condenser temperature 中文意思是什麼

condenser temperature 解釋
冷凝器溫度
  • condenser : n. 冷凝器；凝汽器；電容器；聚光器；【紡織；印染】集棉器；搓條機。
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. Heat installation continues rising, condenser water drops to the temperature of drainage, temperature - sensing component in top material will minify with cold, leave port a, drawoff the condense water quickly

    溫度繼續升高，閥內溫度超過該閥感溫元件所排水溫度時，頂桿的位移使a口關閉。
  2. By using a same boundary dimensions high efficient and new type copper exchanger substituted carbon steel oil condenser, and increasing flow rate of circulation water to reduce the temperature of freezing oil which feeds into compressor stage, to eliminate the malfunction during compressor operation, and improve running efficiency of the machine

    採取將碳鋼材質的油冷卻器更換成等外形尺寸的高效新型銅管換熱器、增加循環水流量的方法，降低了進入二段壓縮機冷凍油溫度，排除了壓縮機運行中的故障，改善了機組的運行效率。
  3. Automotive air conditioner accessories : automotive air conditioner cooler, evaporator, heat sink, air conditioner, temperature adjuster, heater, central cooler, air desiccators, cooling fan controller, internal heat exchanger, compressor, motor, air warmer, warm air device, electronic fan for cooling condenser, liquid can, thermal expansion valve, air condition pipeline, switch, clutch, connector, height valve, shunt valve and all kinds of automotive air conditioner production materials ( body aluminum, copper materials, etc ), production equipment, measurement equipment, etc

    車用空調配件：各種車用空調冷凝器、蒸發器、散熱器、空調器、調溫器、加熱器、中冷器、空氣乾燥器、冷卻風扇控制器、內部熱交換器、壓縮機、電動機、暖風機、暖風裝置、各種冷凝器電子扇、貯液灌、熱力膨脹閥；各種車用空調管路、開關、離合器、接頭、高低閥、換向閥及各種車用空調生產材料（車用鋁材、銅材等） 、生產設備、檢測設備等。
  4. It is concluded that it may be disadvantageous to capacity modulation at low temperature environment if the condenser area is smaller and throttle set is capillary. 3

    結果表明：系統在冷凝器面積偏小和採用毛細管作節流裝置的前提下，不利於低溫環境下的容量調節。
  5. Experimental investigation and numerical simulation on air temperature distribution around wire - and - tube condenser

    絲管式冷凝器周圍空氣溫度分佈的實驗研究及模擬
  6. Concentric jacket pipe surrounded the test condenser. steam was generated in the boiler, flowed upward to the inlet of connection pipes, then flowed downward into the condenser tube, the cooling water flowed countercurrently through the annulus. the experiment covered the range of the pressure 1. 0 ~ 3. 0bar, heating power 2. 0 ~ 15. 0kw, steam mass flow rate 0. 001 ~ 0. 004kg / s, air mass flow rate 0. 0 ~ 0. 00163kg / s, and cooling water temperature 20 - 60 ?

    在系統壓力為0 . 1 0 . 3mpa ，加熱功率為2 15kw ，蒸汽質量流量為0 . 001 0 . 004kg s ，空氣質量流量為0 . 0 0 . 00163kg s ，二次側冷卻水溫度20 60的范圍內，系統研究了豎直下降管內含有空氣的蒸汽冷凝特性，獲得了不同壓力、不同空氣含量和不同加熱功率下，冷凝段的溫度分佈和局部熱流密度的數據。
  7. The bigger no. 5 6 high pressure heater ' s difference temperature is another factor. the paper detaily analysed the reasons that turbine ' s relative intra - efficiency and condenser ' s vacuum lowering and no. 5, 6 high pressure heater ' s difference temperature rising. it using the thermal system equal quantity analysis method, calculated the value that turbine unit thermal efficiency had been lowered

    論文中對汽輪機相對內效率低、凝汽器真空低於設計值以及# 5 、 6高壓加熱器上、下端差大於設計值的原因進行了詳細的分析，並將各因素對整個熱力系統效率降低的影響程度進行了定量的分析和計算。
  8. Based on sufficient investigation of relative field at home and abroad, combined with actual state of engineering, aimed at the characteristics of low temperature waste heat power generation, under adequate consideration of economical efficiency, the thermodynamic system models on the base of rankine - cycle, which mainly consisted of evaporator, ehd condenser and steam turbine - generator group with r11 as working fluid, were constructed after comparing the current low temperature waste heat power generation systems

    文中在對國內外相關領域進行了充分調研的基礎上，結合工程實際狀況，針對低溫余熱發電特點，充分考慮經濟性的前提下，對現行的低溫余熱發電系統進行比較，選擇了以具有低沸點的r11為工質，由蒸發器、 ehd冷凝器、汽輪機-發電機組等主要部件組成的有機朗肯循環熱力系統模型。
  9. With the operation conditions, the adsorber, the evaporator, the condenser, the receiver and the throttle are disigned. the adsorber is of the most importance in the adsorption system, so we provide the non - dynamic equilibrium model of active carbon fibre ( acf ) - methanol adsorption refrigeration pair. the numerical simulation is carried out based on the recorded solar radiation data measured in nanjing and daily ambient temperature for the typical clear days. the temperature field, the pressure field, the methanol concentration and the temperature of evacuted tube, and water tube are caculated

    吸附床是吸附製冷系統的核心，本文以活性炭纖維?甲醇為工質對，建立了吸附床非動態平衡吸附傳熱傳質數學模型，以南京夏季典型一天中的輻射強度和環境溫度為條件，模擬計算了吸附床在通水冷卻和自然冷卻兩種狀態下，吸附床內各點壓力、溫度、吸附率、吸附總量及真空管和冷卻水管壁溫隨時間變化關系。
  10. Sea water thermal survey plan and measurement of the water temperature rise due to condenser cooling water discharge

    冷凝器流水升溫量度及熱排放的海水監測
分享友人
分享到 Line

分享到臉書