condensation temperature 中文意思是什麼

condensation temperature 解釋
冷凝溫度
  • condensation : n. 1. 濃縮；【物理學】冷凝（作用），凝聚（作用）；壓縮；縮合；凝塊。2. （著作等的）壓縮；壓縮后的形式，節本。
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. In the synthesizing process, the ph value in hydroxymethylated stage, the reaction time, temperature and the moore ratio of sodium bisulfate to melamine in the sulfonated stage, and die ph value in the condensation stage, are important factors influencing on the performance of jd

    在合成過程中，羥甲基化階段的ph值，磺化階段的ph值、時間、溫度和投料摩爾比，縮合階段的ph值等對減水劑性能影響顯著。
  2. Adiabatic condensation temperature

    絕熱冷凝溫度
  3. C. the condensation temperature has negligible effect on the mean heat transfer coefficient at a same oil concentration

    同一含油率下，冷凝溫度對平均換熱系數幾乎沒有影響。
  4. C ) the condensation temperature has negligible effect on the mean heat transfer coefficient at a same oil concentration

    C ）同一含油率下，冷凝溫度對平均換熱系數幾乎沒有影響。
  5. In the condition of same condensation temperature and evaporating temperature, the cop of the basic gax cycle is lower than that of the simplicity cascade cycle, but it is greatly better than the mid - pressure double - effect cascade cycle, on the other hand, the work condition is not as rigor as the simplicity cascade cycle, so the ratio of performance and cost is relatively high

    在相同的冷凝溫度和蒸發溫度下，基本gax循環的性能系數（ cop ）雖然比單純復疊循環的低，但要遠遠優于中壓雙效復疊循環，而且運行的條件不象單純復疊循環那樣苛刻，故基本gax循環的性價比較高。
  6. Eev should be selected for various refrigeration systems according to the thermal properties of refrigerants ; the discharge coefficient of eev is sensitive to the aperture and impulse quantity of eev ; when the eev structure is made, the discharge coefficient goes up with the lowering of evaporation temperature or goes down with the hoisting of the condensation temperature. it is le

    對于不同工質的冷藏集裝箱製冷系統，電子膨脹閥應該根據具體製冷劑的熱力性質選取；電子膨脹閥流量系數對孔徑和脈沖數比較敏感；在結構固定時，流量系數隨蒸發溫度的降低而升高，隨冷凝溫度的增加而增大，受過冷度變化的影響較小；電子膨脹閥的容量受孔徑影響最大。
  7. The analysis indicates that in the absorbing refrigeration cycle using tfe - tegdme working fluid under the same evaporating temperature and condensation temperature, the performance of the simplicity cascade cycle is the best while the heat burden of the generator is the maximum, the performance of the mid - pressure double - effect cascade cycle is the worst while the heat burden of the generator is higher than the basic gax cycle

    分析結果表明，採用以tfe - tegdme為工質吸收式製冷循環，在同樣的蒸發溫度和冷凝溫度下，單純復疊循環性能最為優越，但發生器的熱負荷也最大；中壓雙效循環性能最差，而且發生器的熱負荷要比基本gax循環大，運行的經濟性差。
  8. On the basis of that, this paper investigates the saturated temperature of hc600a - oil mixtures, condensation heat transfer and pressure drop characteristics in a horizontal micro - fin tube for it

    在此基礎上，對純天然工質異丁烷（ hc600a ）與潤滑油suniso3gs的混合物飽和溫度、水平微肋管內凝結過程的傳熱及流阻特性進行了實驗研究分析。
  9. On the basis of the investigation on the related literature of new refrigerant substitutes, the in - tube condensation of refrigerant and refrigerant - oil mixtures, this paper investigates the saturated temperature of hc290 - oil mixtures, condensation heat transfer and pressure drop characteristics in a horizontal micro - fin tube for it

    本文在分析研究國內外有關替代工質、製冷工質及其含油混合物管內凝結性能研究現狀的基礎上，對純天然工質丙烷（ hc290 ）與潤滑油suniso3gs的混合物飽和溫度、水平微肋管內凝結過程的傳熱及流阻特性進行了實驗研究分析。
  10. In the condition of high combustion temperature, coal minerals are first decomposed and gasified, and when plume is cooling, they can form lots of submicron particles though nucleation, condensation and agglomeration

    在燃燒的高溫條件下，煤中的礦物質首選經歷熱分解和氣化，當煙氣冷卻時，它們經過冷凝成核、凝結和團聚等作用，形成大量細粒子。
  11. The analytical results indicate that the temperature and the concentration of water vapor have been changed in the condition of condensation and also provide evidence of structural optimum of indirect evaporative cooler

    數值模擬以及熱力性能分析的結果表明，冷凝使得間接蒸發冷卻器內部的溫度場、水蒸汽濃度場等的分佈發生了變化，換熱效果以及有用能的利用狀況也發生了變化。
  12. Nh2so3h was used to efficiently perform one - pot, three - component, biginelli condensation reactions of aldehydes, - ketoesters and urea under solvent - free conditions at room temperature by grinding method

    摘要以nh2so3h為催化劑，室溫無溶劑條件下，研磨芳醛、 -酮酸酯和尿素合成了一系列1 ， 2 ， 3 ， 6 -四氫嘧啶2 -酮衍生物。
  13. Md has many advantages, such as simple equipments, maintenance free, running at low temperature, high condensation of remain, high performance in separating and by - product salts. all mentioned above can keep running costs of desalination low

