cavity effect 中文意思是什麼

cavity effect 解釋
空腔效應
  • cavity : n. 1. 【解剖學】穴,窩,盂,腔,空腔;【醫學】(空)洞。2. 【物理學】模槽;氣蝕區;空腔諧振器;【原子能】(反應堆中的)小室,暗盒。
  • effect : n 1 結果。2 效能,效果,效力,效應,作用,功效;影響。3 感觸,印象;外觀,現象。4 旨趣,意義。5 ...
  1. What should point out is, a little venereal pathogen is likely from the eduction of ill cutting position beyond the penis, vagina, if transmit luetic hard chancre to be able to grow the other place in the body, bleb of acuteness wet wart, genital is ok autoinoculation, also can grow to wait for place in oral cavity, so although condom has protective effect, but also have certain limitation

    應該指出的是,有些性病病原體可能從陰莖、陰道以外的病損部位排出,如傳播梅毒的硬下疳可以長在身體的其它部位,尖銳濕疣、生殖器皰疹可以自體接種,也可以長在口腔等部位,所以避孕套雖有保護作用,但也有一定的局限性。
  2. Mastoid plombage and cavity of concha formation on the effect of radical mastoidectomy

    耳甲腔成形及乳突腔充填術在乳突根治術中的應用價值
  3. Observation on the clinical effect of cystostomy drainage in the place of thoracic cavity close drainage

    膀胱穿刺造瘺管替代胸腔閉式引流管效果觀察附32例報告
  4. Periodontal diseases don t only have effect on our oral cavity

    牙周疾病對健康的影響並不止於口腔。
  5. 4 ) in a pre - swirl rotator - stator cavities with discrete pre - swirl nozzles and blade - cooling entry holes, the influences of pre - swirl angle and flow parameter on the flow and heat transfer characteristics were numerically investigated. the correlation for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established. the results show that : advantage of per - swirl inflow is the effect of cooling the blade - cooling entry holes ; pre - swirl inflow increases heat transfer in rotating disk of pre - swirl chamber ; as pre - swirl angle increases, local nusselt number decreases in pre - swirl chamber ; the temperature of stator of inner rotator - stator chamber and per - swirl chamber decreases as rotating reynold number increases ; when the axial mass flowrate maintains constant, heat transfer in the rotating disk of inner rotator - stator cavities does n ' t change as per - swirl mass flowrate increases, while heat transfer in the rotating disk of per - swirl chamber increases ; when the pre - swirl mass flowrate maintains constant, change of the axial mass flowrate has effect on the whole cavity

    結果表明,預旋進氣的優點在於增強了葉片冷卻孔附近的對流換熱效果,局部努謝爾數隨預旋角的增大而有所減小;隨旋轉雷諾數的增加,不論是內轉靜腔室還是預旋腔室的靜盤上的溫度都不同程度的降低:當軸向中心進氣質量流量不變時,隨預旋進氣的質量流量增加,內轉靜腔室的轉盤盤面上的換熱基本沒有變化,而預旋腔室的轉盤盤面上的換熱效果增強;當預旋進氣質量流量不變時,軸向中心進氣的質量流量的改變對整個盤腔都有影響。
  6. Effect of sodium bicarbonate gargle on the prevention of fungal infection in oral cavity in patients with leukemia after chemotherapy

    碳酸氫鈉液漱口預防白血病病人化療后口腔真菌感染的效果
  7. The linear and nonlinear optical properties of these compounds have been systematically studied. the following parts are included in this thesis : one - photon and two - photon fluorescence ; upconversion superradiance and cavity lasing properties ; the optical power limiting effect of these compounds ; and so on. tpa absorption coefficients have been got by z - scan method

    3 、系統研究了它們的線性和非線性光學性質,主要包括:單、雙光子熒光,上轉換超輻射和腔激射性能及其效率,光限幅效應,用z - scan的方法得到了其雙光子吸收截面。
  8. Effect of high aluminum algaas oxidized layers on vertical - cavity surface - emitting lasers

    的激光二極體線列陣光纖耦合器件
  9. We call the new quantum phenomenon that ca n ' t be explained by classical theory non - classical feature of cavity field. it has been proved by experiment, that quantum states of cavity field can exhibit three non - classical features, i. e. photon antibunching effect, sub - poissonian statistics distribution, and squeezed states

    在光場與原子相互作用的過程中會出現某些不能為經典理論所解釋的新的量子現象,人們統稱這些現象為光場的非經典效應,目前實驗上所觀測到的非經典現象有光子的反聚束效應、亞泊松分佈和光場的壓縮效應。
  10. Methods one hundred and twenty residual crowns and roots of short molars were restored with casting cavity - retention form post - core crown and followed up for 2 ~ 5 years to observe the clinical effect

