collinear 中文意思是什麼

collinear 解釋
adj. 形容詞 【數學】共線的。

  1. Methods to prove problems on three points collinear

    證明三點共線問題的方法
  2. Diffraction theory for collinear dual beam z - scan

    掃描的衍射理論
  3. Let p be a finite planar point set with no three points collinear

    設p為一個無三點共線的有限平面點集。
  4. Mutual coupling analysis of collinear antennas with signal and system concept

    利用信號與系統概念分析線天線的互阻抗
  5. Finite element analysis of sif of flat msd panels with a number of collinear holes

    共線多孔平板應力強度因子有限元分析
  6. Collinear array antenna

    直排天線陣
  7. Collinear image formation

    共線成象
  8. In this paper we consider only finite planar point sets in which no three points are collinear

    本文討論平面上無三點共線的有限點集。
  9. Standard test method for sheet resistance of thin metallic films with a collinear four - probe array

    用共線四探針法對金屬薄膜的薄膜耐力的試驗方法
  10. Research on multi - photo collinear condition constrained least squares matching and its application of traffic

    附有約束條件的最小二乘影像匹配及其在交通事故中的應用
  11. On the stage of describing the shape of airplane and extracting feature, we derive five - coplanar - point invariant from the basic projective invariant - cross ratio, and resolve the problem of stabilization of five - coplanar - point when there is three points are nearly collinear

    在對飛機外型提取特徵進行描述的階段，首先從基本的射影不變量交比不變量出發，推導出了平面五點不量，並解決了當有三點接近共線時不變量不穩定的問題。
  12. Scattering of sh - wave by a radial collinear crack at the edge of arbitrary - shape - cavity in isotropy media is studied. the solution of dsif at crack tips is obtained

    研究了各向同性介質中任意形孔邊徑向裂紋對sh波的散射，求解了裂紋尖端的動應力強度因子。
  13. Pappus theorem : if the vertices of a hexagon lie alternately on two lines, then the three intersections of the pairs of opposite sides are collinear

    帕卜定理：在兩條直線上各取三點，並作適當的連線，則三對直線的交點會在同一直線上。
  14. Testing of semiconductor materials ; measurement of the resistivity of silicon or germanium single crystals by means of the four probe direct current method with collinear array

    半導體材料的試驗.用探針直線排列的四探針直流法測
  15. Acoustooptic deflector is the significant component of the optical devices such as integrated optical spectrograph, tunable filter, scanner, convolver, correlator and optical switch etc. acoustooptic deflector can be divided into collinear and non - collinear, bulky and wave - guided, body devices and surface devices

    聲光偏轉器是集成光學頻譜儀、可調諧濾波器、掃描儀、卷積器等光學器件的重要組件、聲光偏轉器可分為共線式和非共線式、塊體型和波導型以及體波器件和表面波器件。
  16. With the development of automobile industry and road transportation ， the traffic accidents happen every day in the world and become a serious society problem the vehicle collision accidents are over 2 / 3 times as much as all traffic accidents they cause a large amount of social infuence and serious economic loss therefore ， it is urgent to study vehicle collision accidents comprehensively and systematically ， and the research also is the academic foundation to analyze and deal with traffic accident it is difficult to authenticate car velocity after traffic accident to dig over locate witness is right way mechanics is avaid tool in this field it is important to establish math model and this is precondition to calculate vehicle velocity firstly on the basis of summarizing the research results ， this paper deeply discusses the calculating model to analyze the instantaneous motion state in the vehicle collision, the interrelation among the every moving mechanics parameters in the every phase of the collision secondly ， according to the collinear collision and two - dimension collision and the restitution coefficient ， the paper estabishesthe post collision movement models it proves that these models are correct and valid thirdly ， this paper try to research reconstruction of road traffic accident and put forward the method on it

    對交通事故的科學分析應是建立在正確的數學模型與計算機模擬技術基礎上的定量分析，其基本條件就是要有能正確描述事故過程中汽車狀態的數學模型，只有建立正確的數學模型，才能較準確地推定事故車輛的碰撞速度。所以建立正確地車輛碰撞模型和運動模型正是汽車事故再現的關鍵問題。本文首先在總結前人研究的基礎上，深入地研究汽車碰撞理論，分析了車對車碰撞作用瞬間狀態的計算模型及碰撞恢復系數與碰撞前、后速度的關系；其次，根據交通事故中最普遍的一維和二維碰撞的不同情況，採用恢復系數和滑動摩擦系數等概念，分別建立了碰撞后車輛動力學模型；第三，對汽車碰撞事故再現進行了初步研究，確定了車對車碰撞事故模擬計算和反推計算方法，並給出相應的模擬程序流程圖。
  17. Barrier cracks cannot stop the extending of a fracture, and the strength of the sample is reduced by almost one magnitude because of the existing barrier cracks. there are great differences of ae distribution between specimens with non - penetrate crack and specimens with penetrate crack. as for penetrate crack, ae occurs near the two end of the crack, and for non - penetrate crack, crack, ae occurs near the two end of the crack, and for non - penetrate crack, ae occurs near the front edge of crack, which can be explained well by the theory of 3 - d fracture ; ae distribution near the outer part of collinear crack is similar with that of the end of penetrate crack, and inner part of collinear cracks will run - through with high loads

