carbonization temperature 中文意思是什麼

carbonization temperature 解釋
碳化溫度
  1. The degree of carbonization of coal depends on the temperature.

    煤層的炭化程度取決于溫度。
  2. The results showed that : there were five stages in the rising process of the internal temperature of untreated, fire - retardant solution soaked, and fire - proof paint coated wood during the fire ; the carbonization rate of wood decreased by 21. 1 % ~ 35. 6 % and the rising speed of internal temperature also declined greatly when wood was soaked in fire - retardant solution or coated with fireproof paint ; the carbonization rate of white pine was 8. 5 % ~ 17. 4 % higher than that of the northeast china ash ; for untreated wood, the carbonization rate in tangential direction was 5. 8 % ~ 10. 5 % higher than that in radial direction ; the internal temperature of wood varies with the developing direction of combustion

    結果表明：火災發生過程中未處理木材、阻燃浸漬處理和塗刷防火徐料木材內部溫度上升過程出現5個階段；經過阻燃浸漬處理和塗刷防火塗料后，木材的燃燒炭化速度降低了21 . 1 % ~ 35 . 6 % ，內部溫度上升速度大幅度下降；白皮松木材的燃燒炭化速度比水曲柳木材的燃燒炭化速度快8 . 5 % ~ 17 . 4 % ；未處理木材沿弦向的燃燒炭化速度比徑向快5 . 8 % ~ 10 . 5 % ；木材內部的溫度變化沿燃燒推進方向不同而不同。
  3. The results show : ( 1 ) around 600 is a key carbonization temperature for bamboo

    結果表明： （ 1 ） 600左右是竹材炭化的一個非常重要的熱處理溫度。
  4. The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of

    對于碳化工藝，側重研究了碳化時間、反應室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影響，研究結果表明:隨著碳化時間的增長，碳化層的晶粒尺寸隨之變大，表面粗糙度隨之降低，但當碳化到一定時間之後，碳化反應減緩，碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應室氣壓的升高而變大，適中的反應室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小時，碳化層的晶粒尺寸隨氣體流量的變化不明顯，但當氣體流量增大到一定程度時，碳化層的晶粒尺寸隨氣體流量的增大而明顯變大，同時，適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低時，碳化層的晶粒取向不明顯，隨著碳化溫度的升高，碳化層的晶粒尺寸明顯變大，且有微弱的單晶取向出現，但取向較差，同時，適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ，以ch _ 4作為c源氣體時得到的碳化層表面平整得多;比起si （ 100 ） ，選用si （ 111 ）作為基片生長的碳化層的晶粒取向一致性明顯更好。
  5. This paper put forward some opinions of electrode char distributive proportion and measurement of gray - king low temperature assay and compared it with carbonization test in aluminium retort

    摘要主要針對格金低溫干餾測定中的電極炭配比、稱量等問題提出見解，並與鋁甑方法進行了對比。
  6. At the bottom of drier, where is high temperature area, heatsensitivity raw material can not contact with heat surface directly, therefore it solves the carbonization and color charge problems of heat sensitivity raw material

    在乾燥機底部高溫區，熱敏性物料不與熱表面直接接觸，並裝有特殊裝置，解決了熱敏性物料的焦化變色問題。
  7. By increasing the h2 dilution ratio, it is found that atomic hydrogen can selectively etch amorphous phase and stabilize crystalline phase. from the study on the distance from substrate to catalyzer, choosing a proper distance can ensure the gas fully decomposed, while a relatively low substrate temperature can cause the nanocrystalline particles to lose mobility and keep their sizes. the pre - carbonization process can enhance the nucleation density and make the growth of high quality nanocrystalline p - sic films much easier

    實驗結果表明：隨著工作氣壓的減小，薄膜的晶粒尺寸有所減小；通過提高氫氣稀釋度，利用原子氫在成膜過程中起的刻蝕作用，可以穩定結晶相併去除雜相；選擇適當的熱絲距離能保證反應氣體充分分解，又使襯底具有較高的過冷度，是形成納米薄膜的重要條件；採用分步碳化法可以提高形核密度，有利於獲得高質量的納米- sic薄膜；襯底施加負偏壓可以明顯提高襯底表面的基團的活性，因負偏壓產生的離子轟擊還能造成高的表面缺陷密度，形成更多的形核位置。
  8. Pakistan ' s coal, because of its high content of volatile matter and non - coking properties, is to be carbonized in a low temperature carbonization plant

    由於含有大量揮發物及具有非焦化性，巴基斯坦的煤需要在低溫碳化裝置中加以碳化。
  9. Xiangjun bamboo floor according to surface layer bamboo strip arrangement structure and whether can divide into undergo high temperature and carbonizated processing was divided into : even pressure, side thrust ; to the festival, disperses the festival ; true colors, carbonization and so on several big series products

    「湘君」牌竹地板根據面層竹條排列結構和是否經過高溫碳化處理可分為：平壓側壓對節散節本色碳化等幾大系列產品。
  10. The volume expansion played a major role in determining its magnetic properties. complicated magnetic phase transitions induced by external magnetic field were found in carbonization of lafe _ ( 11. 4 ) al _ ( 1. 6 ) compound with low carbon concentration. and the temperature of phase transition depends on magnetic field strongly

    同時發現，碳含量較低時， lafe _ （ 11 . 4 ） al _ （ 1 . 6 ）碳化物在磁場誘導下呈現出有趣的復雜磁相變，相變溫度強烈依賴于外加磁場。
分享友人
分享到 Line

分享到臉書