combustion-gas pressure 中文意思是什麼

combustion-gas pressure 解釋
燃燒氣體壓力
  • combustion : n. 1. 燃燒，發火，點火。2. （有機體內營養料的）氧化。3. 騷動。
  • gas : n （pl gases ）1 氣，氣體，氣態 〈cf fluid; solid〉 2 可燃氣，煤氣，沼氣；【礦物】瓦斯。3 【軍事...
  • pressure : n 1 壓；按；擠；榨。2 【物理學】壓力，壓強；大氣壓力；電壓。3 精神壓力，政治[經濟、輿論等]壓力。4...
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. The pilot fuel model has been given to calculate the distribution of the liquid fuel and time of fuel pre - combustion, at the same time, analyzing the important action to the combustion of the natural gas in the combustion chamber of engine, determining the best quantity of pilot fuel. the explosive combustion model has been established to compute the pressure of the cylinder during the combustion, determining the main influence factors. the emission model has been established to forecast the co, nox emission

    理論方面，提出了基於化學反應的燃燒模型?多組分氣相反應系統的化學反應動力學模型，以此進行雙燃料發動機的熱力學?化學反應動力計算；引燃油燃燒模型，計算引燃油液滴的分佈規律和滯燃期，驗證引燃油在雙燃料發動機燃燒過程中的作用，揭示不同噴油規律對雙燃料發動機的影響，確定在不同負荷下的合理引燃油量；爆震模型，揭示爆震與工質能量釋放間的關系和影響爆震的各種運轉因素，確定合理的爆震依據，減小爆震傾向。
  3. Reciprocating internal combustion engines - vocabulary of components and systems - pressure charging and air exhaust gas ducting systems

    往復式內燃機.零部件和系統詞匯.增壓及進排氣管道系統
  4. Reciprocating internal combustion engines - vocabulary of components and systems - part 4 : pressure charging and air exhaust gas ducting systems

    往復式內燃機.元件和系統詞匯.第4部分:增壓和空氣排氣管道系統
  5. It is noted that high pressure mixed gas has to be used in connection with forced blowing wind for gas combustion chamber to produce qualified casting

    特別強調，即使用高壓煤氣，也必須用強制送風的方法供給煤氣燃燒器所必須的空氣量，才能生產出合格的鑄件。
  6. Great difference in pressure for two flow made pressure wave system and it help to extend the delay time for gas in chamber, which increases combustion effusion. second, to increase combustion effusion, the inlet temperature of air and gas should be enhanced in the range of heat releasing in chemical reaction. third, the first work condition is unburned absolutely and the second work condition is burnt in shear layer of inlet and the end of down wall zone in straight segment

    對于壓力差很大的兩股氣流，所形成的壓縮波系的結構可以增加燃氣駐留時間，提高燃燒穩定性;為了提高擴散燃燒的效率，在保證能放熱的化學反應溫度范圍之內，應適當提高燃氣及空氣的來流入口溫度;燃氣噴嘴應居於燃燒室軸線上，是改進超音速燃燒室結構的一種思路。
  7. The so / sb shutoff regulator is used in the gas line to automatically shut off the fuel when the combustion air or any remote signal pressure drops below a predetermined limit

    Sb切斷閥用於燃氣管線自動切斷燃料，當燃燒空氣或者任何遙控信號的壓力低於預設定極限值。
  8. By carrying on experimental study to the ignition performance of the natural gas high speed burners under different conditions, the influence factors are probed such as the type of the gas source, the combustion air pressure, the gas pressure, the proportion of air and gas, gas flow and electrode to the ignition performance of natural gas high speed burner

    摘要在不同的條件下對天然氣高速燒嘴的點火性能進行了實驗研究，探討了氣源種類、助燃空氣壓力、燃氣壓力、空氣與燃氣的比例、氣體流量、點火電極等因素對天然氣高速燒嘴的點火性能的影響。
  9. Reciprocating internal combustion engines ; vocabulary of components and systems ; pressure charging and air exhaust gas ducting systems ; identical with iso 7967 - 4 : 1988

    往復式內燃機.零部件和系統的詞匯.增壓及進排氣管系
  10. Reciprocating internal combustion engines - terminology of components pressure - charging and air exhaust gas ducting systems

    往復式內燃機零部件術語增壓及進排氣管系統
  11. Under this background, we successfully developed an engine fuelled with coal - bed gas and ignited by spark plug. the measurements for the prototype engine were thoroughly made, including the cylinder pressure, the rate of heat release, combustion duration, ignition delays, spark ignition angle, and the fluctuation of the cylinder maximum pressure

    在此背景下，本文對經由s195柴油機改裝得到的燃用變組分煤層氣發動機進行了全面的測試和分析，包括缸內示功圖、燃燒放熱率、主燃期、點火提前角、火焰發展期以及最大壓力循環波動等。
  12. This article has a particular research on three kind of gas / liquid coaxial nozzles for their flow performance and atomization performance under cold - flow - simulated experiment with the supply of laser doppler technology, and the measurement of the drop parameter and combustion performance under normal pressure and burning condition

    本文應用激光多普勒技術對三種氣液同軸模型噴嘴的流量特性和霧化特性進行了冷流模擬實驗研究，並在常壓燃燒條件下對其噴霧流的液滴參數和燃燒性能進行了實驗測量。
  13. Constant pressure combustion gas turbine

    定壓燃燒式燃氣輪機
分享友人
分享到 Line

分享到臉書