combination method measurement 中文意思是什麼

combination method measurement 解釋
組合測量
  • combination : n 1 結合，合併，混合，聯合，配合，組合。2 合作；共謀，同謀；同黨。3 〈pl 〉〈英國〉連褲襯衣。4 【...
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  • measurement : n. 1. 測量，計量，量度。2. 份量，尺寸，大小，寬度，厚度，深度（等）。3. 測量法。 measurement goods （按體積、容積計算的）體積貨物。
  1. The way of taking one nth out of capacitor ' s the first harmonic capacitive reactance as its nth harmonic impedance is verified whit the data from tang7c. according to the approximately estimating method, the first harmonic impedance of 220kv system is calculated. on the basis of the models, this paper gives the harmonic equivalent circuit of substation and gives the b ( n ) function of the harmonic time n. when the capacitors has different combination, b ( n ) ' s value will also change, with the inputting local measurement data, the paper studies the series and parallel resonance at the substation, and deduces that the reason the capacitor ' s fuse of tang6c is frequently interrupted is that its capacitor current contains a large number of 5th harmonics, and that the reason the discharging pt of tang7c capacitor being exploded is also that the 7th and 9th harmonic currents are amplified

    據此，對該站進行了串聯諧振分析和並聯諧振分析，並結合測試數據和有關變電站的運行記錄，指出了導致該站電容器湯6c頻繁燒保險的主要原因是5次諧波電流含量偏高，引起湯7c放電pt爆炸也是因為7次和9次諧波電流被放大。針對這些導致湯陰變電站補償電容器故障的原因，提出了相應的諧波治理措施，包括針對湯6c電容器5次諧波電流含量偏高的原因，提出了停運湯6c電容器或者通過把湯sc電容器的部分容量併入湯6c電容器（湯sc其餘部分停運）以增加湯6c諧波承受能力的措施;針對# 2變低壓側7次和9次諧波電流被放大的現象，提出了在湯7c電容器上加裝一定百分比的串聯電抗器的措施。
  2. This article studies on a novel method about detector calibration and monochromator calibration by using silicon pin photodiode. the detector and the monochromator of one spectrum measurement system had been calibrated using the method, and the spectrum distribution of one laser - produced plasmas ( lpp ) source with jet gas target was measured. the use of a specific combination of the silicon photodiode and multiplayer reflect films is the notable character in monochromator calibration

    本文研究了一種利用光電二極體傳遞標準探測器標定普通探測器和單色儀系統的方法，實際標定了所用的探測器和單色儀系統，測得了噴氣靶激光等離子體光源的相對光譜分佈，設計出絕對光譜分佈的測量方法，並且利用labview的g語言及相應的數據採集卡等硬體設備構造出一套智能化、高效率的測量系統，完成了多層膜反射率測量工作。
  3. Surrounding these special problems met in gas hydrates exploration and through study of high - precision magnetic survey, the sea test by r / v haiyang 1y that is owned by guangzhou marine geological survey in dongsha area of the south china sea, systematical analysis of the test result and combination interpretation of magnetic survey with seismic profile, the authors successfully employ the method to recognize the truth or false of the diapir in seismic profile by integrating total field of high - precision marine magnetic measurement with its gradient change

    本文就目前天然氣水合物調查中存在的這些特殊技術問題，通過對海上高精度磁力測量技術方法研究、廣州海洋地質調查局「海洋四號」船在南海北部東沙海域的海上試驗、對試驗結果的系統研究分析以及磁測和地震剖面兩種手段的綜合解釋，成功地嘗試了用高精度海洋磁測成果中的磁力總場和梯度變化特徵來識別水合物勘探中高解析度地震剖面上的泥底辟構造真偽的技術方法。
  4. A new distributed fusion method of radar / ir based on separation and combination of the measurements is proposed after analyzing the influence of rate measurement. the rate information separated from the radar measurements composes a fake vector of ir

    在對引入徑向速度測量后雷達跟蹤性能進行分析的基礎上，提出了一種基於測量信息組合優化的雷達/紅外分散式融合方法。
  5. A study on data combination method in topography measurement of revolving objects

    回轉體形狀檢測的數據拼接法研究
  6. The study shows the characteristics of goodwill are that : ( 1 ) it is the present value of extra - profit of corporation ( 2 ) it is an intangible assets ( 3 ) it is uncertain and risky ( 4 ) the usage is limit and the formation and variance of value is special compared to other assets. as to the recognition and measurement : ( 1 ) we should conceal combined variance item in combined statement when the goodwill is formed in the mode of controlling combination in order to conform to the international principle ( 2 ) the recognition of self - constructed goodwill is necessary ( 3 ) we should make impairment evaluation to revise amortization when we start to amortize after its first recognition ( 4 ) we attach more importance to un - direct measurement approach on present stage ( 5 ) direct measurement approach can be adopted to self - constructed goodwill, while for goodwill - purchased, it may be reference only, we should adopted un - direct approach to recognize. the accounting process of positive and negative goodwill are that the former should conform to the systematic amortization method.,

