charge temperature 中文意思是什麼

charge temperature 解釋
首火溫度
  • charge : vt 1 填；裝（子彈）；充（電）；使飽和；使充滿；堆積，裝載。2 命令；促；諭示，指令。3 責備；告誡。...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. At a definite temperature a mesoscopic circuit isnt in a determinate quantum state instead of in the mixed state ( or statistical state ). using the density matrix of the canonical ensemble, we have deduced the formulate of the quantum fluctuations of both charge and current in a non - dissipative mesoscopic coupled circuit. and the dependences of the quantum fluctuation of the circuit on its temperature have obtained

    在有限溫度下，介觀電路系統實際上並不處在一個確定的量子狀態，而是處在混合態.根據正則系綜的密度矩陣導出耦合互感電路中電荷和電流的量子漲落，得到了量子漲落與溫度的依賴關系
  2. The experiment results indicated that by application of new control strategy, the charging efficiency was raised to about 90 %, the charging period was reduced to within 2 hours, and there was no apparent electrolyte temperature - rise, which means high efficiency, fast and damage - free charge is realized

    實驗表明，採用新型控制策略的充電過程可使充電效率提高到90左右，充電時間縮短到2小時以內，蓄電池電解液的溫升較之常規充電亦沒有明顯升高，實現了高效、快速、無損的充電思想。
  3. Space charge properties of frp rod materials are influenced by temperature, field strength and high voltage application duration

    結果表明，在高壓直流電場作用下，芯棒材料內部積累的空間電荷的極性和密度受到溫度、電場強度和電場作用時間等因素的影響。
  4. Temperature and phase changes in the gel could also be harnessed to charge a battery

    而膠體中的溫度和相性的改變能被利用來對電池充電。
  5. The main reasons causing increased chilling tendency of nodular iron are as follows : using metal charge containing trace and alloy elements which can increase chilling tendency ; molten iron being holded at high temperature too long ; abnormal nodularizing and / or inoculation treatment, as well as abnormal composition control

    摘要引起球鐵白口傾向大的主要原因是：爐料穩定性差、電爐保溫、球化處理及鐵液成分控制和孕育處理出現異常。
  6. The reasons causing gun propellant charge temperature coefficient and the methods of reducing charge temperature coefficient and increasing gun projectile muzzle velocity have been studied

    研究了火炮裝藥溫度系數形成的原因以及降低火炮溫度系數提高彈丸初速的基本原理和措施。
  7. 4. through the galvanostatic charge / discharge experiments with different schedules, it was found that mn ( ) / mn ( ) in acidic media as half - cell in a novel redox flow system is practically feasible in that it has such advantages as low cost, high open voltage, a certain coulombic efficiency with low charge / discharge current, and long cycling life. in the second part, cosn alloy and cu - sn samples were synthesized firstly by h2 - reduction following solid - state reaction between co ( ii ) 、 cu ( ii ) 、 sn ( iv ) 、 and naoh at ambient temperature

    並研究了其分別作為鋰離子電池陽極材料在1mol / llipf6 / ec + dmc電解液中的恆流充放電性能，各樣品均存在較大的首次不可逆容量損失； 10個循環內cu - sn可逆放電容量可保持在280mah / g以上，而第十周時cosn 、 cu6sn5的可逆放電容量分別為50mah / g和60mah / g 。
  8. Numerical simulation results indicate that, for low temperature dust particles, dust particles mainly exist in the area near the column center and their charge - number can be considered as a constant, while in the area where there are no dust particles, ion and electrons are in ambipolar diffusion ; for high temperature dust particles, both the distribution regions of dust particle and high ion density are expanded and dust charge - number is increasing with the distance from the center

    計算結果表明：當塵埃粒子的溫度較低時，塵埃粒子主要集中在圓柱形放電器的中心很小的區域，塵埃粒子攜帶的電荷幾乎是一個常數，受塵埃粒子空間電荷的影響，離子在該區域的密度最高。在遠離中心區域，離子和電子呈現雙及擴散特點；當塵埃粒子的溫度較高時，塵埃粒子分佈的區域和高離子密度區域擴大，塵埃粒子離放電器中心越遠，攜帶的負電荷越多。
  9. Thus, during a normal light-up there is a blade temperature charge of about 30 degrees/sec.

    於是，在正常點火時，葉片溫度的變化率約為30度秒。
  10. In order to keep the normal bath temperature and slag forming condition, the charge of pig iron should not be exceeded 10 % on middle and small converter

    中小型轉爐內生鐵塊的加入量不應超過10 % ，使轉爐吹煉過程中保持正常的熔池升溫和成渣狀況。
  11. Reduction crack in the pumping transfer concrete during the megathermal climateit is a diffcult problem. the unit undertaking project of no : 4 pump station for diverting water from the south to the north make a beneficial explore form the design of mix proportionging, control and the concret placing temperature to control the crack extension those experience can be referenced by the unit in charge of large scale pumping station project

    摘要高溫季節泵送混凝土裂縫控制的當前工程界一個難題，南水北調淮安四站工程建設中，建設單位科學安排、精心施工，從控制混凝土配合比、入倉溫度等多方面著手，對混凝土裂縫控制技術進行了有益的探索，並取得了預期的效果，為混凝土抗裂技術積累了經驗，對同類型泵站的施工具有重要的參考意義。
  12. By researched and analyzed, it was found that grain fracture had close relation with charge design safety of guns. grain fracture can lead to pressure abnormity in chamber. particularly in the condition of low temperature, it was the main cause leading to chamber blow

    經研究分析，火藥顆粒的破碎直接影響到裝藥設計安全性，造成膛壓異常現象，特別在低溫條件下，火藥破碎是引起膛炸的主要原因。
  13. On the basis of analyzing the concept of charge temperature in the field environment, this paper discusses the unbalances of internal temperature of charge and environment temperature and the serious extents of traditional charge temperature measure error

    摘要該文在澄清野戰條件下的藥溫概念基礎上，介紹了野戰條件下裝藥環境溫度不均勻性、裝藥內部溫度不均勻性和傳統藥溫測量誤差嚴重性。
  14. From the view of modern weapon system fire precision demands, it is found out that the charge temperature measure maximum deviation should be less than 1 and the standard deviation less than 0. 7 through reading firing table and making demonstration

    而從現代火炮系統射擊精度需求角度，經查閱射表和論證可知，藥溫測量的單向偏差應不大於1 ，標準誤差應不大於0 . 7 。
  15. Therefore, the measure error of traditional charge temperature exceeds 3 to 8 times

    因此，傳統藥溫測量誤差超過了3 ~ 8倍。
  16. Egr - cts egr charge temperature sensor egr

    進氣溫度傳感器
  17. Act air charge temperature sensor

    進氣溫度傳感器
  18. Act air charge temperature

    進氣溫度
  19. Mct manifold charge temperature

    進氣溫度傳感器
  20. A kind of charge temperature measure equipment is developed whose measure precision ( standard error ) reaches 0. 6

    該文研發的藥溫實時測量裝置，其精度（標準誤差）達到了0 . 6 ，在國際同類產品中是先進的。
分享友人
分享到 Line

分享到臉書