中的耦合器設計得到了實驗驗證。
  10. The results showed that kp value increased with the increase of the initial concentration and ph value of the feed phase. the determined diffusion coefficient showed good agreement with the value that were calculated by the experiential equation given by castillo r. reactive extraction equilibrium constant kr increased with the increase of the initial concentration of the feed phase and the carrier concentration, while kr value increased slowly in the high initial concentration of the feed phase

    分配系數的研究結果表明，分配系數kp隨著料液苯酚濃度增大而增大，隨料液ph值增大而升高;採用多孔板法測定水相中苯酚的擴散系數，並將測定值與經驗公式估算值進行對比，結果表明，測定結果是可靠的;表觀反應萃取平衡常數kr隨著載體濃度升高而增大，隨著料液濃度的增加而增大，而在濃度較大時， kr增大趨勢變緩。
分享友人
分享到 Line

分享到臉書