    膜蒸餾法所用設備簡單，維護方便，除鹽率高，較低的溫度下即可進行，淡化后的濃縮水濃度高，作為副產品可用於鹽的生產，這些都有可能使得淡化水的成本降低。
  14. Hygrothermal performance of building components and building elements - internal surface temperature to avoid critical surface humidity and interstitial condensation - calculation methods

    建築物部件和結構件的濕溫性能.防止臨界表面潮濕和縫隙冷凝的內表面溫度.計算方法
  15. Fouriertransformation infro - red microspectroscopy micro - ftir technique was used to investigate the chemical compositions and structures of cutinite, vitrinite and fusinite from jurassic coals in tarim basin at different temperatures. the results show that the chemical structure of cutinite is mainly composed of long aliphatic - side chain with minor amounts of aromatic compounds. vitrinite is mostly composed of aromatic compounds, in addition to large amount of short aliphatic - side chain compounds. whereas fusinite are dominant by aromatic structure. the study indicates that cutinite is one of the best oil source - rocks, with the higher hydrocarbon - generation potential ; vitrinite is one of better gas source - rocks, and has medium hydrocarbon - generating potential ; fusinite has little hydrocarbon - generating potential. in addition, the components of aliphatic structures of cutinite, vitrinite and fusinite decrease, the aromatics are enriched and condensation of aromatic structure increases with increasing the temperature, and along with the rise of temperatures, the intensity of aliphatic structure and heteroatomic compounds decrease obviously, however the aromatic structure changes a little

    應用顯微紅外光譜技術，對塔里木盆地侏羅紀煤中有代表性的3種組分角質體鏡質體絲質體在不同熱模擬溫度下的結構組成變化特徵進行了研究，結果表明：角質體結構組成中含有較豐富的長鏈脂族結構，而芳香結構和含氧官能團的含量則相對較少與此相反，絲質體結構組成中芳香烴占絕對優勢，而脂族結構含量則很少鏡質體結構組成介於角質體和絲質體之間，含有較多的短鏈脂族結構和芳香結構。
  16. The evaporation section and the condensation section of the heat pipes can ben changed as the temperature of the outdoor air varies. so the heat pipe can be operated through the whole year. after analyzing the characteristics of energy recovery in air - conditioning system, associating heat feature of air - conditioning system with running environment

    分析了空調系統排風能量回收的特點后，作者結合空調系統運行環境，建立了該傳熱裝置的數學模型，結果表明:熱虹吸管的傾斜角、充液率、管長和迎面風速對熱虹吸管的傳熱都有重要影響。
  17. Results showed : ( 1 ) cbt cell death in low tempratures is accompanied by characteristic changes, such as, reduced cell size, distorted nucleus, chromatin condensation and margination and cell ( cytoplasmic ) vacuolization ; cell mortality and ca2 * concentration increase along with time passed in low temperature. mitochondrial membrane potential and 02 increased at first, and then decreased. activities of sod decreased at first, followed by significant increasing and finally depressed

    結果表明： （ 1 ） cbt在低溫協迫下，細胞圓縮，細胞核變形，染色質濃縮且邊位，細胞質空泡狀；細胞死亡率隨處理時間的增加而增加；細胞內鈣離子濃度隨處理時間延長而遞增；線粒體膜電位差在低溫處理早期急速上升，隨后一直下降；細胞內超氧陰離子（ o _ 2 ~ - ）在低溫處理前期出現高峰，接著呈下降趨勢；細胞內sod活性在低溫處理前期減弱，接著上升，然後持續下降。
  18. The project studied the direct contact condensation behavior of saturated steam on the subcooled liquid in passive gravity injection system. the experiment parameters were as follows : the initial pressure of prz ranged from 0. 2 0. 6mpa and the initial fluid temperature of core makeup tank ranged from 10 80. condensation phenomenon in cmt was observed

    本課題進行了非能動重力補水系統中飽和蒸汽在過冷液面上直接接觸冷凝的實驗研究，研究了在加裝遮流板時，系統壓力0 . 2 0 . 6mpa ， cmt初始溫度為10 80條件下壓力容器cmt中飽和蒸汽在過冷液面上冷凝的瞬態特性。
  19. The effects of the flow rate, the inlet temperature, the inlet concentration and the system pressure, the temperature of cooling wall and the radius on the features of condensation process with binary ( tfe / nmp ) vapor were gained

    同時，也得出了進口流量、進口溫度、進口濃度、體系壓力、冷卻壁溫和管徑等參數對垂直管內部分膜狀冷凝過程參數分佈的影響規律。
  20. At the beginning of this article, we give the analysis about the principle of external condensation. we find out that the most important factor in the condensation is the temperature of the air in the system. and we point out the factors which can make influence in the external condensation, such as the temperature and the humidity of the environment, the temperature and the pressure of the supplying air, the load of the system, the area of passage of speed control valve, and so on. next, we give the mathematics model of the pneumatic system using the knowledge of aerodynamics and heat transfer theory. and using the finite difference method and the numerical analysis we can get the solutions of the model. we use c program to simulate the model

    本文首先對氣動系統外部結露的原理進行了分析，指出了氣動系統內部氣體溫度下降是氣動系統外部結露根本原因，提出了影響氣動外部結露的主要因素，包括環境溫度、環境濕度、供氣壓力、供氣溫度、氣缸負載和調速閥開度等。然後應用氣體動力學、氣體熱力學和傳熱學對氣動系統建立數學模型，用逆步進有限差分法和數值分析演算法對所建模型進行求解，利用c語言編製程序對氣動系統模型進行模擬，給出了氣管及氣缸內氣體的各個時刻的狀態參數。
分享友人
分享到 Line

分享到臉書