calculation program 中文意思是什麼

calculation program 解釋
計算程序
  • calculation : n. 1. 計算,計演算法。2. 推定,預測。3. 深思熟慮,精打細算;慎重的計劃;算計。
  • program : 按遺傳密碼工作
  1. A 3 - d simulative calculation program concerning temperature field and creep stress field and its pre - processing and post - processing has been developed. by applying this program, temperature field and creep stress field of hydraulic culvert and sluice engineer concrete is simulated. 2

    開發了非穩定溫度場和應力模擬計算的三維有限元計算程序及有限單元法的前後處理程序,運用此程序對水工涵閘工程混凝土進行了溫度場和應力場的計算分析,得出相關結論。
  2. So according to the technology regulation of reclamation engineering, hydraulic calculation must be carried out in the design of final closure. this paper firstly introduces the progression and present situation of reclamation engineering, emphasizing on the features of present reclamation and on the experiences and theories of home and abroad ; using fortran perfects the hydraulic calculation program of the closure and makes the program to meet different conditions ( such as considering flood, the variation of time interval, multi - entrance, multi - reservoir capacity ), and after comparing and analyzing a great deal of schemes, the reasonable computation scheme was brought up ; the interface of the program was carried out by the programming language vb to make the process of calculation become easier and more distinct, so the result can be analyzed and handled more directly ; vb is used in the later management of the result to plot the graphic chart of the isoline of the maximum of hydraulic element ( the velocity of flow, the drop height and the rate of flow ) automatically ; finally it was applied in the reclamation project of dongbidao of fuqing

    本文首先介紹圍海工程的發展進程與國內外圍海的開發現狀,重點介紹了我國目前圍海工程的特點及在圍海工程實踐中積累的經驗和理論;利用fortran語言完善堵口工程龍口水力計算程序,使程序可以滿足圍海工程復雜工況下(如考慮內港洪水、計算時段的變化、多口門、多庫容、多水閘)的龍口水力計算,並進行大量方案的比較和分析,提出合理計算方案;利用面向對象的可視化編程語言vb進行界面開發,使計算過程有良好的人機界面,更直觀地對計算結果進行分析和處理;計算結果的后處理採用vb編程實現龍口水力要素最大值等值線圖的繪制;並運用所編軟體對福建省福清市東壁島圍墾工程進行龍口水力計算,為堵口合龍提供科學依據。
  3. In addition, using the rough quantum theory of gravity, the quantum form of gravitational radiation in weak field is discussed, which is coincident with the classical results, and the calculation program does not need many operators

    另外本文採用簡化的量子觀點討論了弱引力場引力輻射的量子表述,計算過程並未涉及大量的算符運算,而且運算結果表明它與經典小參數法得到的相應輻射形式是自洽的。
  4. The best compression ratio and fuel injection advance angle are calculated through mess optimization calculation program of language c. on the basis, optimization simulation of inlet and exhaust timing has been carried with the diesel engine working model to increase diesel engine ' s volumetric efficient

    在此基礎上,利用柴油機工作過程模型,對進排氣正時進行了優化計算,以提高柴油機的充氣效率,改善燃燒性能,為進一步改善該機性能指明了方向。
  5. All of the researches are carried out on the background of a spatial continuous beam - arch composite bridges, and the relative loading experimental results are compared with the calculated values. it indicates that the theory of elastically supported continuous beam method load lateral distribution is a kind of simple convenience and safe practical engineering calculation method. 2 ) the suspender force and correlated modality is analyzed with the use of general calculation program ansys. during testing suspender force, the influence of the rigidity of suspender must be considered

    在此基礎上,以一座實際的預應力混凝土連續梁拱組合體系橋梁為工程背景,採用一般的試驗研究方法對該橋進行了荷載試驗研究,並將有關的荷載試驗結果與理論計算值作了比較,結果表明:所提出的彈性支承連續梁法計算值,與空間有限元分析理論值及荷載試驗測試值基本吻合。
  6. In this model, the peak of flood, flood total outflow and flood process are to be considered. a calculation program with monte - carlo method and a simplified method for calculating diversion risk are suggested

    在該模型中,可考慮水文中的洪峰流量、洪水總量和洪水過程的不確定性及水力的不確定性,提出了用monte - carlo方法計算施工導流風險的步驟和用近似法計算施工導流風險的方法。
  7. We present a calculation program in this paper, based on the physical optical theory ( po ) theary to predict bse and bses for a conical type of radome. the po theory is used to determine the ficticius currents electrical and magnetic on the inner face of the radome, which is illuminated directly by the radar antenna, and then use the transmission matrix mothod to determine the outer surface ficticion currents, the radiated from the antenna through radome is considered as the radiation field of these ficticion current

    本文提出了一種基於物理光學理論預測正圓錐天線罩瞄準誤差及瞄準誤差斜率的計算程序。首先,雷達天線照射到天線罩內壁,應用物理光學法求出內壁等效的電流和磁流,其次,根據傳輸矩陣理論求出外壁等效電流和磁流,天線通過天線罩的遠區場即可認為是外壁等效電、磁流產生的場。
  8. A calculation program is made and an accurate convenient software is offered to engineering design

    編制了計算程序,為工程設計提供了一個計算準確、使用方便的計算軟體。
  9. According to the diverse current state of a tilting gate, the flux calculation program was worked out to calculate the flux at different current state of the gate and to protract the curves of flux to upper reaches of the gate

