coagulation bath temperature 中文意思是什麼
coagulation bath temperature
解釋
凝固浴溫度- coagulation : n. 凝固（作用）；凝結物。
- bath : n （pl baths ）1 沐浴，洗澡。2 浴缸；澡盆。3 浴室，（公共）澡堂。4 〈常 pl 〉（豪華的）大浴場；溫...
- temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
-
As the temperature of the second coagulation bath increases, the water flux increases and the clearance rates of urea and creatintine first increase then decrease and increase a little at last
隨著第二凝固浴溫度的上升，水通量一直上升，肌肝和尿素的去除率先是上升，然後下降，最後又有略微上升的趨勢。 -
Effects of coagulation bath temperature on the structure and performance of polyethersulfone hollow - fiber membranes by dry wet process
凝固浴溫度對相轉化聚醚碸中空纖維膜結構與性能的影響 -
The effects of polymer concentration, solvent volatilization time, temperature and composition of coagulation bath and the thickness of membranes are studied for preparing the best nanofiltration membrane
實驗重點考察了鑄膜液固含量、溶劑蒸發時間、凝膠浴組成和溫度、膜厚等因素對所制納濾膜性能的影響。 -
With a decreasing cellulose concentration of casting solution or an increasing temperature of coagulation bath, the mean pore ssze becomes larger, resulting in higher pure water flux and lower rejection of bsa
隨著鑄膜液濃度的降低或凝固浴（純水）溫度的升高，膜的水通量有較大的提高，但截留率會明顯下降。 -
Effect of temperature of coagulation bath on structure and properties of lyocell fibers from bamboo pulp
凝固浴溫度對有機溶劑法再生竹纖維素纖維結構與性能的影響 -
4. the effect of the temperature and concentration of the second coagulation bath on the structure and properties of pes membranes are studied
4 .研究了第二凝固浴溫度和濃度對聚醚礬膜的結構與性能的影響。 -
The results showed that when the nmmo concentration of coagulation bath is 20 %, the temperature is 25 and the cotton pulp concentration is 5 %, cellulose packaging films with the excellent mechanical properties can be prepared
結果表明，棉漿濃度為5 % ，凝固浴濃度為20 % ，凝固浴溫度為25時，可制得有較好力學性能的纖維素包裝膜。 -
By using atomic force microscopy ( afm ) investigation on the membrane surface, different separation properties can be explained very well according to the data of pore size. increasing temperature or nmmo concentration of coagulation bath or decreasing concentration of casting solution leads to larger skin pore size, wider pore size distribution and higher values of the roughness parameters
用原子力顯微鏡（ afm ）對膜表面形態的分析表明：膜表面孔徑隨著鑄膜液濃度的降低、凝固浴溫度和濃度的升高而逐漸變大，且孔徑分佈變寬。 -
With an increase of nmmo concentration of coagulation bath or concentration of casting solution, the crystallinity of membrane increases. however, an increase of temperature of coagulation bath is accompanied by a decrease of crystallinity of membrane
膜的結晶度隨鑄膜液濃度、凝固浴濃度、刮膜速度的增加而增大，隨凝固浴溫度的升高而降低。
分享友人