combustion injection 中文意思是什麼

combustion injection 解釋
起燃
  • combustion : n. 1. 燃燒，發火，點火。2. （有機體內營養料的）氧化。3. 騷動。
  • injection : n. 1. 注射。2. 注射劑，注射液，針藥，灌腸（藥）。3. 充滿，注滿。4. 【醫學】充血。5. 【機械工程】噴射。6. 【宇宙空間技術】（衛星等的）入軌，射入軌道，射入軌道的時間[地點]。
  1. Vortex injection provides a form of swirl or cyclone combustion for a rocket engine similar to systems often employed in industrial furnaces.

    渦流噴射在火箭發動機中產生一種渦流或旋渦形式的燃燒，與工業爐中常採用的系統相似。
  2. The investigation has declared that the fuel injection with bq fuel pump had higher injection pressure, bigger fuel supply rate and shouter fuel supply duration, which would cause the fuel injection quantity and the fule - air mixture to increase during ignition delay period, the pre - mixed combustion to become acutely, and finally result in increased power levels of noise

    研究表明，裝配bq噴油泵，噴油系統的噴油壓力較高，供油速率較大和供油持續時間縮短，使得滯燃期的噴油量增加，滯燃期內形成的可燃混合較多，預混燃燒劇烈，導致整機噪聲聲功率級增加。
  3. Meanwhile in the condition of high temperature, water vapors can participate in combustion. water gas reaction will happen, which will reduce carbon particle in flame, and reform combustion performance, so improve combustion efficiency. the article developed a kind of technology of water injection into intake ports for 4135g diesel engine, meanwhile designed a suit of water injection system

    同時在高溫條件下，水蒸汽參與燃燒，部分水分子與未完全燃燒的熾熱的炭粒發生水煤氣反應，形成可燃性氣體，從而減少了火焰中的炭粒，提高了油的燃燒程度，改善了燃燒狀況，提高了油的燃燒效率。
  4. Experimental study on a new type direct injection circularly stratified charge combustion system for alcohol engines

    燃燒邊界條件對乙醇均質壓燃燃燒的影響
  5. Abstract : the changes of fuel performances and optimum combustion organigations inside cylinders of the direct injection diesel engines can be improved combustion emissions

    文摘:直噴式柴油機燃料性能改變和缸內燃燒過程的組織優化，可以改進它的燃燒排放。
  6. Based on the analysis of the combustion in cylinder, the thorough research of multiparameters ( engine speed, load, ignition timing, injection timing, injection nozzle type, compression, ignition pattern etc. ) on methanol engine combustion cyclic variations is made on a 1130 single - cylinder diesel engine fueled with methanol

    在燃用甲醇燃料的1130單缸柴油機上，通過缸內燃燒分析，對影響甲醇發動機循環變動的各種因素（轉速、負荷、點火提前角、噴油提前角、噴油嘴類型、壓縮比、點火方式等）進行了詳細的研究。
  7. So it is proved that the working model is right, and on the basis, the influences of the compression ratio and fuel injection advance angle on the diesel engine ' s combustion performance are studied. ( 2 ) energy resource and environment protection are two important problems that diesel engine is faced with. so in this paper the constrained optimization is studied in order to decrease fuel consumption within the limitation of the regulation on exhaust emission and power output

    （ 2 ）能源和環境保護是柴油機存在和發展的兩大問題，因此本文在滿足排放法規及柴油機動力性的基礎上，以降低油耗為主要研究目標，進行有約束條件的優化計算，並提出了一種新的柴油機工作過程優化計算方法? ?非線性回歸?網格法。
  8. The performance experiments of emulsified diesel oil are done on a 1135 diesel engine. by a lot of experiment data and charts, the factors that influence the combustion effect are analyzed, including the factors of emulsified fuel self such as emulsifiers, water content, emulsifying way, and the factors of diesel engine such as fuel injection advance angel, injection pressure, load, model of engine, and so on

    在1135柴油機上進行了乳化柴油的臺架試驗，通過大量試驗數據及圖表分析了影響乳化油燃燒效果的因素，包括乳化油自身的因素如乳化劑、含水量、乳化方法等，以及發動機的狀況與參數如噴油提前角、噴油壓力、工況、機型等。
  9. Numerical investigation on combustion process in a spark - ignited direct - injection alcohol engine via hybrid combustion model

