conductive method 中文意思是什麼

conductive method 解釋
導電法
  • conductive : adj. 傳導（性）的，有傳導力的。
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Thus, in general, the conductive paint spray method and the electroless plating method have been currently used

    這樣，目前普遍使用的是導電塗料噴霧法。
  2. It detailed analyzes the characteristics of symmetric semi - space, layered telluric medium of transient electromagnetic methods, deduces apparent resistivity ( ps ) formulae of earlier, later and whole stage channels, it also analyzes and deduces the tem response effect of local conductive body in high resistance medium and its apparent resistivity formula, inquires into the causing reason, distinguishing method and the way of eliminating or reducing its effect of tem additional effects

    第二章瞬變電磁法的理論基礎，較詳細地分析了均勻半空間、層狀大地瞬變電磁場的特徵，推導了早期、晚期及全期道視電阻率s公式；以及高阻圍巖中局部導電體的瞬變電磁響應和相應的s公式推導。
  3. In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %

    本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。
  4. Oxygen environmental scanning electron microscopy is a new and practical method for directly observing and analyzing non - conductive oxide materials

    氧環境掃描電子顯微分析是針對氧化物類非導電材料直接成像和分析的一種新穎而實用的方法。
  5. Sol - gel method was used for preparing the nano - tio2 photocatalytic film on general glas slid and ito conductive glass. the spectrum property, surface image, crystlal type, particle size, thickness and other properties of this film were measured by uv - vis, afm, xrd and other apparatus

    採用溶膠-凝膠法在普通玻璃載波片和ito導電玻璃上制備出負載型納米tio _ 2薄膜，並用uv - vis ， afm ， xrd等對納米tio _ 2薄膜的光譜特性、表面形貌、晶型及粒子大小、薄膜厚度等進行了表徵。
  6. The surface resistance and electromagnetic interference ( emi ) shielding effectiveness of the conductive fabrics were measured by four point probe method ( astmf 390 ) and the coaxial transmission line method ( astm d4935 - 99 ), respectively

    分別用四探針法和雙軸傳輸線法測量了導電滌綸織物的表面電阻和電磁屏蔽效能。
  7. Non - conductive coatings on non - magnetic electrically conductive basis materials - measurement of coating thickness - amplitude - sensitive eddy current method

    非磁性電導基體金屬上的非導體鍍層.鍍層厚度的測量.波幅靈敏渦流法
  8. Non - conductive coatings on non - magnetic electrically conductive basis materials - measurement of coating thickness - amplitude - sensitive eddy current method iso 2360 : 2003 ; german version en iso 2360 : 2003

    非磁性導電基體上非導體覆蓋層.鍍層厚度的測量.振幅
  9. Testing method for resistivity of conductive plastics with a four - point probe array

    用四點探針排列法測定傳導塑料電阻率的測試方法
  10. Test method for resistivity of conductive fine ceramic thin films with a four - point probe array

    用四點探針排列法測定傳導精細陶瓷薄膜電阻率的試驗方法
  11. To verify analytical solutions, the numerical solution is computed for the problem that an arbitrary time - harmonic current dipole is in a conductive sphere utilizing finite element method and the analytical solution is compared with the numerical solution

    為驗證所求電磁場解析解的正確性，利用通用有限元分析軟體對導體球中時諧電流元的電磁場解析解作了數值驗證。
  12. It is held that the contact polarization curve method, being an exploration technique characterized jointly by immediacy, long distance and totality, is especially suitable for conductive sulfide ore deposits

    認為接觸極化曲線法特別適合導電性硫化礦床，是同時兼具直接性、遠程性和總體性三者的勘查技術。
  13. Abstract : this paper briefly introduces the method of testing the real sensitivity for eed and gives the data processing method in terms of the electrostatic critical ignition energy of conductive - powder eed conforming to logarithmic normal distribution

    文摘:簡要介紹了電火工品真實靜電感度的測試方法，以導電藥式電火工品靜電臨界點火能量服從對數正態分佈為基礎，給出了對應的數據處理方法。
  14. Testing of semi - conductive inorganic materials ; measuring the thickness of silicon epitaxial layer thickness by infrared interference method

    半導體無機材料的試驗.用紅外線干涉法測量硅外延生長
  15. Method for conductivity measurement of ion - conductive fine ceramics

    離子導電精細陶瓷的導電性測量方法
  16. Based on the previous explanation, we could understand why a metallic door handle is usually not considered as an extraneous conductive part. if a proper installation method is used, the metallic accessories in bathroom could become non - extraneous conductive parts

    至於浴室內的金屬掛架，若安裝方法得宜（譬如裝有絕緣墊） ，便有足夠的對地抗阻，變成不是非電氣裝置金屬部分。
  17. A measurement method of microwave surface resistance of large area high tc super - conductive thin films

    高溫超導薄膜微波表面電阻測試方法
  18. Regarding the metallic windows, due to their exposure to external environment where rain and high humid conditions are prevalent, they are usually considered as extraneous conductive parts. the bonding connection method for extraneous conductive parts is specified in code 11 of the cop

    至於一般的金屬窗框，因受安裝方法及外界環境等不明朗因素（如雨水及潮濕）所影響，一般都會被視為非電氣裝置金屬部分。
  19. The paper presents a solution method for the transient temperature field, in which the finite element method or the finite difference method is used to get discrete structure, and the finite difference method is used to get discrete time in order to simplify the transient thermal conductive equations as a set of linear equations as a set of linear equations at different moment

    本文提出對空間採用有限元法或有限差分法，而對時間採用有限差分法將瞬態熱傳導方程簡化為不同時刻的線性方程組以求解瞬態溫度場，用以求解大體積混凝土在固化過程中不同時刻的溫度分佈。
  20. Electroplating on magnesium alloy can get a quite bright alloy - layer which has better antiseptic ability and conductive performance, the alloy - layer raises hardness, anti - corrosion and wearability of the surface of the magnesium alloy. the electroplating coating as the preconditioning can carry on regular shelter and decorating, so electroplating is a good method to obtain highly anti - corrosion metallic coating

    鎂合金表面電鍍是在液相中沉積出具有相當防腐能力和導電性能的光亮鍍層，這層均勻的鍍層提高了鎂合金表面的硬度、耐蝕和耐磨性，作為鎂合金件的預處理防護層，就可以進行常規的防護和裝飾，因此，電鍍是獲得耐蝕金屬塗層的好方法。
分享友人
分享到 Line

分享到臉書