combination plane 中文意思是什麼

combination plane 解釋
接合面
  • combination : n 1 結合，合併，混合，聯合，配合，組合。2 合作；共謀，同謀；同黨。3 〈pl 〉〈英國〉連褲襯衣。4 【...
  • plane : n 懸鈴木屬樹木。n 1 平面，水平面，面。2 （知識等的）發達程度，水平，階段。3 【航空】機翼面；〈常 ...
  1. Stability of rock slopes is generally controlled by the structure of rock masses, especially the soft structure surfaces. analysis of rock mass structures is a key to establish geological models and numerical simulation and a foundation to assess the stability of rock slopes. the weak structure surfaces are mainly bedding planes, faults, joints, schistosity plane and contact zones of intrusive bodies. since they are different in genesis and scale, the rock masses are different in features and mechanical intensities. based on the combination of rock structure bodies, 15 basic modes of deformation and failure of rock slope are systematically summarized. the deformation and failure of rock masses actually result from the recombination and rearrangement of these rock bodies. there are 11 types of rock mass structures and various deformation and failure of bank slopes are present in the reservoir area of the three gorge project

    巖體結構，特別是軟弱結構面對基巖斜坡變形與破壞具有顯著的控製作用，巖體結構模式分析是建立斜坡地質模型和數學模型的關鍵和評價斜坡穩定性的基礎。巖層層面斷裂構造節理裂隙片理與劈理以及侵入體和圍巖的接觸帶等是控制基巖斜坡穩定的軟弱結構面，這些成因不同大小不一的結構面將巖體分割成性質各異力學強度不均的各種巖體結構體，構成了15種基巖斜坡變形破壞的巖體結構基本模式。不同結構體的重新組合與排列是斜坡失穩的內在原因。
  2. At present, a datum plane - conversion scheme is introduced in the sight system of active ground - to - ground missile. in this scheme the datum plane of sight system is transferred from inertia combination to missile terminal, and the angle of two datum planes is measured at the technical position

    目前，常規導彈在瞄準中採用了基面轉換方案，將導彈瞄準基面由慣性組合轉換到彈體尾段，兩基面夾角在技術陣地測量。
  3. There are problems to choose which section plane as the best section plane before the oil well orbit optimized design because there have been ten - more kinds of section planes ( beeline and arc ' s combination ) and the oil well orbit should be fit of all stratum conditions

    考慮到工程上對油井軌道剖面類型（直線圓弧組合）的描述多達十余種，以及實際施工時油井軌道不僅需要滿足最優化條件，還要適應地質、地層和繞障等要求，因此存在井軌道剖面類型的選擇問題。
  4. 1. comparing reservoir beds in details step by step, we have divided and compared the deposition time unit in guan 3 - 6 sandstone bed sets, which has been divided into 20 small beds, 30 time units : rebuilding oil sandstone body data table, building graph database, further analyzing the level and section plane configuration and combination pattern of sandstone, and deducing the maze reservoir geology model of river sandstone, are the most important basis for oil reservoir description and residual oil distribution study

    1 、採用儲層逐級細分對比方法，對館3 - 6砂層組進行了沉積時間單元的劃分對比，共劃分出20個小層、 30個時間單元；重新編制了油砂體數據表，建立了圖表數據庫，並進一步分析了單層砂體平面、剖面形態以及砂體組合模式，總結出河道砂體屬迷宮式儲層地質模型，這是精細油藏描述及剩餘油分佈研究的最重要基礎。
  5. After studying a lot of documents of computer - graphics and computation of geometrical, based on nurbs, which is a pop expression to describe curve and surface, the author put forward a method ? ? to identify bad point by most excursion, to illustrate how to choose smooth base plane, which is not referred in most documents, and to introduce optimize method of operational research to combine surfaces, especially for surfaces combination with vertex, and improvement of combination effect

    在解決多曲面有角點的拼接問題中引入了運籌學的優化方法，改善了多曲面拼接的效果，而且在ugii造型軟體的基礎上，用visualc + + 、 ug / openapi進行二次開發，加入了壞點剔除，曲線光順，曲面片之間的拼接等功能，很好的解決了反求工程中所遇到的問題。
  6. By adopting the combination of quality and quantity analysis, the thesis first analyse how to determine the enemy fighter plane during an air - attack to our secured target by four cases, then analyse the intensity of the enemy air - attack firepower by practicable air force, daily fighter intensity, and daily fighter quantity

    採用定性與定量相結合的方法，對如何判斷敵空襲被掩護目標使用的兵器種類進行了分析，然後從空襲可用兵力、日出動強度和日出動量三個方面對空襲火力體系的攻擊強度進行了深入研究。
  7. In this paper, dynamic stability of parametrically excited flexible cam - follower system on the weakly nonlinear condition is investigated by using the combination of both the method of multiple scales and the technique of fourier series expansion. the equations of approximate transition curves in the plane of the dimensionless frequency and excitation ( amplitude ) parameter that separate stable from unstable solution are derived