    用混合燃燒模型研究缸內直噴醇類燃料發動機的燃燒
  10. Fuel injection nozzle used on small bore diesel engine with swirl combustion chamber

    小缸徑渦流室柴油機用噴油嘴的研究
  11. Pci prechamber injection combustion process

    預燃室噴射燃燒過程
  12. Moreover, it has been pointed out that the hydrogen engine used in ? cylinder injection with high pressure can increase volumetric efficiency and compression ratio, - therefore, the performance indexes in this engine, such as output power, thermal efficiency, range of thickness of mixture with normal operation and nox emission, can be improved, and it is possible for the engine to realize rapid combustion of thin mixture, so abnormal combustion, such as backfire, pre ? ignition, can be controlled effectively

    指出了採用內部混合氣形成方式且高壓噴射的氫發動機，有利於提高充氣效率和壓縮比，從而改善發動機的動力性和經濟性；有利於擴展發動機正常工作的濃度范圍；並且有利於實現稀薄混合氣快速燃燒，從而可以有效地抑制早燃、回火及爆燃等異常燃燒和no _ x排放量。試驗指出了發動機的點火正時、噴射正時及噴氫量對發動機的性能、異常燃燒、 no _ x排放量有很大影響。
  13. Generally speaking, for an injection diesel engine, the combustion noise is higher than the mechanical noise ; whilst the case is the other way round for a non - injection diesel engine

    一般直噴式柴油機燃燒噪聲要高於機械噪聲，而非直噴式柴油機的機械噪聲則高於燃燒噪聲，但是低速運轉時燃燒噪聲都高於機械噪聲。
  14. After a detailed analysis of the characteristics of zero -, quasi -, and multi - dimensional models of direct injection diesel engines, we make proper simplifications on the quasi - dimensional combustion model

    本文在詳細分析了模擬直噴式柴油機燃燒過程的零維模型、準維模型和多維模型各自的特點后，對柴油機的準維燃燒模型作了合理簡化。
  15. Numerical study on spray and mixture stratified combustion in a direct injection gasoline engine

    汽油機燃油噴霧和分層燃燒的數值研究
  16. Based on correctly describing high pressure fuel injection spray, a quasi - dimensional combustion model for forecasting performance and emission of high pressure common rail diesel engine is established

    在正確描述高壓燃油噴霧的基礎上，建立了一個能預測高壓共軌柴油機性能和排放的準維燃燒模型。
  17. A new hcci combustion system for diesel engine based on the technologies of multi - pulse fuel injection and the bump combustion chamber was developed by professor su wan - hua in necl of tianjin university. the premixed homogenous combustion is realized by the technology of multi - pulse fuel injection

    天津大學內燃機燃燒學國家重點實驗室蘇萬華教授提出的基於多脈沖噴射技術和bump燃燒室的復合燃燒技術是一種能夠實現均質燃油混合氣快速燃燒的新hcci燃燒方式。
  18. The combustion and flow process of cavity flame holder with liquid kerosene fuel on room temperature were investigated experimentally, with different fuel equivalence ratio and injection schemes

    在燃燒狀態下，對基於常溫液體煤油燃料的凹腔火焰穩定器的燃燒與流動特徵進行了試驗研究，並比較了不同當量比和不同燃料噴注方式。
  19. The experimental investigations were first conducted on diesel spray wall - impingement mixing process with or without a bump on a flat wall and in a combustion chamber by means of plif method in the self - made constant volume combustion spray simulation set - up which can reproduce the typical working conditions and high - pressure fuel injection of modern diesel engines. the simulation computation of a cfd code about them was then carried out

    首先在自行研製的、可以模擬現代柴油機典型工作環境及高壓燃油噴射特性的定容燃燒噴霧模擬裝置上用片狀激光誘導熒光法（ plif ）對平壁上、燃燒室內不設置和設置bump的柴油噴霧撞壁混合過程進行了試驗研究，然後又用cfd多維數值分析軟體對其進行了模擬計算。
  20. Since injection density cannot be varied independently, it is difficult to show conclusively its effect on combustion stability.

    由於不可能獨立地改變噴射密度，要確定地指出噴射密度對燃燒穩定性的影響是很困難的。
分享友人
分享到 Line

分享到臉書