calculation formula of 中文意思是什麼

calculation formula of 解釋
控制設備選用計算公式
  • calculation : n. 1. 計算,計演算法。2. 推定,預測。3. 深思熟慮,精打細算;慎重的計劃;算計。
  • formula : n (pl formulas lae )1 公式,程式;定則,方案。2 【醫學】配方,處方。3 (政治口號等的)提法,表...
  • of : OF =Old French 古法語。
  1. This text studies the origins and the development processes of the eva theory first, making reader have a clear picture of the domestic and international research the development condition of eva theory, then introduces the eva calculation formula of these oriels in details, and computes the adjustment item that eva need

    本文首先研究了eva理論的起源與發展過程,使讀者對eva這一理論的由來以及國內外的研究發展狀況有了一個比較清楚的認識,接下來詳細介紹了eva這一理論的計算公式,以及計算eva所需的調整項目。
  2. According to the calculation formula of the ratio of pile and soil of compound foundation bearing capacity, and base on the calculation formula of the ratio of pile and soil given in this thesis, the relation model of rayl eigh wave velocity and gravel pile compound foundation bearing capacity is deduced

    根據復合地基承載力應力比計算公式,基於本文提出的應力比計算模型的基礎上推導了瑞雷波速和碎石樁復合地基承載力之間的關系模型,建立了日本模型、武漢地區模型、下遼河平原模型三種模型的碎石樁復合地基承載力計算公式。
  3. Based on the theories described above, calculation formula of general dimension of least square measure and multi - fractal fault diagnosis and analysis system have been established with borland c + + builder 5. 0, and checked by pure sinusoidal and cosine signal and sinusoidal signal with noise, and verified by the examples

    基於上述原理,建立了最小二乘法的廣義維數計算公式,用borlandc + + builder5 . 0編制了以廣義維數計算分析為基礎的多重分形故障診斷系統,並對標準的正弦信號、餘弦信號及帶有噪聲的正弦信號進行了驗證。
  4. First, using strip - partitoning method and programming in matlab language, the numerical caculations of the relation curve between moment and curvature are done for the beams strengthened with non - prestressed and pretressed cfrp sheets, base on the assumption of plane section, non - bonding slip and non - peeled destroy. secondly, nolinear finite elemeant analysis by ansys are done for the beams strengthened with prestressed cfrp sheets base on the three assumptions before mentioned, the analysis are all done for the relation curve between load and displacement, the distribution of material stress, the distribution of cracks. lastly, calculation formula of flexural capacity and deflection are proposed

    )的全過程關系曲線。其次基於上面的三個假定,選擇合理的本構關系,利用ansys通用有限元分析程序對預應力碳纖維布加固梁進行非線性有限元分析,分析了加固梁的荷載-撓度關系、材料的應力情況、裂縫的分佈情況等。最後提出了承載力計算公式和正常使用狀態下撓度計算公式。
  5. Abstract : a manufacture method of a major diameter circline weldless u - expansion joint by hydrostratic forming is introduced, a calculation formula of loading with hydrostratic forming is given by stress analysis

    文摘:簡要介紹了液壓成型大直徑無環焊縫u形膨脹節的方法,通過應力分析,給出了液壓成型的加載內壓計算公式。
  6. In order to use the strength and toughness index for design and apply of sfrc unified theoretical calculation formula of reinforcing and toughening of sfrc is given. experiments on bending toughness, breaking toughness and cube strength test results are carried out in connection with various kind of deformed steel fiber

    初步給出建立鋼纖維混凝土增強、增韌統一理論計算公式思想,為鋼纖維混凝土強韌雙重指標在設計、選用鋼纖維混凝土中的應用打下基礎;針對不同種類異形鋼纖維進行了彎曲韌性、斷裂韌性、立方體抗壓強度等試驗。
  7. Based on the analysis of pool water evaporation heat transfer and the sensible heat transfer between indoor air and pool water, deduces the calculation formula of latent load by pool water evaporation

    摘要通過對游泳館內池水蒸發換熱及池水與室內空氣之間的顯熱換熱分析,推導出池水蒸發潛熱負荷計算公式。
  8. In the theoretical description of grazing emission fluorescence, the mode of fluorescence intensity emitted from layered materials dependence of grazing angle is established by applying asymptotic approximations to double fourier integrals, and the theoretic calculation formula of fluorescence intensity from a thin layer is derived. by the derived expressions, the theoretic simulation curves of several thin layers on si substrate are calculated. in the experimental setup, the requirement of construction of the setup and some important parameters are brought forward

    最後,利用平穩位相方法建立了掠出射情況下薄層樣品產生的熒光強度和掠出射角的對應關系數學模型,推導了薄層樣品熒光強度理論計算公式,並以此為依據模擬計算得出了cr 、 fe 、 ti和ni等幾種以si作基底的單層薄膜樣品的熒光強度隨掠出射角變化的理論曲線。
  9. The fluxion model of gas and the gas pressure formula were decided in the surrounding of bore wall firstly, and according to the relation of gas content and gas pressure, the theory calculation formula of gas loss quantity was deduced, and finally, the revision method of original coal gas pressure was brought