    隨后，本文採用多尺度法並結合fourier級數展開，分析了不同的凸輪從動件運動規律和不同的凸輪的升程、停程以及回程的時間分配規律下，無間隙的周期時變凸輪系統模型的穩定性，獲得了各種規律下的凸輪系統的穩定區間圖。
  8. In this thesis, three systems, namely, perfect and defect sno _ 2 ( 110 ) surfaces, ti and ru - doped surfaces and the adsorptions of small molecules on above perfect surfaces have been studied in details by using the first - principles method with the combination of pseudopotential plane - wave and atomic basis sets. the structural stability, surface states and the surface chemistry of undoped and metal doped sno _ 2 ( 110 ) surfaces have been discussed, which can provide the theoretical rules to improve the surface properties of this special functional material

    為了深入了解sno _ 2表面的電子結構本質及其化學反應性質，本論文採用贗勢平面波和原子軌道基組相結合的第一性原理方法，詳細考察了三種類型體系，即sno _ 2 （ 110 ）完整和缺陷表面、 ti和ru摻雜表面、以及典型小分子在上述完整表面的吸附，揭示了sno _ 2 （ 110 ）及其金屬摻雜表面的構型穩定性、表面態及其對表面化學反應性的影響，為該類型表面功能材料的改性提供理論依據。
  9. The surface deformation monitoring of the side - wall by combination of the forward intersection method with the analytical trigonometric elevation measurement demonstrates that the plane deformation and vertical deformation of the side - wall are small, and the quality of dam filling and side - wall construction is satisfactory

    用能夠滿足精度要求的前方交會法與解析三角高程測量法結合的方法對邊墻表面變形進行監測，結果表明，邊墻平面位移和垂直位移均較小，大壩填築和邊墻施工質量可靠。
  10. According to the bridge standard, we analysis the combination structure, simplify it and decompose the complicated space structure into two plane structure hi order to calculation

    根據橋梁規范，對柳梧大橋的組合結構進行了結構簡化分析，將一個復雜的空間結構分解為兩個平面結構進行計算。
  11. The combination of a crystallographic plane and, within that plane, a crystallographic direction along which slip ( i. e., dislocation motion ) occurs

    滑移面和該面上一個滑移方向的組合稱為一個滑移系，晶體滑移（如位錯的移動）可以沿該系統發生。
  12. I myself have tried to use limited elements such as the dot, the line, the plane, and various colors to form protean pictures, and open up the picture frame so as to achieve a three - dimensional effect in the combination of dots and lines

    我自己長期探索用點、線、面，黑、白、灰及紅、黃、綠有限數種元素來構成千變萬化的畫面，展拓畫幅，在點、線的疏密組合中體現空間效應。
  13. According to projection features and projection characteristics of the boss - eyed plane, we can adopt " the way of analyzing the line frames from the projection of an object surface " to analyze the combination shape and hence construct the three - dimensional drawing

    根據可視面的投影性質和投影特徵，可採用「表面框分析法」對組合體形狀進行分析，從而確定三維立體圖。
  14. At here, based upon designing idea of the shearing planes of left and right two shears are at 45 with respect to main transmission plane and the combination with changeable structure, the shearing mechanism of two mutually twisted flat screw wires was designed

    在此，基於左右兩把剪刀的剪切平面相對于主傳動平面成45 ，以及與變結構相結合的設計理念，設計出了兩根互繞扁螺旋鋼絲的剪切機構。
  15. Comparison and analysis of the stress distribute rule and deformation of two kinds of combination dies that with flat end plane or with oblique end plane cavity come to conclusion that the oblique end plane combination die is of higher intensity

    摘要通過對平、斜端面組合凹模在預緊及合成兩種狀態下應力和變形位移的對比分析，得出了斜端面組合凹模的應力分佈規律，指出在其他條件相同的情況下，斜端面組合凹模具有更高的強度。
  16. The exist - null combination method for the topological optimization of plane membrane structure

    平面膜結構拓撲優化的有無復合體方法
  17. The edged - based fem in combination of pml is applied to compute the radiation of an open waveguide in infinite plane. the calculated radiation patterns are in agreement with that obtained by analytical method

    本文應用矢量有限元和pml分析了無窮大接地平面上開口波導的輻射特性，與理論近似方法對比完全符合。
  18. Their object is to find a way, which is effective and economical to resolve this kind of problem. the problem of optimal placement of stock sheets is that planning plane parts on the stock sheets in the most optimal combination and layout

    板材排樣優化問題是指當平面零件從規則的矩形板材上下料時，規劃零件在板型原材料上最佳的下料組合與每個下料零件最優布局的問題。
分享友人
分享到 Line

分享到臉書