    2商譽的確認、再確認與計量： u ）對我國而言，以控股合併方式下形成的外購商譽在合併報表中的處理應遵循國際慣例，取消合併價差項目； （ 2 ）從資產的確認標準以及會計原則等多個角度來看，確認自創商譽非常必要； （ ）商譽在初始確認后，應對購買商譽進行攤銷的同時，並進行商譽的減損評價，使減損評價起到「修正」攤銷的作用： （ 4 ）直接計量法與間接計量法是計量商譽的兩種方法，現階段只能是計量的科學性讓位於計量的難易程度，採用間接法計量商譽； （ 5 ）隨著近年來自創商譽入賬的呼聲日益高漲，若要將自創商譽入賬，顯然只能採用直接計量法計量其價值，而對外購商譽，可以先以直接計量法的計算結果作為重要參考，然後再用間接計量法計算的結果對商譽登記入賬。
  7. The output information of single classifier has three forms of abstract, rank and measurement single classifier supplies both the unknown pattern classifying information on the measurement level and the wrong classifying distribution information of the training samples on the abstract level, which are used to design the fuzzy multiple classifiers combination method

    單個分類器的輸出信息有三種表現形式：符號層、排序層、度量層。應用單個分類器在度量層次上，對未知模式的分類信息；在符號層次上，訓練樣本的錯分類分佈狀況，設計了模糊多分類器組合方法。
  8. The surface deformation monitoring of the side - wall by combination of the forward intersection method with the analytical trigonometric elevation measurement demonstrates that the plane deformation and vertical deformation of the side - wall are small, and the quality of dam filling and side - wall construction is satisfactory

    用能夠滿足精度要求的前方交會法與解析三角高程測量法結合的方法對邊墻表面變形進行監測，結果表明，邊墻平面位移和垂直位移均較小，大壩填築和邊墻施工質量可靠。
  9. The variation of the film composition can be monitored by using the method of spectrum analysis during the film deposition ( for the intensity of the persistent line is proportional to the particle density of the element in the vacuum chamber ). the measurement of the transmission spectrum of the film on a transparent substrate can be used to calculate the film parameters, such as refractive index, extinction coefficient and the thickness of the film. therefore, the combination of the two methods would be helpful to on line monitoring the film constituents and the optical paramenters in the preparation of thin films

    在制備薄膜的過程中，利用光譜分析的方法，以放電光譜特徵譜線強度的變化來反映相應物質成分的變化，以連續光譜光源發出的光透射過薄膜的透射率的變化，來反映薄膜的厚度、折射率、吸收系數等光學參數的變化，從而達到在制膜過程中，對薄膜的成分、厚度等參數進行在線監控的目的
  10. Based on the conception of gear global deviations, starting with the related factors influencing sbg ’ s deviations, the paper has explored the quantitative evaluation of topographic deviation for sbg by means of mathematical method in combination with measurement principle, and has developed the software of sbg ’ s deviation evaluation

    基於齒輪整體誤差概念，從影響螺旋錐齒輪誤差形成的相關因素出發，利用數學方法結合測量原理，本文對螺旋錐齒輪齒面拓撲誤差的定量評定進行了探索，開發了螺旋錐齒輪誤差評定軟體。
  11. According to the analyzing on the questions such as the parameters of moire stripe signal influence on photoelectric rotary encoder interpolation errors, lissajou chart ' s characteristics and applications in interpolation errors measurement, we developed a dynamic measurement method about the parameters of moire stripe signal and interpolation errors evaluation. with the combination of hardware and software, a dynamic measurement system of interpolation errors of photoelectric rotary encoder is designed

    通過分析莫爾條紋信號的各種信號質量指標對光電軸角編碼器細分誤差的影響， lissajou圖特性及其在細分誤差測量中的應用，研究出光電軸角編碼器光電信號參數測量及細分誤差評估的動態測試方法，並針對這一方法通過硬體及軟體技術的結合，設計出一套光電軸角編碼器細分誤差的檢測系統。
  12. In the study of environment model - based processing, the thesis presents a signal enhancement method based on combination of the ocean acoustic propagation, measurement system and noise models. furthermore, a signal enhancement algorithm is developed on the basis of the model - based identifer ( mbid ) implemented by the the augmented gauss - markov process and corrsponding extended kalman filter

    本文通過了對模基信號處理實現信號增強的理論研究，提出了一種利用傳播模型、噪聲模型和陣測量模型、並注重環境信息來實現水聲信號增強的方法，繼而實現了基於增廣高斯?馬爾可夫過程和相應的擴展卡爾曼濾波聯合的模基辨識器的信號增強演算法。
  13. Finally, system ’ s measurement error and error compensation method are analyzed, and some measures of anti - interference are taken to improve system ’ s reliability. the project was finished by combination the theory and the practice, and a new way on peterson coil automatic compensation is available

    本課題將理論運用和實踐相結合，為中性點經消弧線圈接地系統的自動調諧提供了一種新的技術手段，具有廣闊的應用前景。
  14. With the combination of automatic amplitude balance approach, in this method, the accuracy of the phase measurement has been improved significantly. experimental results indicate that the maximum phase error is less than ?. 5 ? 5

    實際測試表明，改進后的時序測相方法對所有可能的被測相位的最大測相誤差小於1 . 5 。
  15. In this paper, a mixed method with the combination of advantages of analog and digital is discussed. it consists of two parts, analog and digital. first capacitance is converted to frequency by analog part, which makes the relations between capacitance and frequency, then high accuracy and instantaneous frequency measurement is accomplished by digital part based on the multiple period synchronization method

    隨著數字電路的成熟，也有數字方法。本文結合模擬和數字方法兩者的優點，採用模/數混合方法。該方法由模擬和數字電路兩部分組成，首先由模擬電路建立電容到頻率的函數對應關系;然後由數字電路對頻率計數。
分享友人
分享到 Line

分享到臉書