    根據翻板閘門的不同水流流態,編制過閘流量計算程序,計算各流態的過閘流量,並繪制了過閘流量與上游水位關系曲線。
  10. This program can predict the wall temperature 、 internal wall heat tranfer coefficient 、 fluid temperature and entropy profile along the water wall. all of these provide an important foundation for designing this type of water wall structure to ensure the safety of the boiler operation. this hydrodynamic calculation program and the results can be used to analyze operation reliability and structure design of water wall system

    利用所開發的程序對設計的超臨界cfb進行了計算,給出不同負荷下,水冷壁出口工質溫度分佈,水冷壁受熱面不同位置處的金屬壁溫、內壁放熱系數、流體溫度焓值分佈,以及不同管子的流動壓降等結果,為分析鍋爐工作可靠性及水冷壁系統的結構設計提供了重要依據。
  11. The elastoplasticity finite element calculation program dfem is successfully developed, which is based on damage mechanics model

    成功地開發了基於損傷力學模型的彈塑性有限元計算程序( dfem ) 。
  12. Theory research based on overrelaxation : according to electromagnetic theory fundamental equation, boundary condition is analyzed, iterative formula is deduced, overrelaxation factor is selected and calculation program is composed. through calculation on varied parameter, a group of suitable parameter is found out. in the third chapter : the conclusion of theory research is verified through experiment

    理論研究使用超鬆弛迭代法:根據麥克斯韋電磁理論基本方程,建立了磁場浙江大學博士學位論文:行程傳感液壓缸基礎技術的研究分析數學模型,分析了邊界條件,推導了迭代公式,確定了鬆弛因子,編制了運算程序,通過對不同參數的試算,找到了一組有規律參數之間的關系。
  13. Under consideration of the effects of the life time of nd : yag lower level on extracted energy from amplifier, a numerical model and calculation program incorporated the effects of the pulse width on amplifier energy extraction is proposed. the calculated results are compared with the experimental data of a slab mopa dpl system setup previously and then the model is modified according to experimental results

    考慮到nd : yag激光下能級壽對放大器能量提取的影響,建立了脈寬對放大器能量提取影響的數值計算模型及程序,計算結果與已建立的板條mopadpl系統的實驗數據進行了比對並對程序進行了修正,提高了程序的可靠性。
  14. Calculation program of thermodynamic properties of refrigerants in the simulation of refrigeration system

    製冷系統模擬中的工質熱力性質計算程序
  15. The calculation program using the matlab has been worked out to get the numerical solutions of the proposed models. the experiment has first been conducted in the laboratory to get the fundamentals thermal and moisture properties ( such as materials density, specific heat capacity and thermal conductivity ) and also the material moisture absorption isotherms of adobe building materials. the methods of measuring the surface mass transfer coefficient and material moisture content have been proposed

    首次對生土建築材料物性參數進行了實驗測試,得到了常用生土建築材料的密度、比熱和導熱系數等參數值,得到了生土建築圍護結構的等溫吸濕平衡曲線的擬合函數關系式;此外,研究了生土建築圍護結構表面質交換系數實驗測定方法,探索了利用電阻率測量生土建築圍護的安窪築科技人學博十學位論文結構內部含濕量的測試方法。
  16. Based on the wall temperature of hollow wire, the further calculation program has been given. it account for the complexity of the stator ' s structure and can be used in the calculation of the temperature distributions in arbitrary cross section of windings

    在空心導線壁溫分佈計算方法確立的基礎上,充分考慮到定子線棒結構的復雜性,採用有限差分的方法編制了通用性較強的線棒截面溫度分佈計算程序。
  17. Then establish the equation, a complete calculation program using c language is drawn up

    運用c語言編制計算程序,計算出末敏彈各個運動參數的值。
  18. The main results of research in this paper are : the stability and accuracy of the fem calculation program are validated with the reference of the test report on the leading operation of 1 # generator in fengzhen power station

    本論文主要研究成功如下: 1豐鎮電廠1 #發電機進相運行試驗技術報告為參考,驗證了有限元計算程序在計算200mw發電機時的可靠性和精確性。
  19. With the equation for water vapor transfer in unsaturated soil the thesis deduces the equation for liquid water transfer, and then puts forward the coupled calculation method for water vapor and liquid water transfer together, and then build the difference calculation program to realize the coupled calculation under the one - dimension and constant - temperature condition, and put the program into practice with the experiment conditions, the calculation result tallies well with the experiment data, the facts proves the reliabilities of theory deduction and the feasibility of coupled calculation method

    最後論文結合非飽和土氣態水遷移引起的含水量變化方程,推導了液態水遷移引起的含水量變化方程,提出了非飽和土考慮氣態水和液態水混合遷移的計算方法,編制差分計算程序實現了一維恆溫條件下液態水和氣態水的禍合計算,並將程序結合試驗條件進行了應用,計算結果與試驗結果較為吻合,表明了理論推導的可靠性和禍合計算思路的可行性。
  20. Conomic analysis model. this model has mainly four peculiarities as follows : 1. he method of large systems resolution, assemble and gradational development is used, therefore, the dimensions of the calculation program is reduced

    本模型系統主要包括了以下三個部分: 1 、支流及非控制區模擬模型2 、幹流模擬模型3 、經濟評價模型本模型系統主要具有以下特點: 1 、採用了大系統分解、集成、分層次開發的方法,對支流和幹流模型分級開發,減小了計算模型的規模。
分享友人