compounding properties 中文意思是什麼

compounding properties 解釋
混煉工藝性能
  1. Owing to the abundant output and broad applications of poiyolefine, pls nanocomposites based on poiyolefine have become an enormous commercial allure. the studies on the melt compounding of polymer / compatibilizer - layered silicates system and their structure and properties were carried out

    提出聚合物粘土( pls )納米復合材料的阻隔幾何模型,推導出適合pls納米復合材料體系的相對透氣性公式,並探討影響透氣性的各種因素。
  2. Preparation, structure and properties of hdpe ~ g ~ aa / mmt nanocomposites melt grafting reaction of hdpe with aa was performed in thermohaake rheomix and hdpe - g - aa with high grafting degree and high grafting efficiency was prepared. the change of torque indicated that the graft copolymerization was existed during melt compounding. the extent of grafting was analyzed by ftir and element analysis

    在hdpe中只加過氧化二異丙苯( dcp )時,由於發生交聯反應而使平衡扭矩明顯增加,熔點和結晶度降低,加入aa后, aa與hdpe的接枝和hdpe自身的交聯並存,前者對後者有抑制作用,從而使扭矩下降,熔點和結晶度部分恢復。
  3. The effect of intensifier and other conditions on the mechanical properties of composite is studied for the sake of searching the optimal compounding and the optimal technological process. first, a series of composites are manufactured by means of different nonwoven fabric and different resin. the dissimilar methods are adopted including hand molding, vacuum - bag molding and vacuum assistant resin injection

    本文在研究非織造布增強樹脂基復合材料的復合工藝、力學性能和破壞機理中,在運用材料學、工藝學、力學和宏觀測試手段的同時,注重採用微觀測試方法,主要採用掃描電子顯微鏡進行測試,觀察了復合材料拉伸斷口的微觀形貌,研究了不同類型的非織造布增強體,不同樹脂和不同工藝條件對宏觀力學性能的影響,從而選擇最佳的增強體和基體的組成、復合條件和工藝,以製成性能最佳的新型材料。
  4. Rubber compounding ingredients : precipitated, hydrated silica - method for determination of physical properties in rubber including test recipe

    橡膠配合料.沉澱的含水二氧化硅.橡膠的物理性能的測定方法
  5. Study on compounding and properties of gypsum - based building putty

    石膏基建築膩子的配製與性能研究
  6. But with the rapid development of the materials science, the research on the properties of superfine powder will become the main task of the superfine powder technology in the future. the aim of the research on the superfine powder properties is to prepare new, functional properties and complex superfine powder, by designing or compounding modification on superfine particles

    而隨著材料科學迅猛發展的需要,超細粉體性能研究將是超細粉體技術學科今後的主要任務,目的在於通過粒子設計對粒子進行改性或復合處理,力求研究出新的高性能復合超細粉體,使其具有多功能性,以提高超細粉體的使用性能與價值。
  7. A solid - state shear compounding technology based on pan - milling ( s3c ) has established, by which the graphite with weakly combined structure are exfoliated and then compounded with pp at nanoscale. the obtained pp / graphite nanocomposites have greatly enhanced electrical and thermal conductivity. their structures and properties were characterized by analysis of particle size and distribution, sem, tem, xrd, the electrical conductivity, the thermal conductivity and heat - decomposition temperature etc. by taking advantages of the layered inorganic fillers with a weak interaction between layers ( e. g

    磨盤碾磨剪切力場使pp分子鏈斷裂,相對分子質量減小,石墨的導熱和潤滑性能抑制pp的降解和粉碎,使pp / yep250 (膨脹石墨250倍)復合粉磨盤碾磨固相剪切復合技術及導電導熱pp /石墨納米復合材料的制備與性能體中, pp分子運動活性提高,結晶能力增強,為pp在熔融加工中進一步向己剝離的石墨片層間擴散,形成納米復合結構創造了條件。
  8. Rubber compounding ingredients - silica, precipitated, hydrated test recipe and ingredients - determiantion of physical properties in rubber

    橡膠配合劑沉澱水合二氧化硅在橡膠中的試驗配合和物理性能測定
  9. By compounding caco3 with pp, the effect of caco3 content, diameter and shape on the crystallization, dispersion morphology and properties of pp / caco3 composites was investigated. the results showed that addition of caco3 into pp decreased the apparent crystal size in perpendicular direction to the ( 110 ), ( 040 ) and ( 130 ) crystallographic planes of ppa crystal, and with similar uniform dispersion of caco3, the dominant factor influencing toughness is the diameter of caco3 particles, but not the decrease of pp crystal size. the toughening effectiveness of nano caco3 is obviously better than that of micron caco3

    將caco _ 3與pp進行填充復合,研究了caco _ 3含量、粒徑及形狀對體系的結晶,分散形態及性能的影響,發現碳酸鈣的加入使聚丙烯晶型垂直於( 110 ) 、 ( 040 )和( 130 )晶面的表觀晶體尺寸減小,揭示了在分散均勻的情況下,影響材料韌性的主導因素不是晶粒尺寸的減小,而是碳酸鈣的粒徑,納米張玲:彈性體及無機剛性粒子增韌增強聚丙烯復合材料的研究碳酸鈣的增韌效果明顯優于微米碳酸鈣。
  10. The properties of intermetallics - ceramics composites are well superior to that of the inde - pendent material , and the composites show the remarkable superiorlty of compounding they can not on - ly be for civil use , but also they show the potential application in the fields of aerospace and military e - quipments

    金屬間化合物與陶瓷互為基體材料進行復合,可顯著提高各自的性能,顯示出很強的復合優勢,可用於機械等民用行業,在航天航空以及軍事裝備等領域中也有很好的應用潛力。
  11. In this article, based on introducing the concept of nanoplastic, it mainly expressed the intercalation compounding techniques and properties of some typical nanoplastics ( such as nylon 6 / clay nanocomposites, pet / clay nanocomposites, ultra high molecule weight polyethylene / clay nanocomposites )

    摘要本文在簡介納米塑料概念的基礎上,重點介紹了插層復合法制備納米塑料及典型納米塑料的性能。
  12. In this paper, we make use of hexadesyltrimethyl, an approximate ammonium compounding ( 15 - ch2 - number 17 ), ocatadecylaminechloried as cation exchange agents. the montorillonite is treated with these agents, which results in marked increase in their organophilic properties. the orgnic - montmorillonite has been identified by x - ray diffraction, different thermal analysis and infrared adsorption spectra

    在本文中,我們分別用十六烷基三甲基溴化銨、一種混銨鹽( 15主鏈- ch2 -數量17 )和十八烷基氯化銨作為陽離子交換劑,對蒙脫土進行了改性,使之由親水性變成親油性,繼而採用熔融插層方法制備了聚乙烯/蒙脫土復合材料。
分享友人