    方法:對120顆短磨牙殘根殘冠應用洞固位形鑄造樁核冠修復,對其臨床效果隨訪2 ~ 5年。
  11. The influences of foundry process and method factors on combination effect was investigated including the influences of gating system design, pouring temperature, atmospheric pressure of mould cavity, thickness of cast - penetrated layer and so on

    作者就澆注系統、澆注溫度、型腔氣壓、鑄滲層厚度等工藝參數對鑄滲效果的影響進行了試驗研究。
  12. On the basis of the experimental research, its hysteresis characteristics, calculation method of stiffness in different stage and ultimate bearing capacity are discussed. based on a seismic design method on the new lateral resistant system is concluded according to the research result in the paper. the effect of some parameters is discussed on steel frame with cavity sandwich wall infill and some design suggestion is presented

    在試驗研究的基礎上,建立了該體系的恢復力特性模型,提出了模型各受力階段的剛度計算公式、極限承載能力的計算方法和抗震計算方法;對影響空腔結構砌體填充墻鋼框架抗側力性能的因素進行了討論,提出了設計建議。
  13. Second, we compute the self - impedance through cavity modal theory and mutual impendance based on reaction theory respectively. then the generalized impedance matrix that reflects the effect of mutual coupling is formed. at last, the effect of mutual coupli ng on 2 - d doa estimation algorithms is investigated and two efficient methods of mutual coupling compensation are proposed

    本文首先對兩種二維doa估計演算法? ssm法和二維酉esprit法的性能進行了比較,用空域平滑演算法解決了相干源的二維doa估計;其次運用腔模理論計算微帶天線的自阻抗,用反應原理計算微帶天線間的互阻抗,進而形成計入互耦影響的廣義阻抗矩陣;討論了互耦對二維doa估計的影響,提出了兩種互耦補償的方法。
  14. Conclusion rectifying treatment of the cavity after ess is necessary to patients who fail to be followed - up actively and is necessary to improve the curative effect of ess and the avoidance of revision ess

    結論鼻竇內鏡手術后術腔未按時清理的矯正性治療可矯正鼻竇內鏡手術后連續一定時期內未主動隨訪所致術腔的再生病變,提高治愈率。
  15. Temperature field of hollow ingot solidification is simulated by fem. to different mould, effect of heat transfer coefficient between inner sleeve and cooling medium and thickness of core refractory on final position of solidification, the highest temperature of inner sleeve against cooling medium, and shrinkage cavity and porosity are compared. in addition, change of temperature in typical position of core refractory is also compared

    對空心鋼錠凝固過程的溫度場進行了有限元分析,對不同錠型結構的芯部換熱系數、耐火材料厚度對最終凝固位置、內筒壁最高溫度及縮孔疏鬆的影響進行了對比,並討論了耐火材料典型部位的溫度隨凝固時間的變化。
  16. Abstract : temperature field of hollow ingot solidification is simulated by fem. to different mould, effect of heat transfer coefficient between inner sleeve and cooling medium and thickness of core refractory on final position of solidification, the highest temperature of inner sleeve against cooling medium, and shrinkage cavity and porosity are compared. in addition, change of temperature in typical position of core refractory is also compared

    文摘:對空心鋼錠凝固過程的溫度場進行了有限元分析,對不同錠型結構的芯部換熱系數、耐火材料厚度對最終凝固位置、內筒壁最高溫度及縮孔疏鬆的影響進行了對比,並討論了耐火材料典型部位的溫度隨凝固時間的變化。
  17. Under the cylindrical coordinate, the transit - time effect of the radial gap in the resonance cavity of rtto is studied by hydrodynamic theory. the equation describing the interaction between the electron beam and the high frequency field is obtained

    在柱坐標系統中,我們用流體理論方法分析了rtto諧振腔間隙的渡越時間效應,得到了在有限渡越角情況下電子束與高頻場相互作用的方程。
  18. This paper studies the diffuser ' s influence on the fadw ' s running properties experimentally including the inner wall and outer wall of diffuser and the backpressure of the diffuser. to prevent the gas of fadw from leaking into the laser cavity because of the effect of layer and turbulence the leak - proof flakes are designed. first the method of the leak - proof flake design is studied and then its influence on the properties of fadw is studied experimentally

    實驗研究了擴壓器對fadw工作性能的影響,提出了擴壓器結構和超音速噴管相對布局參考數據;研究了氣動窗口側壁防漏片的結構對氣動窗口性能的影響,並給出其工程設計方法;同時還研究了擴壓器不同的背壓對整個fadw作性能的影響,據此提出了擴壓器與引射器結合的設計方案,從而為大壓比、高性能的fadw的設計提供了進一步設計參考方法。
  19. Study on the pipe cavity effect of pressure sensor

    壓力傳感器管腔效應問題研究
  20. 4. an approach to realize all - color display is using micro - cavity effect for polymer led

    實現全色顯示的一種有效方法就是利用微腔來控制發射波長。
分享友人