conditions of furnace 中文意思是什麼

conditions of furnace 解釋
爐況
  • conditions : （旅遊合同中）條件或服務項目
  • of : OF ＝Old French 古法語。
  • furnace : n. 1. 爐子；熔爐；高爐。2. 極熱的地方。3. 磨煉；艱難。vt. 在爐中燒熱（金屬）。
  1. The hydrodynamic experiments with countercurrent flow of gas and liquid simulating the flow conditions in the lower zone of the blast furnace were carried out in a packed bed to clarify the gas pressure drop characteristics in that zone

    摘要為了闡明高爐下部氣相壓降的特性，在填料床內模擬高爐下部流動條件進行了氣液兩相逆流的流體力學實驗。
  2. A differential fixed - bed reactor was employed to study the reaction between iron blast furnace slag ( bfs ) / hydrated lime ( hl ) sorbent and so2 under conditions similar to those in the bag filters of a spray - drying flue gas desulfurization system

    摘要本研究以微分固定床反應器，在模擬噴霧乾燥除硫系統中的袋式過濾器的條件下，探討爐石/氫氧化鈣吸收劑與二氧化硫于低溫下之反應動力學模式。
  3. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  4. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  5. Steel rolling heating furnace conditions are realized by means of heat balance testing of the furnaces

    摘要通過對湘鋼軋鋼加熱爐的熱平衡測試，了解爐子的熱工作狀況。
  6. Abstract : it analyses reduction machanism of silicon in femn blast furnace ， basic conditions, ways and technological measures to smelt low silicon blast furnace femn, points out the technical and economical advantages of smelting low silicon femn in blast furnace

    文摘:分析了錳鐵高爐內硅還原機理、冶煉低硅高爐錳鐵的基本條件、途徑和工藝措施，指出了高爐冶煉低硅錳鐵的技術經濟優勢。
  7. Abstract : the present paper elaborates the role of the ironmaking area and the general situation of process flow and task of the ironmaking area at wisco in the coming century, correctly analyzes the current conditions and advantages of the ironmaking facilities, and affirms that the blast furnace ironmaking is still the main stream in the 21st century and the ironmaking area will remain the bottle neck in the whole process flow in wisco

    文摘:闡述了進入新世紀武鋼煉鐵系統的作用、武鋼工藝流程的總形勢及武鋼煉鐵系統的任務;正確地分析了武鋼煉鐵系統的現狀及其優勢，提出了高爐煉鐵仍是21世紀煉鐵系統的主流，而煉鐵系統又是武鋼整個流程中的關鍵性環節。
  8. Huayao has researched and developed several advanced kiln & furnace series and supported products that are suitable for china national conditions, of which the open - flame roller kiln for daily - use ceramics production was recognized as national torch project, and six products were praised with china national science and technology award

    自行研製開發出符合我國國情的多個先進窯爐系列及配套產品，其中應用於日用瓷生產的明焰燒成裝配式輥道窯項目被定為國家火炬計劃項目， 6項產品獲得國家科研技術獎勵。
  9. In this paper, the necessary and sufficient conditions such as the diameter and some physical properties of the baked electrodes in the lengthwise graphitization furnace are highlighted and discussed in terms of single series or in multi - series packing types of the electrodes in the furnace

    摘要討論了串接石墨化爐內焙燒坯料單串裝爐和多串並聯裝爐時，坯料的直徑和一些物理性質必須滿足的充要條件。
  10. Abstract : analysis is made on types and performances of protective atmospheres of the steel tube heat treatment furnace with protective atmosphere, and also dynamic analysis on the non - oxidation equilibrium conditions of the chemical process of atmosphere of the said furnace is made

    文摘:分析了鋼管保護氣氛熱處理爐的保護氣氛類型及性能，對鋼管保護氣氛熱處理爐內氣氛的化學過程動態分析了無氧化的平衡條件。
  11. The improvement technique of the single - slag manner smelting steel of arc furnace has been put forward, with details of discussion about suitable conditions and range of such technique and analysis of process characteristics and effect mechanism

    摘要提出了電弧爐單渣法煉鋼的改進工藝，針對單渣法熔煉的工藝內容，較為詳細地討論了其工藝適應條件和范圍；分析了藝流程特性和工藝行為的作用機理。
  12. Abstract : in experimental conditions, simulating reducing atmosphere in blast furnace, the samples of al2o3 - c brick is heated at high temperature. the microscopic structure of al2o3 - c brick is observed by scanning electric telescope before and after heating and compressive strength and rupture strength are measured. on the base of them, the reason resulting in the changes is analyzed

    文摘:在實驗室條件下模擬高爐還原氣氛高溫處理鋁碳磚試樣，觀察處理前、后鋁碳磚的顯微組織形貌的變化，並測定其抗壓、抗折強度，分析引起這種組織變化的原因
  13. Corundum mullite product adoprs electrocast refractories. through high pressure formation and high temperature burning, this product has comparatively high refractoriness, mechanical strength and slftening temperature under load. it can be widely used as inner lining. of various industrial furnace under such hard working conditions as high temperature, flushing and erosion

    剛玉莫來石製品是採用電熔合成原料，高壓成型，高溫燒成的具有較高耐火度及機械強度，較高荷重軟化濁的可廣泛應用於各類工業爐高溫、沖刷、侵蝕條件較苛刻的窯爐內襯的耐火製品。
  14. But the paper set out form the lab, the conditions of the temperature of the water wall tubes and the ambience of the furnace is imitated in lab, the material of sample is adopted by the steel of the water wall tubes of the boiler, which made the test conditions approach to the fact work conditions of the water wall tubes of the boiler and made the imitation accurate

    本文則從實驗室出發，在實驗室模仿鍋爐水冷壁的溫度條件和爐膛氣氛條件，採用鍋爐水冷壁用鋼（ 20g ）作為試樣材質，盡可能接近鍋爐水冷壁的實際工作條件以達到模仿的效果。
  15. Based on the actual application experience from more than twenty years in wisco, the favorable effects of saving energy, increasing production and prolonging furnace life - span were gained through reasonably selecting infrared radiant coating with excellent properties for the particular producing conditions of different industrial furnaces

    根據武鋼20多年的實際應用經驗，針對不同工業爐具體的工況條件，合理選擇性能優良的紅外輻射塗料，能夠取得良好的節能、增產和延長爐子使用壽命的效果。
  16. Abstract : the furnace body erosion of 2 blast furnace of pzh steel at the end of second compaign wassystematically investigated. the causes for furnace body erosion were analyzed. the features of furnace body erosion were clarified under conditions of intensification of smelting process. the mechanism of lining protection was further revealed with tio2 bearing burden, the technical measures which make the blast furnace high efficiency and long compaign were put forward

    文摘:對攀鋼2高爐第二代爐役爐體侵蝕作了系統地研究，分析了爐體侵蝕的原因，弄清了強化冶煉條件下攀鋼高爐侵蝕的特點，進一步揭示了含鈦物料的護爐機理，提出了實現攀鋼高爐高效長壽的技術措施。
分享友人
分享到 Line

分享到臉書