    關于預制裂紋系對巖石破裂的影響，集中討論了：空障礙體構造不能阻止主裂紋的擴展，反而會使巖石的破裂強度降低近一個量級；由於構造的不同，非穿透切口樣品和穿透切口樣品的聲發射空間分佈特點有本質區別，穿透切口樣品的微破裂在切口兩端發育，而非穿透切口樣品的微破裂在切口兩端之間切口前緣處發育，這用三維破裂理論可以很好地解釋；含共線構造的巖石，裂紋外端的聲發射分佈與單裂紋構造中裂紋端部的聲發射分佈相似，裂紋內端聲發射有密集分佈，在應力達到一定水平時，內端部發生錯斷，而不是貫通。
  18. Based on these foundations, we give a perfect scheme of the bbo opos : single pass amplification coefficient of the opg under different pump intensity is calculated ; collinear type - i and type - ii phase matching tuning curve pumped by the q switch nd : yag various harmonics as well as noncollinear type - i tuning curve are calculated in details ; the effect of the walkoff for the nonlinear effect coefficient and the group velocity matching are analyzed ; the acceptance angle in parametric process is calculated ; the numerical threshold of the bbo opo is calculated ; the process of the saturation and depletion of the pump beam are analyzed ; the relationship of the conversion efficiency and reflectance of output mirror are discussed ; various linewidth controlling methods are discussed ; the improvement of the beam quality applying the unstable cavity is discussed ; and the crystal bbo design is considered

    在此基礎上，給出了一整套bbo - opo激光參數設計方案：計算了不同泵浦強度下的參量放大倍數；詳細計算了在nd : yag調q激光器各次諧波泵浦條件下的共線類和類相位匹配的調諧曲線，以及非共線類相位匹配調諧曲線；分析了走離角對非線性系數和群速匹配的影響；計算了參量過程的允許角；計算了bbo - opo的理論閾值條件；分析了飽和與泵浦光束的消耗過程；給出了轉換效率與超過泵浦閾值的倍數的關系；討論了轉換效率與輸出鏡反射率的關系；討論了線寬控制的各種方法；研究了利用非穩腔改善光束質量的方法；考慮了bbo晶體的設計。
  19. Using the conic function model local approximation, w. cdavidon ( 1980 ) proposed a class of iterative algorithms with modified matrix combining function value, furthermore under the theory d. c. sorensen has used local quadratic approximation method, then applying collinear scaling idea improving on the above algorithm and generalizing it, getting a class of collinear scaling algorithm, unifying former quasi - newton. in the paper, using local quadratic approximation method, the first, constructing the new collinear scaling gene, getting a class of the new collinear scaling algorithm with briefness and numerical stability, ., we discusses some properties of the algorithm and its local linear convergence, q - superlinear convergence and the whole convergence ; secondly we have made numerical experimentation and numerical analysis ; the last, we have done much discussion for collinear scaling idea and given the several new collinear scaling algorithm

    本文的工作就是基於局部二次逼近原理，首先通過構造新的共線調比因子，得到了一類新的更簡潔，數值穩定性更好的共線調比演算法，進而我們給出了本共線調比演算法的局部收斂性，全局收斂性以及演算法q -超線性速度的理論證明；其次，用經典的無約束優化五大考核函數就本共線調比演算法進行了數值試驗和數值分析；最後，就局部二次逼近思想，進行共線調比演算法思想進行更廣泛的討論，給出了幾個新共線調比演算法。
  20. The effect of pump beam ' s walk - off and the group - velocity - mismatch in bbo crystal is discussed, the group - velocity - mismatch can be compensated by non - collinear phase - match when the angle between signal and idler beams equals to 14. 4

    當下轉換光與抽運光夾角達到13 . 4度時，非共線相位匹配基本可以消除晶體中群速失配對下轉換過程的影響。
分享友人
分享到 Line

分享到臉書