    摘要首先確定了孔壁周圍瓦斯的流動模型及瓦斯壓力表達式,進而根據瓦斯含量與瓦斯壓力的關系,推導出了瓦斯損失量的理論計算公式,最後提出了瓦斯壓力的修正方法。
  10. In this paper, determining method of stress distribution was investigated. various stresses are superposed to deduce the calculation formula of stress distribution

    本文研究了瓷套的應力分佈的確定方法,將多種應力疊加在一起,推出了應力分佈參數的計算公式。
  11. Gives a calculation formula of the absolute error of specific frictional head losses

    給出了湍流區沿程阻力系數絕對誤差的計算式。
  12. Abstract : three theory problems about technology of leather making are discussed. the first is the difference between surface charge and isoelectric point ( pi ). the second is about the origin of the calculation formula of basicity in making cr3 + liquor. the third is the swelling mechanism of a skin or hide in basic medium

    文摘:本文討論了皮革製造中的三個理論問題,一是表面電荷與電點( pi )之間差別,二是三價鉻鞣液配製中公式的簡單來源,三是生皮在堿液中膨脹的機理。
  13. Abstract : through the geometric factor analysis of main cable in erection, the calculation formula of internal force of main cable is given and the analysis method of main cable safety is also discussed in detail

    文摘:通過對纜索吊裝設備主索的幾何因素分析,給出了主索的內力計算與驗算公式,結合示例詳細介紹了主索安全度分析方法。
  14. Based on the test data of air chamber pushrod force - stroke, a computation model a bout air chamber pushrod force - stroke was established, and calculation formula of actuation deformation characteristics of the drum brake was proposed according to test data

    摘要以制動氣室推出力行程試驗數據為基礎,建立了氣室推桿力與行程的計算模型,根據試驗數據提出了鼓式制動器的促動變形特性的計算公式,用試驗方法解決了制動器推桿總行程過大的生產實際問題。
  15. The calculation formula of seepage tensor to the model of non - linear seepage with the area of karst conduit in the whole coordinate axis is deduced. on the basis of galerkin finite element method, the equation of finite element with the non - linear seepage of groundwater is educed, on the foundation of this information, the program of karcon. for is compiled

    推導出整體坐標系下巖溶管道區非線性滲流模型滲透張量計算公式,基於galerkin有限元法,導出了地下水非線性滲流的有限元方程,在此基礎上編制了計算程序karcon . for ,將該程序用於典型模型的計算分析,結果表明該方法是合理的。
  16. From the point of view, a new calculation formula of background value is proposed, and the improvement could make the gray model have the ability to optimize the modeling so as to obtain the optimal results

    同時引入概率論的知識,並結合馬爾可夫模型動態的預測將來各年的經營狀況以及各種狀況的概率,以提高預測的精確性。
  17. By the analysis of several gas forces in the twin - scroll compressor, the calculation formula of working volume and all different crank shaft angle are derived

    摘要分析了雙頭渦旋齒渦旋盤所受的各種氣體力,提出了在任意曲軸轉角下的各種氣體力及工作腔容積的計算公式。
  18. The derivation of the leakage flow rate formula of the special annular clearance between the piston and cylinder under condition of variable viscosity in the axial piston pumps was carried out. at same time, considering the questions of the eccentricity and the variable sealing length of piston friction pair, the modified coefficient of the calculation formula of the flow - rate of the leakage was given

    在變粘度、柱塞偏心以及變密封長度條件下,對軸向柱塞泵中柱塞與缸孔之間的特殊圓環縫隙的泄漏流量公式進行推導,得到了該計算公式的修正系數; 6
  19. In this paper, we study the influence factors about acid - base titration jump and the stoichiometric point deducing approximate calculation formula of acid - base titration. some useful results are obtained

    摘要本文推導出了強酸強堿、一元弱酸弱堿、多元弱酸弱堿滴定突躍、化學計量點的近似計算式,用公式說明了影響滴定突躍的因素及化學計量點的位置,並得出了一些重要結論。
  20. Based on the analysis of the stress distribution law in different districts around the self - closed and full - connected arch walling support roadway, the relationship among the limit equilibrium radius and the in - situ rock stress, the physico - mechanical properties and support parameters is obtained. the calculation formula of arch walling width design is put forward so as to provide a theoretical basis for the practical design of support

    在分析自封閉全接觸碹體支護巷硐周圍不同區域應力分佈規律的基礎上,得出了圍巖極限平衡區半徑同巷硐所處的原巖應力,圍巖本身的物理力學性質及碹體支護參數間的相互關系,提出了設計碹體厚度的計算公式,為實際進行支護設計提供了理論依據。
分享友人